NuPowerTM 06C09A C-band PA uses GaN-on-SiC MMIC technology.
Measuring 2.5 x 2.0 x 0.65 inch compact size, NuPowerTM 06C09A C-band Power Amplifier provides 40 dB RF gain and module efficiency of greater than 35%. Suitable for electronic warfare systems for airborne electronic attack and unmanned aircraft systems, unit offers 15 Watts saturated RF power in C-band of 4.5 GHz to 6.25 GHz frequency coverage and is ideal for integration into wide variety of air...
Read More »
GaN Power Amplifiers come with gain of 15 to 40 dB.
With 2.5 Watts of output power and up to 20% PAE, GaN based Power Amplifiers eliminate need for combiners and waveguide interconnect. Used in application ranging from e-band radio, remote sensing as high power millimeter-wave sources, units are suitable for test and measurement applications. Available as 2-way and 4-way solid state power amplifiers, units come with internal voltage regulation,...
Read More »
Pasternack Delivers High Power Amplification with GaN Technology
High Power Amplifier Generates 100W Saturated Output Power from 0.7 to 2.7 GHz Irvine, Calif. - Pasternack, a leading provider of RF, microwave and millimeter wave products, offers a number of high power broadband amplifiers that can be used across a wide range of applications including electronic warfare, radar, communications, and test and measurement. Pasternack’s PE15A5033F high power...
Read More »
TI's Nanopower Op Amps enable energy-efficient 4- to 20-mA loop systems.
Operating on single supply voltage as low as 1.6 V and offset voltage as low as 300 µV, Texas Instruments’ nanopower, general-purpose LPV801 and LPV802 and precision LPV811 and LPV812 Operational Amplifiers extends battery and sensor life for applications such as building automation, sensor nodes, and wearables. With input rejection ratio greater than 80 dB in the 500-MHz to 1-GHz frequency...
Read More »
Corrosive/Ultrapure Fluid Heat Exchanger Coils - Choosing the Right Strategy
Check out this white paper to learn which heat exchanger types are the best for high temperature performance in chemically aggressive applications.
Read More »
Model 2185 High Power Pulsed Amplifier with superior SWaP.
Ideally used in DME, tactical air navigation, and military FoF, Model 2185 High Power Pulsed Amplifier operates in 960 to 1215 MHz at 10 KW peak range. Amplifier features protection and remote monitoring with excessive VSWR with Shutdown on fault and gives output power degradation at RF section component failure. With user selectable RF power detectors, AGC, ALC, and MGC output power modes, unit...
Read More »Custom MMIC President and CTO to Speak at the Compound Semiconductor Conference on KaBand Pulsed Gallium Nitride Power Amplifier for Radar Applications
Chelmsford, MAÂ- - October 25th 2016 - Custom MMIC, a leading developer of performance driven monolithic microwave integrated circuits (MMICs) is pleased to announce Paul Blount, President and CEO at Custom MMIC, will be presenting at the Compound Semiconductor Conference on Wednesday, October 26th with his talk entitled, “A High Efficiency, Ka-Band Pulsed Gallium Nitride Power...
Read More »
PE88X-Series Active Frequency Multipliers doubles input frequency.
Eliminating need for external LO buffer amplifier stage and additional circuitry, active frequency multipliers require single +5 V DC supply. Producing output power level up to +17 dBm, unit offers DC blocked input/output RF ports. Utilizing efficient GaAs PHEMT semiconductor technology, device offers output frequencies from 8 GHz to 46 GHz and input frequencies from 4 GHz to 23 GHz. Applications...
Read More »
Ultra - Low Noise Amplifiers, Driver Amplifiers, and Low Loss Phase Shifters on Display by Custom MMIC at IEEE International Symposium on Phased Array Systems and Technology
Chelmsford, MA – Custom MMIC, a leading developer of performance driven monolithic microwave integrated circuits (MMICs) is pleased to announce their attendance at the IEEE International Symposium on Phased Array Systems and Technology October 18 - 21st in Waltham, MA at Booth #7 with a focus on ultra-low noise amplifiers, driver amplifiers, and low loss phase shifters. With a large suite of...
Read More »
C-Band 20 W RF Power Amplifier supports complex waveforms.
NuPower™ 06D05A provides saturated RF power of 20 W in C-band (4.4–4.9 GHz) with module efficiencies of up to 30%. For complex waveforms requiring linear PA, this product offers error vector magnitude (EVM) of 4% at 2 W output. RF gain of 40 dB is achieved with 0 dBm nominal input drive level, and 4.50 x 3.50 x 0.61 in. aluminum chassis promotes heat dissipation for higher-temperature...
Read More »Intersil's14-channel programmable gamma buffer, ISL76534 offer 10-bit resolution.
Offering 1 Vcom and 14 gamma channels with 10-bit resolution for fine-tuning, the automotive-grade ISL76534 ensures consistent brightness and color matching for all LCD panels. Primarily designed for infotainment displays, ADAS smart mirrors and instrument cluster displays, ISL76534's 75 dB PSRR stops power supply noise from reaching the outputs and becoming visible in the LCD panel. Internal...
Read More »
More performance and functionality for Sinumerik 828D CNC
Siemens new SINUMERIK 828D ADVANCED, SINUMERIK 828D and SINUMERIK 828D BASIC sets the standard for productivity enhancements of turning and milling operations on standardized machines and simplify the automation of grinding machines. See our video to learn all about it.
Read More »
