Ultra Low Power Microcontrollers leverage 130 nm technology.

Ultra Low Power Microcontrollers leverage 130 nm technology.

Based on ARMÂ-® Cortex(TM)-M3 processor, 32-bit STM32L Series offers 33 DMIPS at 32 MHz and integrated Flash densities from 64-128 KB. Units include features that promote safety and data security, such as Brown-Out Reset, onboard Flash with ECC support, Memory Protection Unit, and JTAG fuse. Part of EnergyLite(TM) platform of products that optimize battery life, microcontrollers provide 6...

Read More »
Bulkweigh Controller works with scale automation system.

Bulkweigh Controller works with scale automation system.

Designed for use with oneWeigh scale automation system, oneWeigh 780 Bulkweigh Controller provides control of hopper system and calculations needed for accurate target weights and rapid draft cycles. Unit connects to PC workstation via Ethernet, enabling operation from any workstation on network and remote diagnostics via Internet. Also able to connect to plant control systems, NTEP-certified...

Read More »
Siemens to Build Combined Cycle Power Plant in the Netherlands

Siemens to Build Combined Cycle Power Plant in the Netherlands

Erlangen (Germany), April 16, 2010 - Siemens Energy has received an order from the Netherlands for turnkey construction of a combined cycle power plant. Purchaser of the 435-megawatt Hemweg 9 plant is the Dutch utility Nuon, a subsidiary of Vattenfall A.B. A long-term maintenance agreement was also signed. The plant, which will attain a very high efficiency level of approximately 59 percent and...

Read More »

WattStopper Controls Contribute to 40% Energy Savings in Kaiser Permanente Warehouse

SANTA CLARA, CA April 2010 - Kaiser Permanente installed WattStopper lighting controls as part of a warehouse renovation designed to improve lighting and reduced energy consumption. The upgrade resulted in better task lighting throughout the facility and energy savings of over 40%, as detailed in the following case study. Managers of a 350,000 square foot Kaiser Permanente distribution warehouse...

Read More »
Overvoltage/Overcurrent Protection IC negates input surge damage.

Overvoltage/Overcurrent Protection IC negates input surge damage.

To safeguard low-voltage, portable electronics from damaging input voltage transients and current surges, LTC4361 utilizes 2% accurate 5.8 V threshold to detect overvoltage event and respond within 1 Â-µs (max) to isolate downstream components from input. Overvoltage protection of up to 80 V can be achieved without additional external components. Additionally, this 2.5-5.5 V IC/MOSFET...

Read More »

SATA DAS Controller supports real-time encryption.

With over 80 MBps write performance, OXUFS944SE direct attached storage (DAS) controller bridges eSATA, FireWire, or USB 2.0 interface to single HDD. Silicon is complemented with application firmware, which includes secure, real-time eSATA encryption. Also included, flexible cipher engine provides real-time, on-the-fly encryption/decryption of data that adheres to AES. Typical power consumption...

Read More »

Reference Starter Kit is based on mixed signal FPGAs.

Module Management Controller Board Management Reference Starter Kit is based on SmartFusion(TM) intelligent mixed-signal FPGAs, which integrate board-specific logic into SmartFusion chip. System's analog processing with zero load on processor supports xTCA-aware analog sensor monitoring. Also included is benchtop management controller development board, which inserts into any compliant AMC slot....

Read More »
Hardware and Software System extends lifecycle of gas wells.

Hardware and Software System extends lifecycle of gas wells.

Designed to run in all SCADAPack 4203 gas flow computers and 300-Series controllers, SCADAPack ProductionPLUS combines Electronic Flow Measurement and plunger lift for 30+ wells per pad. Solution offers distributed intelligence and extensive data analysis, providing gas operators with wireless or wired Sensor-to-Enterprise application. Offering Windows-based PC environment, SCADAPack...

Read More »

Emerson to Install Ovation(TM) Expert Control System at Pakistan's New Halmore Combined-cycle Power Plant

Emerson selected by Descon Engineering Company Ltd., believed to be the first Pakistani company to secure EPC contract for a combined-cycle plant PITTSBURGH - Emerson Process Management announced today that it has been selected to install its Ovation(TM) expert control system at the Halmore Power Plant, a new 225-MW combined-cycle power generating facility in Bhikki, located in the geographic...

Read More »
New DC Brushless Control Receives Design Award

New DC Brushless Control Receives Design Award

DESIGN NEWS has awarded the Dart BLM700 with a BEST NEW PRODUCT- FINALIST for 2010 in the Motion Control / Automation category. DN's Golden Mousetrap Awards highlight the best and brightest engineering innovations of the past year, as well as creativity in product design . This is the second consecutive year a Dart product has been selected a New Product Finalist (in 2009 the MD PLUS Series was...

Read More »
Precision Machining Solutions with Over 25 Years of Experience
Sponsored

Precision Machining Solutions with Over 25 Years of Experience

Quality, customer service, and unbeatable value are the hallmarks of Hogge Precision. Since 1989 we have built a reputation as the go-to precision machining source, servicing many demanding industries. For CNC machining and screw machining, there are few manufacturers that can match our capabilities and expertise. See our video to learn more.

Read More »

All Topics