Controller suits AdvancedTCA and MicroTCA platforms.

Based on Wintegra Winpath2 Processor technology, Model ATMIV AdvancedMC broadband communication controller offers 4 OC3/STM-1 or 2 OC12/STM-4 trunks and is suitable interface to process ATM and IP signaling and bearer traffic. Board and driver provide AAL2/5 to UDP/IP interworking, IP routing and forwarding over ATM, AAL2, and AAL5 termination, and AAL2 and AAL5 switching. High bandwidth carrier...

Read More »
Microcontrollers facilitate upgrade migration.

Microcontrollers facilitate upgrade migration.

Offering pin-for-pin compatibility, Flexis(TM) series includes 8-bit MC9S08QE128, based on S08 core with up to 128 KB Flash, and 32-bit MCF51QE128, based on ColdFireÂ-® V1 core. Products can run off of external 32 kHz oscillator that consumes under 1 Â-µA of current, and internal voltage regulator enables 6 Â-µsec wake-up from stop modes. Along with stop modes offering minimum current...

Read More »
Location Detection SoC is designed for ZigBee-® networks.

Location Detection SoC is designed for ZigBee-® networks.

Supplied in RoHS-compliant 7 x 7 mm QLP-48 package, CC2431 System-on-Chip (SoC) features hardware location engine targeting low-power ZigBeeÂ-®/IEEE 802.15.4 wireless sensor networking applications. Device is supported by TI Z-Stack(TM) protocol stack and combines CC2420 RF transceiver core with 8051 MCU, up to 128 KB flash memory, and 8 KB RAM. RSSI-based location engine calculates node...

Read More »

Motorola's WiMAX and Mesh Solutions Earn NXTcomm Eos Awards

Award recognizes companies with cutting-edge technology solutions ARLINGTON HEIGHTS, Ill., June 21, 2007 // - Motorola (NYSE: MOT) today received awards for two of its MOTOwi4(TM) wireless broadband products in the inaugural competition of the NXTcomm Eos Excellence of Achievement Award. Motorola's WiMAX Flexible Access Point System won in the Technology Innovation Group: Access Networking...

Read More »
Considerations for Choosing a Plastic Injection Molder
Sponsored

Considerations for Choosing a Plastic Injection Molder

Choosing a plastic injection molder is no small decision. There are a number of factors that play into your selection, and it's important to consider them all to ensure you find the plastic injection molding company that suits your unique needs. This eBook is your guide to identifying those factors to help you make an informed decision.

Read More »

Freescale Unveils Radio Frequency Technology to Revolutionize Control of Home Entertainment Devices

Robust RF entertainment control platform designed to leapfrog infrared controls and provide de facto consumer electronics standard ORLANDO, Fla. (Freescale Technology Forum) - June 25, 2007 - Freescale Semiconductor is changing the dynamics of the consumer electronics market by introducing radio frequency (RF) technology designed to revolutionize the way consumers remotely control their home...

Read More »

Flash Microcontrollers are suited for portable applications.

Featuring ARMÂ-® Cortex(TM)-M3 core and 32-128 K of embedded Flash memory, Models STM32F103 and STM32F101 32-bit MCUs offer 72 and 36 MHz clock frequency, respectively. Products operate from 2.0-3.6 V power supply and consume down to 2 Â-µA in standby mode with reset circuitry active. Peripheral set includes 128 Kb embedded flash, 20 KB RAM, 2 ADCs, 3 USARTs, 2 SPI, 2 I2C, three 16-bit...

Read More »
Power Controllers are designed for notebook PCs.

Power Controllers are designed for notebook PCs.

Models NCP5371, NCP5218, and NCP5215 address notebook power subsystem needs for Vcore, DDR memory, and CPU chipsets, respectively. Available in Pb-free QFN-48 package, dual-edge, 2-phase Model NCP5371 features current mode variable frequency architecture. Combining PWM controller for VDDQ supply with VTT linear regulator, Model NCP5218 comes in Pb-free QFN-40 package. Dual channel buck controller...

Read More »

Microcontrollers offer 40 MIPS performance.

Available in 6 x 6 mm packages, Series PIC24HJ12 16-bit microcontrollers feature peripheral pin select, which allows designers to remap digital I/O to optimize board layout. Additional features include 12 Kb Flash, 1 Kb RAM, 1 UART, 1 SPI, 1 I2C(TM) port and A/D Converter with 10 channels and user-selectable 10- or 12-bit mode. Model PIC24HJ12GP201 comes in 18-pin SOIC and SDIP packages, while...

Read More »

Door Controller is powered by the Ethernet.

RCM III(TM) with PoE offers door strike capabilities for securing remote entryway access control in airports, hospitals, corporate buildings, industrial plants, schools, and government facilities. Door controller enables new and retrofit sites to supply power to new door readers, door controllers, and door strikes via building's Ethernet. Unit is compliant with IEEE 802.3af standards.

Read More »

Boost Controller regulates output voltages up to 60 V.

Featuring 1 W dual n-channel MOSFET gate drivers, Model LTC3814-5 eliminates heat sink and can regulate 24 V at 4 A output with up to 97% efficiency from 4.5-14 V input source. Synchronous, step-up switching regulator controller utilizes current mode control and maintains Â-

Read More »

All Topics