Electronic Adapters

USB Card supports signaling up to 480 Mbps.
Electronic Adapters

USB Card supports signaling up to 480 Mbps.

Four-port Model PPM-USB2 provides direct Peripheral Component Interconnect to PC/104-Plus bus. It includes 2 OHCI controller cores for full-/low-speed signaling and one EHCI host controller for high-speed signaling. Root hub with 4 downstream facing ports is shared by OHCI and EHCI controller cores. All downstream facing ports can handle 480 Mbps high-speed, 12 Mbps full-speed, and 1.5 Mbps...

Read More »
IDE Adapter supports both Type I and Type II cards.
Electronic Adapters

IDE Adapter supports both Type I and Type II cards.

Featuring 40-pin and 44-pin IDE connectors, remote CompactFlash® to IDE adapter, Model CFII-IDE(TM) enables both solid-state CompactFlash and IBM® Microdrive® media to be used as bootable IDE disk drive in any computer with IDE interface. It includes power and drive activity LEDs, master/slave selection jumper, 4 mounting holes, and front panel mounting brackets. Model CFII-IDE...

Read More »
USB Devices allow portable data acquisition.
Electronic Adapters

USB Devices allow portable data acquisition.

Offering 16-bit accuracy, DAQPad-6015 and DAQPad-6016 feature maximum sampling rate of 200 kS/sec for single channel. The 4-channel, 24-bit, USB-9211 provides thermocouple measurement, while 4-channel, 16-bit USB-9215 offers simultaneous sampling, measuring multiple signals with minimal phase delay. Both deliver integrated signal conditioning. SCXI-1600 DAQ module delivers plug-and-play USB...

Read More »
Electronic Adapters

Adapter integrates xSeries and eserver i5 servers.

Integrated xSeries® Adapter, Model 200 enables direct high-speed attachment of eServer® xSeries x346 servers to iSeries and eServer i5 servers. Server and storage management for xSeries servers may be consolidated on eServer i5, with up to 31 TB of disk storage capacity per Windows(TM) server. Integrated xSeries Server and xSeries servers attached to iSeries and eServer i5 servers...

Read More »
Adapter Card enables communication with serial I/O.
Electronic Adapters

Adapter Card enables communication with serial I/O.

Isolated adapter card, PCI-AC48, links RS-485 serial devices with industrial and personal computers using 33 MHz PCI bus. It enables RS-485 communication with Opto 22 serial-based I/O, including remote bricks for mistic(TM) I/O product family, as well as SNAP-B3000 serial brain. Product incorporates 2 RS-485 serial ports that provide communication in 2- or 4-wire mode, and software that allows...

Read More »
Electronic Adapters

Ethernet Adapter is offered for eserver pSeries® systems.

Ethernet-SR PCI-X adapter, No. 5718, offers 10 Gigabit Ethernet PCI-X based server connections with throughput on standard, shortwave multimode optical cable. It supports distances to 33 m using 62.5 Â-µm multimode fiber with 200 MHz km min modal bandwidth @ 850 nm or 300 m using 50 µm multimode fiber with 2,000 MHz km min modal bandwidth @ 850 nm. Product supports...

Read More »
Adapter connects flash drives to IDE port.
Electronic Adapters

Adapter connects flash drives to IDE port.

Available in single- and dual-drive versions, CFADPT7 allows users to connect 1 or 2 compact flash drives to any system with IDE port. It fits in 2.5 in. hard drive footprint to allow for retrofit of existing products. In addition to standard 44-pin, 2 mm IDE connector, CFADPT7 can also have 40-pin IDE connector. Unit accepts both type 1 and type 2 CF cards and works with DMA capable CF cards.

Read More »
USB to RS232 Adapter is USB bus powered.
Electronic Adapters

USB to RS232 Adapter is USB bus powered.

Utilizing Cygnal's CP2101 USB to UART IC, Model ADP-232 helps users transition from RS-232 applications to standard USB 2.0. Designers can maintain desired RS-232 device and plug it into available USB port. Corresponding mounting holes are provided on PCM-2004 USB Hub/Controller to allow for mounting up to 4 ADP-232 devices, adding as many as 4 RS-232 ports to system.

Read More »
Bridge provides USB-to-serial connectivity.
Electronic Adapters

Bridge provides USB-to-serial connectivity.

Supporting both self- and bus-powered modes, Model TUSB3410 allows connectivity between serial-based embedded applications and laptops or legacy-free PCs. It contains 8052 microcontroller unit with 16 kB RAM that can be loaded from host or external on-board memory via I2C bus. Fully compliant with USB Full Speed specifications, bridge supports data rate of 12 Mbps and can sustain 6 total...

Read More »
Electronic Adapters

IP Phone Power Adapter is compatible with CISCO standard.

Model EPA3 Ethernet Power Adapter enables IP telephones to receive power from network supplying power over Ethernet. Incorporated 3-port switch makes it possible to deliver full network bandwidth to PC or laptop. Unit uses 802.3af standard or proprietary Cisco in-line power as input and delivers 12 V to standard dc power jack on IP phone. Adapter has power and connection status LEDs as well as...

Read More »
Sentry Equipment Introduces New Compact Hygienic Automatic Sampler
Sponsored

Sentry Equipment Introduces New Compact Hygienic Automatic Sampler

As a leader in industrial sampling equipment at Sentry Equipment, our success is built on a history of innovation and designs that epitomize value and efficiency. The new Hygienic Automatic Sampler is another example of our dedication to developing quality engineered products. To learn how this product can streamline the sampling process for dry, free-flowing materials, see our new video.

Read More »

All Topics

COVID-19 Response Suppliers COVID-19 Response:
Can Your Company Help Provide Critical Supplies?

We are using the power of our platform to aid in the mass shortage of critical supplies. If your company can help provide supplies, capabilities, or materials for products such as N-95 Masks and Tyvek SuitsPlease let us know.

COVID-19 Response Suppliers