Electronic Amplifiers

Op Amps have boost voltage.
Electronic Amplifiers

Op Amps have boost voltage.

PA38 and PA39 high voltage MOSFET power operational amplifiers are constructed with surface mount components on thermally conductive but electrically isolated substrate. Metal substrate allows PA38 and PA39 to dissipate power up to 125 watts. Power supply voltages range from ±100 Volts (200V total) for PA38 to ±50 Volts (100V total) for PA39. Both have slew rates of 10 V/Â-µs,...

Read More »
RF Amplifier handles BCI testing environments.
Electronic Amplifiers

RF Amplifier handles BCI testing environments.

Model 100A400 has high load tolerance, making it suitable for harsh test environments encountered in bulk current injection testing in automotive industry, where VSWR can exceed 6.0:1. 100 watt, 100 kHz to 400 MHz amplifier is also suitable for laboratory applications requiring instant bandwidth, high gain and moderate power output, such as antenna and component testing, wattmeter testing, and as...

Read More »
Electronic Amplifiers

Op Amps offer supply voltages from +/-2.5V to +/-9V.

MIC918 and MIC919 high speed op amps achieve slew-rates of 1500V/Â-µs while consuming 550µA and 360µA, respectively. Both op amps are voltage-feedback, unity-gain stable devices housed in SC70-5 packaging. Gain-bandwidth product for MIC918 and MIC919 is 51MHz and 27MHz, respectively. Both Op Amps have 60 degrees of phase margin at unity gain that increases with load...

Read More »
Electronic Amplifiers

Operational Amplifiers increase battery-powered system life.

MCP602X family of rail-to-rail input and output op amps are suitable for low current, battery-powered applications. MCP6021 (single), MCP6022 (dual), and MCP6024 (quad) devices meet industry standard pin-outs in standard PDIP, SOIC and TSSOP packages. Each has unity gain stability with gain bandwidth product (GBWP) of 10 MHz, low noise, and maximum quiescent current of 1.35 Â-µA. Devices can...

Read More »
CMAA Crane Buyer's Guide
Sponsored

CMAA Crane Buyer's Guide

CMAA has organized this Buyer's Guide to promote standardization and to assist prospective buyer's of electric overhead traveling cranes in selection of equipment most suitable for their applications.

Read More »
Rejection Filters address SATCOM market.
Electronic Amplifiers

Rejection Filters address SATCOM market.

Series 12086 transmit rejection filters are installed between antenna and LNA in receive segment of satellite earth terminals. They are used in C-band transceiver applications to isolate uplink and downlink signals. Units offer low loss, typically less than 0.04 dB on receive signals, while providing high degree of transmit rejection, ranging from 50 to 80 dB. Construction is 100% dip brazed...

Read More »

All Topics