Electrical Equipment & Systems

Electrical Connectors

Card Connector supports 10 Gbyte Ethernet standard.

70-pin pcb-mounted edge card connector supports 10 Gbyte family of Z-axis pluggable transceivers. It offers alignment posts for stable placement on pcb and standoffs for pcb post-solder cleaning. SMT design provides option for connector placement on either side of pcb. Connector will support all of transceiver variants noted in MSAs (850 Nm serial, 1310 Nm serial, 1310 WWDM and 1550 serial...

Read More »
Power Supplies

Power Supplies are designed for 600 watt applications.

EK Series Power Supplies offer voltage range from 1 to 60 kV in 3.5 in. high rack mount units. They feature air-insulation technology, where air is used as primary dielectric medium rather than silicon rubber, epoxy or oil. Arc sensing and quench circuitry suppress arcing conditions that can occur regularly in high voltage applications, and provide safety and protection for power supply and...

Read More »
Switches are suitable for hand-held electronic devices.
Switches

Switches are suitable for hand-held electronic devices.

Toggle, rocker and slide switches includes miniature, sealed, and subminiature versions. They feature choice of actuators, bushings, and mounting configurations for panel or PCB mounting. Available with silver or gold contacts, switches can be used in power or low level, dry circuit applications. Toggle, rocker and slide switches meet requirements for markets including: test and measurement...

Read More »
One-Handed Clamp uses self-restraining technology..
Clamps

One-Handed Clamp uses self-restraining technology..

Adelok® helps assemble clamped components by holding itself closed and in place during installation. It is suitable for rapid clamp assembly and improved stacking methods for fluid lines and hoses, wire bundles, power cables and fire detection sense lines. Juggling of fasteners, standoffs, washers, ties and grommets is eliminated. Clamp can handle payloads of 0.062 to 3.50 in., and can be...

Read More »
Plug-in Transducers reduce installation time.
Sensors / Detectors / Transducers

Plug-in Transducers reduce installation time.

786 Series transducers can convert 0-10 V or 4-20 mA signals into isolated 0-10 V, 0-20 mA, or 4-20 mA signal with isolation rating of 4kV. It can be plugged directly onto terminal block assembly using base receptacle blocks that are 15, 20, or 25 mm wide. Modules are protected against mismating and can be replaced in single operation during maintenance without affecting wiring. Touchproof test...

Read More »
Transformers operate at 90% efficiency,
Transformers

Transformers operate at 90% efficiency,

High efficiency R-Core transformers have silicon steel cores with two matched bobbins on each side that cancel each other's magnetic flux field, so countermeasures to reduce leakage flux are not needed. Transformers are 30% smaller, 30% thinner and 40% lighter than EI type transformers. Applications include office, A/V, CATV, and electronic equipment. Sizes are available from 5VA to 1000VA.

Read More »
Audio Jacks are available with 4, 5 or 6 conductors.
Connectors

Audio Jacks are available with 4, 5 or 6 conductors.

Suitable for portable devices, information technology applications, and small products requiring additional signals for sensing or control, these audio jacks provide additional conductors in small package size. Both 2.5mm and 3.5mm input sizes are available in thru-hole and surface mount options. All have minimum life of 5,000 cycles and are made from UL94VO materials.

Read More »
Shielded Connector minimizes electrical interference.
Connectors

Shielded Connector minimizes electrical interference.

Micro-Link connector has 360° aluminum mylar foil shield to minimize electrical interference that can disrupt signal from connector to control device. Gold-plated contacts provide long life, improved conductivity, and corrosion resistance. Rated NEMA 6P and IP 68, connectors can be used for quick disconnect of proximity sensors, photoelectric sensors and switches, hydraulic and pneumatic...

Read More »
Tough Pushbuttons resist vandals and the environment.
Switches

Tough Pushbuttons resist vandals and the environment.

Series 76-95 sealed pushbutton switches are made of stainless steel with vandal-resistant chrome button and bezel. Button only protrudes 0.10 in. from front panel, making it difficult for vandals to pry switch from its mounting. Switches can also withstand impacts of significant force. Snap-in switch elements are UL listed and CSA certified, have silver or gold contacts with current-carrying...

Read More »
Direct Drive Motor comes in two parts.
Motors

Direct Drive Motor comes in two parts.

Brushless ULT frameless motor has separate rotor and stator that can be integrated into precision mechanical assemblies. Low profile motor has axial lengths as small as 10 mm, diameters up to 165 mm, and through holes up to 120 mm, making it suitable for direct drive rotary applications. Models are available with 30 to 600 oz-in of torque output. Its three phase motor will run on any sinusoidal...

Read More »

All Topics