Electrical Equipment & Systems

Electric Motors are suitable for tube rolling.

Electric Motors are suitable for tube rolling.

Models 41238 and 22488 Electric Rolling Motors can both be repeatedly run to stall without damage when expanding tubes in boilers, heat exchangers, and other pressure vessels. Model 41238 weighs 19 lb, expands tubes from Â-¾ to 2Â-½ in. OD, and can be used to power tube cutters, tube beading units, tube bevellers and other tools. More powerful Model 22488 can expand tubes up to 3 in. OD,...

Read More »
DC Electrical Receptacles install quickly.

DC Electrical Receptacles install quickly.

Weather-resistant plugs and receptacles for vehicles have Slide-Lok(TM) locking ring for easy installation. Installer slides keyed ring past most of receptacle threads, until ring is flush against panel. Quarter turn engages ring onto threads. Models include: 12VRCTT Thin Terminal receptacle with 2 different-sized NEMA connection tabs to prevent misconnection; 2VPG2A 12 V plug fused at 2 A; and...

Read More »
Bendable Conduit protects wire and fiber optics.

Bendable Conduit protects wire and fiber optics.

Heat-bendable THERM-A-FORM(TM) has memory for shapes. Crush-resistant conduit may be heated and bent into shapes that are retained when cooled. Shapes can be made prior to inserting cables, or with wire or fiber-optic cables installed. Flame-retardant material can be used in long lengths or small sections where extra protection is needed.

Read More »

Switches provide safety and access management.

Electronic Key System (EKS) consists of electronic key and matching key mount, and is used to manage access to PCs and control systems. CES Safety Switch consists of actuator, read head and evaluation unit. Coding of each actuator allows highest level of safety (Category 4) to be maintained. TZ Safety Switch connects directly to AS-i bus. Safety Switch TX meets requirements according to EN 1088...

Read More »
Terminal Block Relay has leakage current suppression circuit.

Terminal Block Relay has leakage current suppression circuit.

Model 700-HL interfaces between TRIAC PLC or SLC programmable controller output and field device, and keeps relay coil turned off when I/O signal is low. Shunting circuit redirects leakage current before current reaches coil. Capable of shunting up to 2.2 mA leakage current for 120 and 240 Vac input voltages, it is available in 110, 125 and 240 Vac/Vdc input voltages in solid-state and...

Read More »
Servo Motors/Amplifiers offer speeds to 6,000 rpm.

Servo Motors/Amplifiers offer speeds to 6,000 rpm.

Sigma II Series AC servo products come in 240 and 480 Vac for applications requirements up to 15 kW. There are 32 combinations of motors and amplifiers ranging from 13.5 oz-in. rated torque to 1550 lb-in. peak torque. Servo drives feature velocity loop bandwidth of 400 Hz abd 16- or 17-bit serial encoder. Servo amplifier reads servo motor ID, indicating type and capacity, and automatically sets...

Read More »
Generator Relay protects against abnormal conditions.

Generator Relay protects against abnormal conditions.

SEL-547 Distributed Generator Interconnection Relay provides utility-grade protection when using generator in all operating modes including peak shaving, base loading, islanding, and emergency backup. Relay provides most basic generator protection functions recommended by IEEE Standard P1547 including over/under voltage detection for single or 3-phase, over/under frequency detection, synchronism...

Read More »

Relay suits opto-electronic protective devices.

MSI Relay expands function of safety light curtains by adding restart interlock, relay monitoring, single or double break, and muting. It is capable of monitoring category 4 safety switches and/or e-stop buttons. Modular unit comes in either 35 or 53 mm housing and is available with 2 different plug-in output sub-assemblies, one for potential-free switching in AC control circuits and one for...

Read More »
Pushbutton Switch mounts in 22.5 mm round hole.

Pushbutton Switch mounts in 22.5 mm round hole.

Dual Lighted Pushbutton is available in momentary action with independent lighted indicator. It features green and red lenses and comes with international ON/OFF legends or with no legends. Actuator meets NEMA 4 and 13 and IP65 requirements, and switch contacts are rated 10 A at 660 Vac. Pushbutton meet UL, CSA, and other international approvals.

Read More »

All Topics