Electrical Equipment & Systems

Motors are inverter-ready.
Motors

Motors are inverter-ready.

Severe Duty motors are available in ratings from 1/2 to 500. Constructed of iron, they are built with Class F insulation, Class B temperature rise, and 1.15 service factor. Motors through 575 V use ISR(TM) Inverter Spike Resistant wire. Processing motors provide corrosion resistant epoxy finish, regreasable ball bearings, oversized rotatable cast iron conduit boxes, and stainless steel nameplate....

Read More »
Pump Protector prevents pump from running dry.
Protectors

Pump Protector prevents pump from running dry.

Stator protection device consists of thermocouple mounted in stator, temperature sensor, and temperature controller. Thermocouple continuously measures stator temperature over ranges from 0 to 255 deg C. If stator temperature rises above specified cut-off point, optical or acoustic signal shows on controller display. Controller can also be set to switch pump off immediately. Applications include...

Read More »
Power Supplies produce 40W outputs.
Power Supplies

Power Supplies produce 40W outputs.

MKS40-Series high density enclosed switching power supplies accept universal input from 85-265 Vac and are available in 4 models that provide single outputs from 5 to 24 Vdc. All models have LED indicator, output adjustment potentiometer, 3,000 V isolation, over voltage and short circuit protection, and integral input line filtering. They operate over ambient temperature range of -10 to +60 deg C...

Read More »
Solid State Relays work in telecommunications.
Solid State Relays

Solid State Relays work in telecommunications.

Optically coupled SSRs are available in 4 models: HSR312, HSR412, HSR312L, and HSR412L. All consist of AlGaAs infrared LED optically coupled to photovoltaic generator that drives power MOSFET detector, and all have 4,000 Vrms isolation. HSR312 and HSR312L switch loads up to 250V, while HSR412 and HSR412L switch loads up to 400V. HSR312L and HSR412L employ active current limit circuitry that...

Read More »
Battery Straps protect rechargeable battery packs.
Straps

Battery Straps protect rechargeable battery packs.

MF-SVS, MF-VSN and MF-VS Multifuse(R) Polymeric Positive Temperature Coefficient straps, with resettable fuses, enhance safety and performance of rechargeable batteries. MF-SVS has initial resistance as low as 14 mOhms and protects Lithium and Ni-MH chemistry cells; MF-VS210N, for GSM battery packs, and MF-VS170N, for lower pulse current applications, have maximum voltage of 12 V, and maximum...

Read More »
SPDT Relay fits in small places.
Switches

SPDT Relay fits in small places.

Slim PCH series relay minimizes need for board space. It has silver-tin oxide contacts in form C (SPDT-NO) arrangement. Normally open contacts are rated at 5A resistive at 277 Vac or 30 Vdc, while normally closed contact set is rated for 3 A. DC coils are available for 5-48 V and nominal coil power requirement is 400mW. Relays are UL recognized, CSA certified and VDE approved. Applications...

Read More »
Battery Protection IC provides over-current detection.
Protectors

Battery Protection IC provides over-current detection.

S-8243A/B Series incorporates battery protection circuits, battery monitor amp, and voltage regulator, reducing board space requirements. 3-serial and 4-serial cell LI-ION ICs have 3 levels of detection: over-charge (+/- 25 mV), over-discharge (+/- 80 mV) and over-current (+/- 25 mV). Applications include notebook computers, hand-held scanners, and other portable electronic devices that use...

Read More »
Leveling Mounts are wash-down and acid-resistant.
Mounts

Leveling Mounts are wash-down and acid-resistant.

Airloc Jackmount® Adjustable PR Series machine leveling mounts are available with rubber or neoprene vibration isolation pads from 40 to 90 durometer with smooth non-skid surfaces. Rubber or neoprene pads come in 5, 10, 15, and 25 mm thicknesses. Offered in all stainless steel or thermoplastic bodies, mounts provide spherical support with ±4 deg range of motion. Available in...

Read More »
Step Motors are suited to multiple applications.
Motors

Step Motors are suited to multiple applications.

Two-phase, 24-step P110 series miniature step motors are 0.63 in. in diameter and 0.75 in. long with holding torque ratings of 1.0 oz-in. Disc-magnet technology results in rotor inertia of 5.7 x 10E-06 oz-in-sec squared. Phase current in disc-magnet motors may be boosted up to 1.5-times nominal for P110. Construction includes magnetic circuit and samarium-cobalt magnet.

Read More »
Gearmotors suit side-broom motors in floor care machines.
Motors

Gearmotors suit side-broom motors in floor care machines.

Right-angle MC 143 series gearmotor units offer sealed gearbox assemblies. Construction includes aluminum die-cast housings; all ball bearing design; metallic gearing with hardened, ground-steel worm; and forged-bronze gears. Units are available with 12-48 Vdc permanent-magnet motors, which deliver up to 800 in-lbs of intermittent torque. Applications include recreational vehicles with slide-out...

Read More »

All Topics