New: Buy Now on Thomas and Pay Over Time with Credit Key   Learn More

Electronic Amplifiers

Electronic Amplifiers

Linear Power Amplifier targets 3G cell phones.

Model AWT6388 is for CDMA450-based cell phones and wireless local loop applications that bring 3G voice and data communications to wide areas in emerging and developed countries. High power and -134 dBm/Hz receive band noise enable performance over extended coverage areas of wide area CDMA450 networks. At 4 x 4 x 1 mm, it is built using InGaP HBT technology and features low-power quiescent...

Read More »
High Side Current Sense Amp has 10 µV offset, zero drift.
Electronic Amplifiers

High Side Current Sense Amp has 10 µV offset, zero drift.

Supplied in 3 x 3 mm package, LTC6102 has max input offset voltage that allows for lower sense resistance without sacrificing resolution. Differential sense voltages are accepted up to 2 V, and 106 dB dynamic range allows unit to resolve micro-amps from amps of current. Topology allows designer to customize power consumption, 1 -µs response time, and I/O impedance characteristics. While 4-60 V...

Read More »
Electronic Amplifiers

ANADIGICS Ships WCDMA PAs for Huawei's Music Optimized 3G Handset

ANADIGICS' AWT6279 PA Selected for Stylish, Feature-Rich U120 Mobile Phone WARREN, N.J., June 12 // -- ANADIGICS, Inc. (NASDAQ:ANAD) today announced that they are shipping production volumes of ANADIGICS AWT6279 High-Efficiency-at-Low-Power (HELP3(TM)) wideband CDMA (WCDMA) power amplifiers to Huawei Technologies Co., Ltd. for its U120 music optimized 3G handset. The stylish, feature-rich U120 is...

Read More »
Electronic Amplifiers

GDA Collaborates with AMD to Develop Home Cinema Design

Innovative Home Entertainment Device Design Speeds Time to Market SAN JOSE, Calif., May 9, 2007 - GDA Technologies Inc., a leading Electronic Design Services (EDS) and Silicon Intellectual Property (SIP) solution provider for embedded, networking, and consumer electronics markets, today announced its successful collaboration with AMD to create a new reference design that OEMs can leverage to...

Read More »
Electronic Amplifiers

Post Amplifier is designed for fiber optic transceivers.

Model SY88973BL low-power limiting post amplifier offers multi-rate capability from 622 Mbps up to 3.2 Gbps operation. It incorporates low loss-of-signal, open-collector TTL output with external 4.75-10k micron pull-up resistor, and also features internal 50 micron data input and low-noise 50 micron CML data output. Available in 3 x 3 mm 16-pin MLF-® package, device operates from single +3.3 V -

Read More »
Electronic Amplifiers

Amplifier is modular and stackable.

Offering dual duplex operation, ClearGain DD1900 Ground-Mounted Amplifier (GMA) incorporates fixed-gain, low-noise amplifier and high-performance filters. Without need for tower climbs, GMA improves signal quality by boosting uplink (RX) signal of mobile system. Amplifying full 1,900 MHz band, it consists of amplification module and power distribution unit, providing full compatibility with all...

Read More »
Electronic Amplifiers

Broadband Wireless Access Point supports up to 4 radios.

DOCSIS-®-based HyFi(TM) 1100 enables Cable Operators to leverage existing Hybrid Fiber Coax network to provide broadband wireless services for city-wide Hotzone and Municipal Wi-Fi applications. When deployed in concert with CASA software, network of installed HyFi 1100s will be able to be auto-discovered, remotely configured, and centrally managed. Solution supports up to 4 independent IEEE...

Read More »
Electronic Amplifiers

Class-D Audio Amplifiers employ filter-free architecture.

Featuring EMI under 30 dBuV/m for frequencies up to 700 MHz, stereo Model PAM8403 and mono Model PAM8303S provide efficiency higher than 90% with 8 W load. Only one input coupling capacitor per channel is needed in external circuit. Housed in 24-pin SOP and SOP-8 packages respectively, 3 W units are suited for digital photo frames, MP4/PMP, GPS navigators, PC speakers, portable DVD players, LCD...

Read More »
Electronic Amplifiers

Amplifier IC targets AM/FM car antennas.

Designed to compensate for signal losses, impedance matching Model ATR4251 enables clear AM/FM car-radio reception when used with windshield, roof, or bumper antennas. Automatic AM and FM gain control enable independent AM and FM adjustment to prevent overdriving of amplifiers under large-signal conditions. Buffer amplifier for AM covers frequency range from 150 kHz to 30 MHz, while FM low noise...

Read More »
Electronic Amplifiers

Endwave Announces New ALC Log Amplifiers(TM)

SAN JOSE, CA-May 18, 2007-Endwave Corporation (NASDAQ: ENWV), a provider of high-frequency RF modules for telecommunications networks, defense electronics and homeland security systems, has announced the release a new product line of ALC Log Amplifiers(TM). ALC Microwave, a leading provider of logarithmic amplifiers to many US and international defense prime contractors, was acquired by Endwave...

Read More »

All Topics