Control Cable works in wet conditions.

Control Cable works in wet conditions.

Flexible, multi-conductor OLFLEXÂ-® Auto-I cable, with high stranding and PVC jacket, is suitable for use in dry, damp, and wet conditions, as well as direct-burial applications. It can withstand temperatures up to 90Â-

Read More »
Unshielded Cable exceeds SCSI Ultra 320 specifications.

Unshielded Cable exceeds SCSI Ultra 320 specifications.

U320 SCSI NexZ0(TM) cable consists of 34 twisted pairs with 30 AWG stranded primaries, designed for internal point-to-point or daisy chain SCSI assemblies. Round construction allows easy routing within box and increases air flow over flat equivalents. Differential impedance is 120 ohms Â-

Read More »
Cabling Equipment suits wire raised floor installations.

Cabling Equipment suits wire raised floor installations.

Products for pedestal cabling applications include CADDY CableCat(TM) J-Hooks with 3/4, 1 5/16, 2, and 4 in. dia loops and retainers; CableCat 425 wide-base cable supports that hold up to 425 four-pair cables; and CableCat pulley for cable pulling. Signal Reference Grid Clip provides quick attachment for grounding systems.

Read More »
Category 6 Cable transmits 10 billion bits/sec.

Category 6 Cable transmits 10 billion bits/sec.

CatLink 6 Plus exceeds TIA/EIA current draft requirements for Category 6. It has been tested to 500 MHz, or twice the 250 MHz frequency TIA requirement, and is capable of 1,000 MHz speed. Cable has dielectric spacer, ripcord, and sequential footage markings. It is available in variety of standard jacket colors. UL listed for general purpose, riser, or plenum applications, cable is ETL verified...

Read More »

Plenum Cable meets fire safety standards.

Limited Combustible-rated (CMP-50) Unshielded Twisted Pair Cable is jacketed and insulated with FED fluoropolymer and has been tested by Underwriters' Laboratories to meet requirements for lower smoke emissions and less flame spread.

Read More »
RF Attenuation Cable works in high voltage applications.

RF Attenuation Cable works in high voltage applications.

Quiet Line continuously extruded low pass filter provides RF power attenuation. It can be spliced onto existing high voltage lead, or supplied as assembly with or without silicone rubber coating. Its continuous thin wall coating is applied over FEP or PFA jacket. Coating allows user to achieve dielectric bond when potting or encapsulating with compatible silicone material. Cable is offered...

Read More »
Custom Cable Assemblies are built to customer specs.

Custom Cable Assemblies are built to customer specs.

Cable assemblies can combine multiple technologies, including plastics injection molding, over-molding, potting of devices, and wire sizes from 10 to 32 gauge. UL, CSA, and VDE approved, cable assemblies can range from single conductors up to 50 pairs, with mylar, foil, braid, copper shielding, and jacketing made from PVC, SJT, SJTO, SVT, and other materials. Active and passive components,...

Read More »
Dual Zip Cable combines 5e and shielded coax cable.

Dual Zip Cable combines 5e and shielded coax cable.

CatLink Dual Zip 24/4 pair Category 5e UTP cable is tested to 200 MHz and coupled with quad shielded RG-6 coaxial cable tested to 2.4 GHz. Another version is available that uses dual shielded coaxial cable consisting of foil and 60% braid. Design speeds cable installation and connector termination, while exceeding requirements for Grade 1 cabling of TIA/EIA-570-A Residential Telecommunications...

Read More »
Microwave Test Cables operate up to 65 GHz.

Microwave Test Cables operate up to 65 GHz.

Internally ruggedized PHASEFLEX(TM) microwave coaxial assemblies combine electrical advantages of expanded PTFE dielectric with environmental protection. Cable has one in. minimum bend radius without affecting the cable performance, and has virtually no springback. Assemblies are suitable for production test applications, locations where test area is not in vicinity of equipment, or vector...

Read More »
Test Assemblies range from DC to 65 GHz.

Test Assemblies range from DC to 65 GHz.

PHASEFLEXÂ-® Assemblies are crush-, torque-, kink-, and fluid-resistant. They are also dust- and dirt-proof with ergonomic/ruggedized boot strain reliefs. Standard connectors include SMA, TNC/PTNC, Type N/Precision N, 7 mm, 7-16, 3.5 mm, 2.92 mm (K style), 2.4 mm, 1.85 mm (V style). Assemblies are suitable for production testing, antenna range testing, thermal vacuum chambers, and remote...

Read More »

All Topics