Electronic Amplifiers

Voltage Limiting Amps suit comm/video/medical applications.
Electronic Amplifiers

Voltage Limiting Amps suit comm/video/medical applications.

Wideband voltage limiting amplifiers set hard limit to output voltage excursion. Packaged in pinout SO-8, OPA698 features unity-gain stability, 250 MHz gain bandwidth product, and 1,100 V/Â-µsec slew rate, while OPA699 features high-gain stability, 1 GHz gain bandwidth product, and 1,400 V/µsec slew rate. Both offer ±120 mA output current, ±4 V output swing, and dual...

Read More »
Audio Power Amplifier features DC volume control.
Electronic Amplifiers

Audio Power Amplifier features DC volume control.

Model TPA2008D2 5 V, Filter-Free, Class-D Amplifier will drive 6 W into 3 ohm speakers at full power with no external heat sink. Gain is controlled by DC voltage applied to VOLUME pin. Half power total harmonic distortion plus noise is 0.045% at 1 kHz, and noise floor is -80 dBV. Amplifier comes in standard PowerPAD(TM) surface-mount, 24-pin TSSOP package and is suited for 15-17 in. LCD TVs and...

Read More »
Transimpedance Amplifier permits digital entry of A/W.
Electronic Amplifiers

Transimpedance Amplifier permits digital entry of A/W.

Model PdA-750 provides direct digital readout of current generated from photodiode, photomultiplier, or similar current source. Full-scale input ranges are ±20 nA to ±20 mA with noise level of less than 1 pA. Unit features variable bias supply, background cancellation, bi-directional RS-232 port, and rechargeable batteries. Large 4Â-½ digit LCD provides max resolution of 1 part...

Read More »
CMOS Op Amps drive 16-bit data converters.
Electronic Amplifiers

CMOS Op Amps drive 16-bit data converters.

Models OPA725 and OPA726 are 12 V, high-speed operational amplifiers that achieve 20 MHz bandwidth, 30 V/Â-µs slew rate, and 0.0003% harmonic distortion with 16-bit settling time. Input common-mode range extends to ground for true single-supply operation, and output swings to within 150 mV of rails, maximizing dynamic range. Both are specified for operation from -40 to +125°C, and are...

Read More »
Differential Amplifier is optimized for video applications.
Electronic Amplifiers

Differential Amplifier is optimized for video applications.

Model LT6552 3.3 V wideband difference amplifier minimizes effects of high-frequency noise pickup, allowing signals to be sent over long lines without corruption by external sources. Common mode rejection is >60 dB at 10 MHz. Unit comes in 3 x 3 mm DFN package and features 75 MHz -3 dB bandwidth, 600 V/Â-µs slew rate, and ±70 mA output current, making it suitable for driving cables....

Read More »
Rail-to-Rail Op Amp features 3-12 V operation.
Electronic Amplifiers

Rail-to-Rail Op Amp features 3-12 V operation.

Current feedback amplifier, Model LT6210 offers adjustable supply current that is programmable from 300 Â-µA to 6 mA with corresponding bandwidth from 10-200 MHz. By changing one resistor, each LT6210 can be configured to attain specific bandwidth and slew rate for given supply current. Unit is offered in 6-lead ThinSOT(TM) package and can be used as video line driver pre-amp, buffer, or...

Read More »
Mono Amplifiers drive 16-32 ohm speakers and earpieces.
Electronic Amplifiers

Mono Amplifiers drive 16-32 ohm speakers and earpieces.

Models TS419 and TS421 operate from supply of 2 V and draw max of 2.5 mA. Standby current consumption can be as little as 10 nA. Amplifiers are available with external gain configuration or with fixed gain of 6, 12, or 18 dB. Signal to noise ratio is typically 98 dB with 5 V supply. Offered in MiniSO-8 and DFN8 packages, amplifiers include On/Off click reduction circuitry and are suited for...

Read More »
Sources and Amplifiers suit laboratory applications.
Electronic Amplifiers

Sources and Amplifiers suit laboratory applications.

Leveraging diode-pumped erbium doped fiber technology, Broadband ASE (amplified spontaneous emission) sources and EDFAs (erbium doped fiber amplifiers) are packaged for test and measurement of photonics components in 1550 nm spectral region. Self-contained BBS-410 and BBS-430 sources generate broadband output as high as 25 mW. Fully-integrated FPA-410 and FPA-415 EDFAs feature signal gains of...

Read More »
Rail-to-Rail Operational Amplifiers draw less than 1 mA.
Electronic Amplifiers

Rail-to-Rail Operational Amplifiers draw less than 1 mA.

Models LT6220 single, LT6221 dual, and LT6222 quad rail-to-rail input and output precision op amps are rated at 60 MHz and can operate from supplies of 2.3-12.6 V. Characteristics include 350 Â-µV max input offset voltage, 150 nA max input bias current, 82 dB CMRR, and 90 dB voltage gain. Devices have output current capability of 50mA for driving heavy loads. They are rated for 0 to...

Read More »

All Topics

COVID-19 Response Suppliers COVID-19 Response:
Can Your Company Help Provide Critical Supplies?

We are using the power of our platform to aid in the mass shortage of critical supplies. If your company can help provide supplies, capabilities, or materials for products such as N-95 Masks and Tyvek SuitsPlease let us know.

COVID-19 Response Suppliers