Optical Parametric Amplifier can be pumped at 1 or 5 kHz.
OPerA(TM) is a low noise, femtosecond OPA that extends wavelength range of Ti:Sapphire kilohertz amplifiers from UV through mid-IR. Standard unit tunes from 1,150-2,900 nm, while Opera-VIS adds output from 400-1,150 nm, and Opera-UV adds output from less than 300-400 nm. A 1.0 mJ of pump energy produces more than 0.1 mJ signal and more than 0.05 mJ idler beams. OPerA is suited for femtosecond...
Read More »Triple Video Amplifier features internal fixed gain of 2.
Model LT6553 eliminates need for external gain setting resistors. It features -3 dB bandwidth of 650 MHz, slew rate of 2,500 V/Ã-µs, and 6 ns settling time, resulting in sharp video images. Differential phase of 0.01Ã-
Read More »Laser Amplifier provides output power of 4 W at 1,048 nm.
Based on Ytterbium tungstate, Eclipse(TM) femtosecond amplified laser operates at pulse repetition rates up to 7 kHz and generates pulse widths of less than 500 femtoseconds. Equipped with optional frequency doubler module, Eclipse delivers output power up to 1.5 W at 524 nm. Laser head utilizes modular design in single compact housing, including directly diode-pumped, monolithic low power seed...
Read More »Audio Power Amplifier targets multi-channel applications.
Single-chip Model STA5150 delivers 200 W into 4 ohm load with less than 10% distortion. It combines Indigo's BASH topology and Bipolar-CMOS-DMOS process technology. BASH technology uses DMOS power transistors operated in class AB mode, reducing EMI and distortion typical of class D switching amplifiers. By continually adjusting power supply voltage, depending on amplitude of amplified audio...
Read More »Finding the Right Bore Configuration for your Application
There are multiple things to consider when choosing a bore configuration for your application. Check out this e-book to learn more!
Read More »Current-Feedback Amplifier suits wireless communications.
Housed in SO-8 and SOT23-6 packages, OPA695 IF amplifier is capable of single supply, +5 to +12 V operation. At G = +8, unit offers 4,300 V/Ã-µsec slew rate and greater than 450 MHz bandwidth. At G = +2, it offers 1.4 GHz bandwidth with 2,500 V/Ã-µ sec slew rate. Unit, specified over commercial and industrial temperature ranges, has 12.9 mA supply current and optional disable control pin...
Read More »Laser Amplifier suits industrial/scientific applications.
Libra(TM) regenerative amplifier consists of femtosecond laser system that combines on-board diagnostics, seed laser-to-OPA computer interface, and hands-off operation in compact, one-box package. Integrated design incorporates Vitesse(TM) as seed laser and Evolution-15 as pump laser. Unit delivers 1 W of 800 nm output at repetition rates of 1 or 5 kHz. It also pumps multiple optical parametric...
Read More »Variable Gain Amplifier suits medical imaging applications.
Model VCA8613 incorporates 8 low-noise pre-amplifiers, 8 attenuators, and 8 post-gain amplifiers, but draws only 600 mW. Differential outputs of LNAs can be switched through 8 x 10 cross-point switch, which is programmable through serial interface input port. Device operates on single 3 V supply and features 1.2 nV/rtHz input voltage noise at 5 MHz. Gain can be varied between 21-26 dB....
Read More »Fixed-Gain Amplifier suits video signal processing.
Packaged in SOT23-6 and SO-8, OPA693 ultra-wideband, fixed-gain video buffer amplifier utilizes output stage architecture and operates from one 5-12 V power supply. Using +5 V supply, it delivers 2 Vpp output swing with 90+ mA drive current and 400 MHz bandwidth at +2 gain. Internal resistor network provides fixed gain of +2 video buffer or Ã-
Read More »Voltage Limiting Amps suit comm/video/medical applications.
Wideband voltage limiting amplifiers set hard limit to output voltage excursion. Packaged in pinout SO-8, OPA698 features unity-gain stability, 250 MHz gain bandwidth product, and 1,100 V/Ã-µsec slew rate, while OPA699 features high-gain stability, 1 GHz gain bandwidth product, and 1,400 V/Ã-µsec slew rate. Both offer Ã-
Read More »Audio Power Amplifier features DC volume control.
Model TPA2008D2 5 V, Filter-Free, Class-D Amplifier will drive 6 W into 3 ohm speakers at full power with no external heat sink. Gain is controlled by DC voltage applied to VOLUME pin. Half power total harmonic distortion plus noise is 0.045% at 1 kHz, and noise floor is -80 dBV. Amplifier comes in standard PowerPAD(TM) surface-mount, 24-pin TSSOP package and is suited for 15-17 in. LCD TVs and...
Read More »ISO-Certified Plastic Injection Molding from Rodon
The Rodon Group is a proven leader in high-volume, close tolerance injection molding. We offer globally competitive, innovative manufacturing solutions for a broad range of industries. Check out our video to learn more.
Read More »