Electronic Components & Devices

Pulsed Diode Laser Driver suits man-portable applications.

Pulsed Diode Laser Driver suits man-portable applications.

Designed to operate from single DL123 battery or equivalent, PLDD-120 delivers 120 A of peak current for 300 -µs to laser diode bar at 1 Hz repetition rate. Measuring 2.1 x 0.75 x 0.78 in. size and weighing 15.2 g, unit is suited for man-portable target designation, rangefinding, illumination, and remote sensing applications.

Read More »
Four-Channel, 12-Bit DAC incorporates non-volatile EEPROM.

Four-Channel, 12-Bit DAC incorporates non-volatile EEPROM.

Supplied in 10-pin MSOP, MCP4728 lets designers program input codes, configuration bits, and I-²C(TM) address bits to integral EEPROM so that data is held during power-off time. This makes configuration and outputs available immediately after power-up. Also, each channel can be individually shut down, reducing power consumption to as low as 0.04 -µA, to extend battery life. On-chip precision...

Read More »
Variable Gain Amplifier features 31 dB analog control range.

Variable Gain Amplifier features 31 dB analog control range.

Optimized for 1-500 MHz operation, Model LTC6412 provides continuous gain adjustment from -14 to 17 dB. Third-order output intercept point is 35 dBm at 240 MHz across all gain settings. Device also achieves constant output noise level over entire gain range, with noise figure of 10 dB at max gain setting. Using negative gain slope mode, gain control slope is -32 dB/V at 140 MHz, with control...

Read More »
DPD µModule® Receiver simplifies basestation design.

DPD µModule® Receiver simplifies basestation design.

Supplied in 11.25 x 15 mm LGA package, LTM9003 wideband RF-to-digital receiver subsystem includes 12-bit, 250 Msps ADC, bandpass filter, IF amp, and RF downconverting mixer. IC reduces board space and development time for wireless basestations implementing PA linearization with digital predistortion (DPD). Included 125 MHz bandpass filter exhibits less than 0.5 dB passband ripple, and noise floor...

Read More »
Suppression Devices protect high-speed data ports.

Suppression Devices protect high-speed data ports.

Designed for compliance with IEC61000-4-2, ESD/ESDU Series is comprised of transient suppression chips with 8 KV protection level for direct contact and 15 KV for air. Chip array versions of above devices, ESA/ESAU Series, come in 0603 x 4 chip array size, while ESD/ESDU Series is available in 0402 and 0603 chip sizes. All circuit protection devices employ air gap technology that achieves...

Read More »
GPIB-USB Interface Controller is IEEE 488.2 compatible.

GPIB-USB Interface Controller is IEEE 488.2 compatible.

Supporting transfer rate of greater than 1.2 MB/sec, IEEE-488.1 and 488.2 compatible USB-3488A enables direct connection of GPIB instruments to laptop computer. It is fully compatible with NI-488.2 software and supports VISA I/O libraries software so that existing GPIB applications can be used without modification. Compact and portable controller measures 3.2 x 2.4 x 1.1 in. and weighs only 180...

Read More »
TCXO offers stability of ±0.28 ppm over -40 to +85°C.

TCXO offers stability of ±0.28 ppm over -40 to +85°C.

Measuring only 5 x 3.2 x 2 mm, T53 Series provides up to 50,000 g acceleration and g-sensitivity as low as 7 x 10-10, and offers Clipped Sinewave or CMOS outputs. It is designed as reference oscillator for critical timing applications that demand small footprint. Applications include smart munitions, GPS, mobile radio, SONET, WiMAX, WLAN, Stratum 3, and Femtocell markets.

Read More »
Vertical Socket Connector has 0.1 mm lead coplanarity.

Vertical Socket Connector has 0.1 mm lead coplanarity.

RoHS-compliant, vertical surface-mount DDR2 DIMM socket connector, FCN-078J series uses precision stamping and molding technology to achieve 0.1 mm coplanarity before and after reflow. Available with footprint of 22.7 x 140 mm, 240-position unit has operating temperature range between -55 to +85°C, voltage rating of AC 25 V and maximum current rating of 0.5 A/contact. Suitable applications...

Read More »

SiC JBS Power Diodes offer multiple rating/package options.

Z-Rec(TM) 600 V Silicon Carbide (SiC) Junction Barrier Schottky (JBS) diodes promote device power efficiency and surge current capability, allowing system power conversion applications from 250-1,500 W. Primarily used for boost diode applications in PFC circuits, diodes help reduce ac-dc power supply losses. Zero reverse-recovery current enables switch-mode power supplies to reach and exceed...

Read More »
Module/Carrier Board supports industrial temperature range.

Module/Carrier Board supports industrial temperature range.

Measuring 2.75 x 2.75 in., Models PQ7-M102XL and PQ7-C100XL module boards operate in temperatures from -40 to +85-ºC. PQ7-M102XL supports Intel Atom(TM) processors Z510PT or Z520PT and Intel System Controller Hub US15WPT as well as features 512 Mb system memory, LVDS/SDVO for dual independent display, and various I/O. PQ7-C100XL, with 3.5 in. ESB form factor, serves as development kit carrier...

Read More »
Precision Machining Solutions with Over 25 Years of Experience
Sponsored

Precision Machining Solutions with Over 25 Years of Experience

Quality, customer service, and unbeatable value are the hallmarks of Hogge Precision. Since 1989 we have built a reputation as the go-to precision machining source, servicing many demanding industries. For CNC machining and screw machining, there are few manufacturers that can match our capabilities and expertise. See our video to learn more.

Read More »

All Topics