Communication Controller serves high-density applications.

Featuring 8 T1/E1/J1 interfaces, iSPAN-® 3640 supports SS7 MTP2, ATM AAL5, SSCOP, and SSCF protocols; up to 248 SS7 Low Speed Links; 8 High Speed Links; or 248 media channels. This AdvancedMC(TM) T1/E1/J1 Controller, designed for ATCA and -µTCA platforms, optimizes system slot usage and provides intelligent interfaces for application platforms that need to connect to TDM/ATM networks....

Read More »

Nippon Pulse to Showcase Products at ATX West

Motion Control Specialist Highlights Stepper and Linear Shaft Motors RADFORD, VA -- For the third consecutive year, Nippon Pulse, a leader in the motion control industry, will be exhibiting its products at the ATX West tradeshow at the Anaheim Convention Center in Anaheim, CA. Dates of the events are February 9-11, 2010. Nippon Pulse will be displaying its products in booth 4171, which is located...

Read More »

I/O Controller enables USB 3.0 to SATA data transfer.

Single-chip VIA VL700 USB 3.0-SATA Controller allows users to connect SATA hard disk drive, solid state drive, and optical disc drive devices to PC via USB 3.0 specification ports. Product supports both SATA 3 Gbps and 1.5 Gbps data transfer rates as well as Native Command Queuing, which allows HDDs/SSDs to internally optimize order in which received read and write commands are executed. Data...

Read More »

Networking Card bridges cell- and circuit-based networks.

Based on Wintegra(TM) WinPath2(TM) on-board network processor, iSPAN-® 3650 AdvancedMC(TM) (AMC) Quad OC-3c/STM-1 ATM-IP Interworking Card can support 64,000 ATM PVCs (Permanent Virtual Circuits), 1 M/s AAL2 CPS packets, and 50,000 Active CIDs supported for AAL2 PVCs. When combined with Interworking application, it becomes integrated gateway on AMC designed to support OC-3c/STM-1 interfaces in...

Read More »
Wireless MCU supports ZigBee PRO applications.

Wireless MCU supports ZigBee PRO applications.

Model JN5148 wireless MCU is designed for wireless sensor networking applications based on IEEE802.15.4 standard. It includes 32-bit RISC processor, up to 32 MIPs performance, 2.4 GHz transceiver, 128 kB ROM, and 128 kB RAM to support networking protocol stack and user application on-chip. Unit integrates power management and has operating current consumption of 18 mA when receiving and 15 mA...

Read More »
Gas Management System offers fully automatic operation.

Gas Management System offers fully automatic operation.

Featuring onboard web server and embedded software, IntelliSwitch II(TM) Gas Switchover allows remote monitoring, secure system configuration, and e-mail notification of real-time system status and events. System offers continuous pressure and flow control from liquid or high pressure cylinder sources. It includes NO/NC relay contacts for alarm outputs; internal, switch-settable input ac power...

Read More »
DMC-12x0 - PC/104 Optima Motion Controllers, 1-8 Axes

DMC-12x0 - PC/104 Optima Motion Controllers, 1-8 Axes

For new applications, Galil recommends the new generation, Accelera series DMC-18x6 PCI controllers. The DMC-12x0 PC/104 bus motion controller is a member of the Optima Series, Galil's prior-generation, multi-axis motion controllers. Designed to fit in an embedded PC/104 system, the DMC-12x0 controller accommodates 1- through 8-axis formats and allows control of step or servo motors on any...

Read More »
DMC-18x0 - PCI Optima Motion Controllers, 1-8 Axes

DMC-18x0 - PCI Optima Motion Controllers, 1-8 Axes

For new applications, Galil recommends the new generation, Accelera series DMC-18x6. The DMC-18x0 PCI motion controller is a member of the Optima Series, Galil's prior-generation, multi-axis motion controllers. The DMC-18x0 controller accommodates 1- through 8-axis formats and allows control of step or servo motors on any combination of axes. Any mode of motion can be programmed including linear...

Read More »

Compressor Controller operates according to air demand.

Designed to monitor, control, and optimize compressed air system, FOCUS Controller uses pressure sensor to control whether requested pressure within compressor station has been achieved. User can preset min/max pressures and control operation according to demand. In addition to remote On/Off facility and local/remote control via key switch, controller includes backlit LCD that shows...

Read More »

Lighting Control Panel features 16 schedules and 16 zones.

Incorporating remote-operated circuit breaker and microprocessor controller, A-Series enables automatic, scheduled lighting control or override control based on real-time needs. Panel integrates with native BACnet and Modbus RTU/TCP protocols and allows users to establish and manage load priorities and perform load shedding on command. It also enables daylight optimization for harvesting...

Read More »

All Topics