New Electrical Equipment & Systems Products

Step-Down DC/DC Converter includes linear controller.

Housed in 3 x 3 mm DFN-12 package, Model LT1939 operates from VIN range of 3-25 V, making it suited for regulating power from variety of sources, including protected automotive batteries, industrial supplies, and unregulated wall adapters. Unit's 2.3 A internal switch delivers up to 2 A continuous output current at voltages as low as 0.8 V. Switching frequency is user programmable and...

Connector System optimizes data rates.

Designed for differential, high-speed signal transmission in telecom applications, ERmet ZD+Ã-® board-to-backplane connector system enables data rates of more than 20 Gbit/s. Four-pair, right-angle female connector features pressfit termination and is mating-compatible to existing ERmet ZD male connector, so existing backplane designs do not require layout changes on backplane side. For...

Step-Down DC/DC Converter offers three 800 mA outputs.

Supplied in 16-lead, 3 x 3 mm QFN package, LTC3545 synchronous buck regulator uses constant frequency current mode architecture and operates from 2.25-5.5 V input. It can generating output voltages down to 0.6 V and has 2.25 MHz switching frequency that enables use of ceramic capacitors and inductors less than 1 mm high. Internal synchronous switches offer efficiencies to 95%, and Burst...

Receiver Module bridges gap between RF and digital.

Leveraging uModule(TM) packaging technology, Model LTM9001 IF/baseband receiver subsystem includes 16-bit ADC sampling up to 160 MS/sec, anti-aliasing filter, and fixed gain differential ADC driver. Semi-customizable device can be configured for various sampling rates, and ADC driver can be substituted for fixed gain versions ranging from 8-26 dB. Anti-aliasing filters can also be configured as...

Inventory Management Services

This white paper provides an overview into the benefits, approaches and considerations for inventory management services.

Step-Down DC/DC Converter is offered in 3 x 3 mm DFN package.

Model LT1913 3.5 A, 25 V step-down switching regulator operates within VIN range of 3.6 to 25 V. It features 4.6 A, 95 mW internal switch that can deliver up to 3.5 A of continuous output current at voltages as low as 0.79 V at up to 90% efficiency. Switching frequency is user programmable from 20 kHz to 2.4 MHz and converter features external synchronization from 250 kHz to 2 MHz. Unit operates...

Leak Detection Relay monitors 2 submersible pumps.

Used to monitor shaft seal of pumps before failure, Series DLD dual-channel leak detection relay finds leaks by sensing status of float or conductivity switch installed in seal cavity. It offers NO relay contacts to energize alarm and deenergize pump in event of leak and includes LED indicator. Installed via 2-pin octal mount, unit is available in sensitivities of 10-25 kW adjustable and 4.7-100...

Analog IC includes adjustable resistor technology.

Incorporating low-noise operational amplifiers with rejustors, Model MBSTC-02 connects directly to piezo-resistive sensors to provide signal conditioning, analog calibration, temperature compensation, and amplification. Adjustment process is isolated from signal path and is performed in-circuit, after assembly and packaging. Operating over temperature range of -40 to +125Ã-

Media Player IC supports high-definition audio.

With less than 5 mW power consumption, Model AS3532 is based on audio engine and audio post-processor, which act as co-processors to ARM central programmable unit. Audio engine executes decompression and playback of compressed audio formats, while audio post-processor, supporting 192 kHz sample rates at 24 bits dynamic range, implements ASRC, multi-channel mixer, and 10 bands graphics equalizer....

STMicroelectronics Introduces World's First 24-Bit Audio DAC with Playback Time Extender Technology for Mobile Music Applications

Single-chip solution includes ST's innovative PTE(TM) (Playback Time Extender) function, reducing system power consumption for longer music playback time, plus on-chip power management enabling direct connection to battery GENEVA, Jan. 30 -- STMicroelectronics (NYSE:STM) today announced a very high performance 24-bit audio DAC (digital to analog converter) that is intended for the mobile music...

Molex Incorporated Showcases I-Trac Orthogonal and QSFP Interface At DesignCon 2008: Molex Booth 511

Molex I-Trac Orthogonal The I-Trac(TM) backplane connector system from Molex Incorporated is a broadside-coupled, skew-equalized, 12.5 Gbps solution. It is designed for both traditional backplanes and orthogonal architectures, which eliminate the need for signal traces routed through the midplane. The I-Trac system utilizes common header and daughtercard components allowing design engineers...

Trotec Laser Offers Customizable Industrial Laser Marking Solutions for Any Application

Trotec's laser marking solutions provide your company with configurable workstations and intuitive, customizable software. Check out our video to learn more.