Electronic Amplifiers

Isolation Amplifiers protect against overload conditions.
Electronic Amplifiers

Isolation Amplifiers protect against overload conditions.

Based on optical insulation technology and sigma-delta modulation for signal processing, ACPL-785J Series allows direct measurement of motor phase currents in power inverters. Units feature minimum bandwidth of 20 kHz and integrated over-current and overload detection. Housed in SO-16 package with 10.3 x 10.2 x 3.5 mm footprint, amplifiers are suited for inverter current sensing, motor phase and...

Read More »
Power Amplifiers reliably deliver consistent power.
Electronic Amplifiers

Power Amplifiers reliably deliver consistent power.

Offering power levels from 30-450 W, broadband power amplifiers are optimized for demanding EMC testing environments with non-ideal load conditions due to antenna mismatch caused by equipment under test (EUT) in antenna's path. Three Class A models are based on GaAs IC technology, which provides low-distortion linear performance across 0.8-3.1 GHz operating range. Two additional models, based on...

Read More »
Ultra-Broadband Power Amp has extended frequency range.
Electronic Amplifiers

Ultra-Broadband Power Amp has extended frequency range.

With no warm-up or turn-on delay, CHPA0618-1-G45 provides 40 W typ saturated power across 5.85-18.4 GHz bandwidth. Ability to achieve solid-state power levels across frequency range is enabled by Spatium(TM) broadband spatial combining technology. This multiple-element architecture provides protection from single-point failures and facilitates even, dispersive, 3D heat dissipation. Other features...

Read More »
Solid State High Power Compact Amplifiers
Electronic Amplifiers

Solid State High Power Compact Amplifiers

Instruments for Industry has over 50 years of experience in the RF/IF microwave power industry. Instruments for Industry is a.k.a. IFI - the Power of Choice". TWT High Power Amplifiers have been our primary focus for every EMC and EMI testing application with power amplifiers ranging from DC to 40GHz, 1 watt to 50 kilowatts. IFI has added an additional line of lightweight miniature RF power...

Read More »
Electronic Amplifiers

Digital Audio IC combines processing and amplification.

Sound Terminal(TM) model STA339BWS utilizes techniques such as Full Flexible Amplification (FFX) to enable fully digital stream from sound source to loudspeaker, promoting audio performance and reducing size for home-audio equipment using small speakers, such as flat-panel TVs and docking stations. Solution combines IP from audio processing and class-D power amp ICs into one chip and includes...

Read More »
Electronic Amplifiers

Noise-Free Audio Amp suits portable/wireless applications.

Able to deliver 1.35 W of output power to 8 ohm speaker or 1.1 W to 4 ohm speaker, NCP2991 Class AB audio amp has THD of 0.015% and features -103 dB power supply rejection ratio that eliminates any noise generated by fluctuation of battery supply voltage. It is also resistive to TDMA noise that occurs during GSM transmission and exhibits zero pop-and-click noise at start-up and shut-down....

Read More »
Electronic Amplifiers

IF Amplifier is digitally programmable.

Featuring 48 dBm OIP3 (output 3rd order intercept) at 200 MHz, LT5554 enables high dynamic range performance in ADC systems. It settles in less than 5 ns from gain change, while gain is digitally controlled from 2-18 dB by 7-bit parallel word, producing 0.125 dB steps gain control granularity. Powered from single 5 V supply, unit draws nominal supply current of 200 mA, has gain accuracy of...

Read More »
Electronic Amplifiers

Filters/ADC Drivers suit I/Q demodulator channel filtering.

Broadband active filters/ADC driver amplifiers include LTC6603, LTC6601-1, LTC6605-7, LTC6605-10, and LTC6605-14. Model LTC6603 features dual matched programmable ninth-order switched capacitor linear-phase filter and ADC driver, where as LTC6601-1, is low noise 0.5% tolerance lowpass active filter and ADC driver with configurable bandwidth from 5-28 MHz. LTC6605-7/-10/-14, are second-order...

Read More »
Electronic Amplifiers

National Semiconductor Delivers Industry's Best Linearity Performance with New High-Speed, 16-Bit ADC and DVGA

PowerWise Signal Path Products Deliver Unparalleled 90.6 dBFS SFDR for Multi-Carrier GSM Base Stations November 11, 2008 - Two new high-speed signal path products, a 16-bit, 130 mega-samples per second (MSPS) analog-to-digital converter (ADC) and a digital-controlled variable gain amplifier (DVGA), were announced today by National Semiconductor Corp. They deliver the industry's best linearity...

Read More »
Electronic Amplifiers

L-com Announces Addition of HyperLink Wireless Line to Portfolio of Products

December 2, 2008 Combination creates availability of wired and wireless solutions from one source NORTH ANDOVER, Mass., December 2, 2008 - L-com, a global leader in the manufacture of wired and wireless connectivity solutions, today announced the expansion of its product offerings to include the Hyperlink line of wireless components. This expansion enables L-com to provide almost 8,000 products...

Read More »

All Topics