Electronic Amplifiers

Micropower Op Amps feature offset voltage of 150 µV.
Electronic Amplifiers

Micropower Op Amps feature offset voltage of 150 µV.

Built on VIP50 BiCMOS process technology, PowerWise LMP223x Series consumes less than 16 Â-µW per channel while providing 130 kHz usable bandwidth and TCVOS as low as ±0.4 µV/°C. Series includes single, dual, and quad models featuring 1.6-5.5 V operation, 10 µA of supply current per channel, and operating temperature of -40 to 125°C. Units offer extended...

Read More »
Electronic Amplifiers

Xilinx Announces Digital Pre-Distortion Reference Design for Freescale's LDMOS Power Amplifier Devices

Industry leaders collaborate to substantially decrease radio development time, increase efficiency and reduce cost for wireless infrastructure BARCELONA, Spain, Feb. 11 -- Xilinx Inc. (NASDAQ:XLNX), the world's leading supplier of programmable logic solutions, today announced a new digital pre-distortion (DPD) reference design based on its Virtex(TM) family of platform FPGAs and XtremeDSP...

Read More »
Electronic Amplifiers

Power Amplifier suits 3G wireless handsets and equipment.

Designed to meet all requirements for GSM/GPRS and EDGE operations in dual-, tri-, or quad-band handsets, Model AWE6174 Polar EDGE power amplifier (PA) module supports use of dc-dc converter to modulate bias voltage and reduce current consumption. It includes separate amplifiers for GSM850/900 and DCS/PCS bands optimized for high performance in both GMSK and 8PSK modes in 6 x 6 mm package. Unit...

Read More »
Power Amplifier targets high-efficiency VSAT applications.
Electronic Amplifiers

Power Amplifier targets high-efficiency VSAT applications.

Designed for Very Small Aperture Terminal (VSAT) applications, M/A-COM MAAPSS0111 is 13.75-14.5 GHz, 4-stage, 1.25 W power amplifier that can be used as driver or output stage amplifier. It is designed to generate 31 dBm of saturated output power while drawing 530 mA of current. Housed in RoHS-compliant, 6 mm 28-lead PQFN package, unit has typical power gain of 32 dB with operating voltage of 8.0...

Read More »
Electronic Amplifiers

Audio Line Driver has power supply range of 1.8-4.5 V.

Available in 4 x 4 mm package, Model DRV601 2VRMS DirectPath(TM) integrates charge pump to allow complete audio output signal chain to run from single 3.3 V power supply. It features 2VRMS/channel output voltage into 600 W at 3.3 V, independent right and left channel shutdown control, greater than 105 dB dynamic range, short-circuit and thermal protection, and pop reduction circuitry. It is...

Read More »
Amplifier-Digitizer handles large strain gage applications.
Electronic Amplifiers

Amplifier-Digitizer handles large strain gage applications.

Designed for Series 6000 DAQ System, Model 6037 is 8-channel strain gage and transducer signal conditioning-amplifier-digitizer that automatically ranges gain according to signal level. Excitation is programmed in 1 V steps from 0-12 V, while 4-pole, low-pass filter provides bandwidths from 1 Hz to 1 kHz with programmable selection of filtered or wideband output. Unit features 16-bit Adc that...

Read More »
Electronic Amplifiers

Gooch & Housego Receives Prestigious Award from Lawrence Livermore National Laboratory

February 5th, 2008 - Gooch and Housego has been presented with a Vendor Appreciation" award from the Lawrence Livermore National Laboratory (LLNL) for the supply of crystal quartz wave plates. The wave plates, supplied by Gooch & Housego Ilminster, in the UK, are key components used in the National Ignition Facility's (NIF) laser pre-amplifier modules at LLNL. The NIF will be used as part of the...

Read More »
Electronic Amplifiers

Power Amplifier suits 3G wireless handsets and equipment.

Designed to meet requirements for GSM and EDGE mode operation with WCDMA and HSPA chipsets, quad-band AWT6155 Polar EDGE Power Amplifier delivers full power output in Polar EDGE Mode with 5 x 5 mm footprint. RoHS-compliant device includes separate amplifier chains, one to support GSM850/900 bands and another for DCS/PCS bands. Internal reference voltage and integrated power control scheme...

Read More »
Electronic Amplifiers

RF Power Amplifier is engineered for 2.3-2.4 GHz band.

Supplied in RoHS-compliant 4.5 x 4.5 x 1.4 mm SMT package, AWM6422 is designed for WiMAX and WiBro applications. It supports IEEE 802.16e-2005 wireless standard as well as IEEE 802.16d-2004 and ETSI EN301-021 standards. Along with InGaP-Plus(TM) technology, solution integrates 25 dB attenuator, output power detector, and 50 W matched RF ports. It exhibits 30+ dB RF Gain and offers EVM...

Read More »
Electronic Amplifiers

Stereo Headset Amp promotes feature-phone audio quality.

Supplied in 2.1 x 2.1 x 0.6 mm flip-chip package, TS4601 offers typical power-supply rejection ratio of -107 dB that prevents handset battery noise from reaching audio output. User functions and configuration control are managed via built-in IÂ-²C interface, and sub-2 µA stand-by mode promotes power conservation. Output is stable under all load conditions, allowing glitch-free...

Read More »

All Topics