Electronic Amplifiers

Zero-Drift Op-Amps are optimized for low input voltage noise.
Electronic Amplifiers

Zero-Drift Op-Amps are optimized for low input voltage noise.

Featuring input voltage noise of 11 nV/sqrt Hz at gain of 1,000 V/V, LMP2021 single and LMP2022 dual op amps suit sensor interface applications operating at low frequencies and low supply voltage. Noise-shaping technology employs continuous-correction circuitry to auto-zero input offset error voltage, enabling uninterrupted accuracy over time and temperature with respective CMMR and PSRR...

Read More »
Electronic Amplifiers

Signal Path Solution suits DAQ systems, STBs, and radar.

At 248 MHz, ADC10D1000 provides spurious-free dynamic range(SFDR) performance of 66 dBc and 9.1 effective number of bits. This 2 GSPS single/1 GSPS dual ADC runs off single supply voltage and consumes 2.8 W. At 2.5 GHz, LMH6554 wideband fully differential amplifier drives 10-bit ADC10D1000 and provides 0.1 dB gain flatness up to 800 MHz, SFDR of 72 dBc at 250 MHz, and input voltage noise...

Read More »
Audio Power Amp Reference Design offers scalable output.
Electronic Amplifiers

Audio Power Amp Reference Design offers scalable output.

With power range from 25-500 W, IRAUDAMP7 reference design offers scalability on single-layer PCB for Class D audio amplifiers above 25 W per channel. Two-channel, 120 W, half-bridge design of IRAUDAMP7S provides 91% efficiency at 120 W in Class D stage, 8 ohms, and THD+N of 0.005% at 1 kHz, 60 W, 8 ohms. While IRAUDAMP7D features IRS2092 protected digital audio driver IC in DIP16 package...

Read More »
Electronic Amplifiers

Power Amplifiers are engineered for 3G/4G femtocell markets.

Designed for OFDMA waveforms such as 802.16 WiMAX, AWB7220 comes in self-contained 7 x 7 x 1 mm SMT package that incorporates matching networks optimized for output power, efficiency, and linearity in 50 ohm system. Isolated, fully matched, multi-chip module, rated 4.5 V, operates from 2.5-2.7 GHz and offers extended capability between 2.3 and 2.5 GHz. Manufactured using InGaP-Plus(TM)...

Read More »
CMAA Crane Buyer's Guide
Sponsored

CMAA Crane Buyer's Guide

CMAA has organized this Buyer's Guide to promote standardization and to assist prospective buyer's of electric overhead traveling cranes in selection of equipment most suitable for their applications.

Read More »
Wideband Amplifier has programmable output limiting clamp.
Electronic Amplifiers

Wideband Amplifier has programmable output limiting clamp.

Suited for automotive safety applications, model LMH6553 fully differential amplifier protects ADC and other downstream circuitry from over-voltage events. It features 900 MHz unity-gain bandwidth, operates on 29 mA supply current, and offers power-to-performance ratio of 32 Â-µA/MHz. Operating over -40 to 125°C temperature range, unit features 600 picosec clamp overdrive recovery time...

Read More »
Electronic Amplifiers

Audio Power Amplifier integrates fault detection.

Supplied in 14-pin TSSOP and AEC-Q100 Grade 2-qualified for operation from -40 and +105°C, LM48100Q Boomer® amplifies warning tones in automobile driver warning systems. Mono 1.3 W amplifier integrates output short circuit and thermal overload protection as well as open drain FAULT output that indicates when fault has occurred. Dual audio inputs can be mixed and multiplexed to device...

Read More »
Electronic Amplifiers

Car Audio Amplifier features digital input.

Supplying direct connection to digital audio player, TDA7801 eliminates need for signal conversion and subsequently promotes sound quality and noise immunity as well as system reliability. It offers SNR from 90-105 dB and delivers intrinsically pop-free operation without clicks or noises during car battery transitions. In addition to incorporating embedded diagnostics, design reduces number of...

Read More »
Electronic Amplifiers

TMD Highlights TWT Amplifiers at EMCUK Exhibition

TMD Technologies will be highlighting its range of TWT amplifiers for EMC applications at the EMCUK exhibition and conference in October this year. The compact, lightweight, broadband products benefit from TMD's leading expertise in high power military radar amplifiers. The company's standard amplifier range covers 1-40 GHz at up to 500 W continuous wave and 40 kW pulsed. With a worldwide...

Read More »
Amplifier Module measures compact 250 x 180 x 53 mm.
Electronic Amplifiers

Amplifier Module measures compact 250 x 180 x 53 mm.

Designed for FM and HDFM radio broadcast applications, FM1K-108 provides 1 kW linear CW output power from 87.5-108 MHz and features 74% collector efficiency and -55 dBc harmonic suppression. Protection circuitry offers security against overdriving, SWR over-voltage, and thermal runaway, while 22 dB gain allows system designer to use input power of 7 W. Class B amplifier features 4 LDMOS...

Read More »
High-Voltage Amplifiers are optimized for bias applications.
Electronic Amplifiers

High-Voltage Amplifiers are optimized for bias applications.

Capable of operating in DC, reversible, and amplifier modes, HVA Series provides programmable high-voltage DC to greater than 1 kHz output. It exhibits 10 ppm temperature coefficients on +10 Vdc reference and 25 ppm coefficients on output voltage monitor and high voltage output. Able to source and sink current, series provides ppm-level line and load regulation. Respective output voltage ranges...

Read More »

All Topics

COVID-19 Response Suppliers COVID-19 Response:
Can Your Company Help Provide Critical Supplies?

We are using the power of our platform to aid in the mass shortage of critical supplies. If your company can help provide supplies, capabilities, or materials for products such as N-95 Masks and Tyvek SuitsPlease let us know.

COVID-19 Response Suppliers