New Electrical Equipment & Systems Products

DC/DC Controllers achieve efficiencies up to 96%.

Suited for boost, flyback, SEPIC, and inverting power supply applications, Models LT3757 and LT3758 can generate positive or negative regulated output voltage by incorporating 2 internal voltage feedback error amplifiers and reference voltages. Model LT3757 operates with input voltage of 2.9-40 V while Model LT3758 operates over 5.5-100 V input range. H and MP-grade versions are guaranteed to...

Gigabit Ethernet Switches feature extended temperature range.

Featuring Green Power Saving technology, Husky HUG-625GE-PS and HUG-626GE-PS provide 6 x 10/100/1000Base-T(X) Ethernet ports and 2 multi-mode 1000SX or single-mode 1000LX fiber ports. Units support 12-48 Vdc or 18-30 Vac power input with reverse polarity protection, 3,000 Vdc EFT protection for power line, and 6,000 Vdc Ethernet ESD protection. Operating from -40 to 80Ã-

Patch Cord facilitates conversion from 10G to 100G Ethernet.

Because 100GBASE-SR10 Ethernet multimode fiber electronics utilize 24-fiber connector, dual 12-fiber MTP to 24-fiber MTP 100G Migration Patch Cord eliminates need for re-cabling in 100G-ready 12-fiber systems. ANSI/TIA-568-C.3-compliant unit features flexible round cable and CorningÃ-® ClearCurveÃ-® multimode fiber. Cord meets polarity requirements of IEEE 802.3ba, 40/100G Ethernet...

Cable Pull Switch isolates power in case of shut-downs.

Supplied in die cast aluminum housing rated to IP67, Series CPS can isolate power to conveyor system or other similar process equipment in case of shut-down condition. Steel wire is placed along side of conveyor and attached to cable pull switch. When cable is pulled at any point along conveyor, it will trip cable pull switch and cause conveyor to shut down. Manual reset of CPS is required to...

Construction Materials for the Future

In this eBook, we highlight some key advantages of Cross-Laminated Timber (CLT) and show why every builder needs to consider adopting this remarkable construction advancement. We'll also introduce you to the latest innovation in CLT, GRIPBlock™, an exciting new technology that will change the way you look at CLT forever.

Integrated RF Circuits suit broadband communications systems.

Operating from 100-2,500 MHz, ADRF6655 active mixer integrates fractional-N PLL synthesizer, VCO, and associated LDO regulator circuits. It operates on single +5 V supply and is intended for up- and down-conversion applications. As 2-channel, fully-differential baseband signal processing solution, ADRF6510 integrates matched pair of fully differential low-noise and low-distortion programmable...

Boost/Inverting DC/DC Converter integrates fault protection.

Offered in 14-pin, 4 x 3 mm DFN and 16-lead MSE packages, LT3581 uses 2 integrated 42 V switches - 1.9 A master and 1.4 A slave - that can be tied together for total limit of 3.3 A. Current mode, fixed frequency step-up DC/DC converter operates from 2.5-22 V input, with transient protection to 40 V, and can be configured as boost, SEPIC, or inverting converter. Along with efficiencies up to 88%,...

Equalizing Cable Transceiver supports 1-10.5 Gbps data rates.

Integrating equalizer, limiting output amplifier, and pre-emphasis cable driver, Model PHY2210 handles 10 G data rates running over 15 m of 24 AWG twin ax cable. Unit requires single 3.3 V supply and can operate over temperature range of -40 to +85Ã-

Active Equalizer/Retiming Driver IC suits copper cable applications.

Model PHY1066 includes programmable pre-emphasis designed for 10 Gbps active copper cable applications. Fitting inside XFP or SFP+ MSA connector, 5 x 5 mm, low-latency IC transmits up to 20 m across 24 AWG twin-axial copper cable, and can be used up to 10 m across 30 AWG cable. It also has loss of signal and loss of lock alarms for monitoring host controller. Unit can be accessed via selectable...

Active Equalizer and Retimer IC offers programmable pre-emphasis.

Supplied in 5 x 5 mm package, PHY1068 is designed for extended reach in 8.5 Gbps backplane and copper cable applications. Integrated input AGC stage lends to sensitivity suited for noise limited links, while equalizer enables extraction of data from signals degraded by dispersion or reflections typical of backplane environments. Along with auto detect 2-wire or SPI MCU interface, features include...

Server Load Balancer provides 4 GbE ports.

Featuring integrated SSL acceleration and Layer 7 content switching, LoadMaster 2200 intelligently distributes user traffic among web and application servers. Unit provides 99.999% high-availability of application servers and removes SLB as single point of failure. With 950 Mbps throughput and up to 200 SSL TPS, balancer ensures users maintain continuous connections with specific server where...

Trotec Laser Offers Customizable Industrial Laser Marking Solutions for Any Application

Trotec's laser marking solutions provide your company with configurable workstations and intuitive, customizable software. Check out our video to learn more.