Electronic Amplifiers

Pasternack Delivers High Power Amplification with GaN Technology
Electronic Amplifiers

Pasternack Delivers High Power Amplification with GaN Technology

High Power Amplifier Generates 100W Saturated Output Power from 0.7 to 2.7 GHz Irvine, Calif. - Pasternack, a leading provider of RF, microwave and millimeter wave products, offers a number of high power broadband amplifiers that can be used across a wide range of applications including electronic warfare, radar, communications, and test and measurement. Pasternack’s PE15A5033F high power...

Read More »
TI's Nanopower Op Amps enable energy-efficient 4- to 20-mA loop systems.
Electronic Amplifiers

TI's Nanopower Op Amps enable energy-efficient 4- to 20-mA loop systems.

Operating on single supply voltage as low as 1.6 V and offset voltage as low as 300 µV, Texas Instruments’ nanopower, general-purpose LPV801 and LPV802 and precision LPV811 and LPV812 Operational Amplifiers extends battery and sensor life for applications such as building automation, sensor nodes, and wearables. With input rejection ratio greater than 80 dB in the 500-MHz to 1-GHz frequency...

Read More »
Model 2185 High Power Pulsed Amplifier with superior SWaP.
Electronic Amplifiers

Model 2185 High Power Pulsed Amplifier with superior SWaP.

Ideally used in DME, tactical air navigation, and military FoF, Model 2185 High Power Pulsed Amplifier operates in 960 to 1215 MHz at 10 KW peak range. Amplifier features protection and remote monitoring with excessive VSWR with Shutdown on fault and gives output power degradation at RF section component failure. With user selectable RF power detectors, AGC, ALC, and MGC output power modes, unit...

Read More »
Electronic Amplifiers

Custom MMIC President and CTO to Speak at the Compound Semiconductor Conference on KaBand Pulsed Gallium Nitride Power Amplifier for Radar Applications

Chelmsford, MAÂ- - October 25th 2016 - Custom MMIC, a leading developer of performance driven monolithic microwave integrated circuits (MMICs) is pleased to announce Paul Blount, President and CEO at Custom MMIC, will be presenting at the Compound Semiconductor Conference on Wednesday, October 26th with his talk entitled, “A High Efficiency, Ka-Band Pulsed Gallium Nitride Power...

Read More »
PE88X-Series Active Frequency Multipliers doubles input frequency.
Electronic Amplifiers

PE88X-Series Active Frequency Multipliers doubles input frequency.

Eliminating need for external LO buffer amplifier stage and additional circuitry, active frequency multipliers require single +5 V DC supply. Producing output power level up to +17 dBm, unit offers DC blocked input/output RF ports. Utilizing efficient GaAs PHEMT semiconductor technology, device offers output frequencies from 8 GHz to 46 GHz and input frequencies from 4 GHz to 23 GHz. Applications...

Read More »
Ultra - Low Noise Amplifiers, Driver Amplifiers, and Low Loss Phase Shifters on Display by Custom MMIC at IEEE International Symposium on Phased Array Systems and Technology
Electronic Amplifiers

Ultra - Low Noise Amplifiers, Driver Amplifiers, and Low Loss Phase Shifters on Display by Custom MMIC at IEEE International Symposium on Phased Array Systems and Technology

Chelmsford, MA – Custom MMIC, a leading developer of performance driven monolithic microwave integrated circuits (MMICs) is pleased to announce their attendance at the IEEE International Symposium on Phased Array Systems and Technology October 18 - 21st in Waltham, MA at Booth #7 with a focus on ultra-low noise amplifiers, driver amplifiers, and low loss phase shifters. With a large suite of...

Read More »
C-Band 20 W RF Power Amplifier supports complex waveforms.
Electronic Amplifiers

C-Band 20 W RF Power Amplifier supports complex waveforms.

NuPower™ 06D05A provides saturated RF power of 20 W in C-band (4.4–4.9 GHz) with module efficiencies of up to 30%. For complex waveforms requiring linear PA, this product offers error vector magnitude (EVM) of 4% at 2 W output. RF gain of 40 dB is achieved with 0 dBm nominal input drive level, and 4.50 x 3.50 x 0.61 in. aluminum chassis promotes heat dissipation for higher-temperature...

Read More »
Electronic Amplifiers

Intersil's14-channel programmable gamma buffer, ISL76534 offer 10-bit resolution.

Offering 1 Vcom and 14 gamma channels with 10-bit resolution for fine-tuning, the automotive-grade ISL76534 ensures consistent brightness and color matching for all LCD panels. Primarily designed for infotainment displays, ADAS smart mirrors and instrument cluster displays, ISL76534's 75 dB PSRR stops power supply noise from reaching the outputs and becoming visible in the LCD panel. Internal...

Read More »
Electronic Amplifiers

Multimedia Source Units feature marine-grade design.

Designed to fit 3 in. gauge hole instrument panel opening, one-piece Model GR10BT offers up to 180 W of peak power. Unit features variety of music source options, including Global AM/FM/Weather Band tuner, Bluetooth music streaming, MP3/WMA USB file playback, and standard RCA audio input. CMS3 two-piece marine-grade digital media hub, designed for extreme duty in harsh environments, offers choice...

Read More »
RF Power Amplifier supports L- and S-band transmitters.
Electronic Amplifiers

RF Power Amplifier supports L- and S-band transmitters.

Housed in 1.8 x 1.8 x 0.5 in. rugged aluminum chassis, NuPower™ 12A03A delivers minimum of 5 W of RF power from 1.0–2.5 GHz when driven with 0 dBm (1 mW) RF input signal. Device is also available in 30 dBm (1 W) input power level version, allowing plug-and-play use with various data transceivers. With low current draw of 0.85 A at +28 Vdc, amplifier supports array of RF communications,...

Read More »

All Topics