Circuits

Microcontrollers suit home appliances and factory automation.

Microcontrollers suit home appliances and factory automation.

Based on ARMÂ-® CortexÂ-®-M4F processor, Models TMPM470FDFG and TMPM475FDFG can operate at up to 120 MHz. Both MCUs incorporate 2 modules, each containing programmable motor driver, 12-bit AD converter, and Vector Engine technology, which consists of hardware-based vector control processor for motor control applications. In addition, TMPM475FDFG incorporates CAN controller. Housed in 14 x...

Read More »
Cell Balancing IC supports monolithic supercapacitors.

Cell Balancing IC supports monolithic supercapacitors.

Integrating over 20 discrete components required for supercap cell balancing on single chip,Â- Model BD14000EFV-C promotes expansion of energy regeneration applications in industrial equipment, automotive start-stop systems, and voltage sag countermeasures. Detection is enabled for 4–6 cells, and cell balancing voltage can be set from 2.4–3.1 V, ensuring support for variety of supercaps....

Read More »

Transphorm and Fujitsu Semiconductor Announce the Start of Mass Production of Transphorm's GaN Power Devices

Production at CMOS-compatible fab enables GaN to meet the increasing demand of the market GOLETA, Calif.,Â-  -- Transphorm Inc., Transphorm Japan Inc., and Fujitsu Semiconductor Limited announced today that Fujitsu Semiconductor group's CMOS-compatible, 150mm wafer fab in Aizu-Wakamatsu, Fukushima, Japan, has started mass production of Gallium Nitride (GaN) power devices for switching...

Read More »

Power MOSFET Drivers come in thermally efficient, small packages.

OfferedÂ- inÂ- SOT-23 and 2 X 2 mm DFN packages, MCP14A005X and MCP14A015X feature driver architecture for high speed operation; fast transitions and short delay times allow responsive circuit operation. Low input threshold is compatible with Microchip PICÂ-® MCUs and dsPICÂ-® Digital Signal Controllers (DSCs) while maintaining noise immunity and hysteresis. Users can design...

Read More »
Quad SPST Analog Switches support wearable applications.

Quad SPST Analog Switches support wearable applications.

Housed in 1.4 x 1.4 mm WCSP package with 0.35 mm pitch and top-side lamination, 200 Ω Models DG2501, DG2502, and DG2503 save space in wearable electronics and sensors as well as consumer and communication devices. Monolithic switches provide low CD(OFF) of 2.6 pF, CD (ON) of 7.6 pF, charge injection down to -0.7 pC, and typical switch-on leakage current of 9 pA. Operating from single 1.8–5.5 V...

Read More »
Low-Noise Single Coil Fan Driver IC has built-in current limiting.

Low-Noise Single Coil Fan Driver IC has built-in current limiting.

Promoting energy efficient cooling system designs, 600 mA MLX90297 integrates Hall Effect sensor with 2 half bridge output stages. In addition to minimum speed setting, speed curve can be tuned via inclusion of one extra resistor. Soft start and soft switching mechanisms achieve optimal acoustic noise levels, as well as minimal vibration at higher speeds, without sacrificing max motor torque, and...

Read More »
Digital Controllers feature VR12/12.5 compliant interface.

Digital Controllers feature VR12/12.5 compliant interface.

Featuring single and dual phase outputs and supporting both PMBus and Intel’s VR12.5 Serial VID bus, Models PV3103, PV3104, and PV3202 provide precision regulation and telemetry to support servers, high-end desktops, and embedded computing systems. RoHS-compliant DC/DC controllers feature 0.6–1.52 V output and programmable frequency from 375 kHz to 1 MHz. Units offer Auto-ControlÂ-®...

Read More »

Winner Micro Participates in CES 2015 Successfully

At the just closed CES 2015, Beijing Winner Micro introduced the Low-power embedded WiFi SoC and related products in the IoT field to the whole world. The company was fruitfully successful during the four-day exhibition. LAS VEGAS - CES 2015 concluded concluded in Las Vegas on Jan. 9. More than 3,600 exhibitors and 170,000 audiences joined the largest exhibition in history. From the customer...

Read More »

3D Gesture Controller enables one-step recognition design-in.

SuppliedÂ- in 28-pin SSOP, GestICÂ-® MGC3030 offers simplified UI options toÂ- enable single-step design-in of 3D gesture recognition in consumer and embedded devices. On-chip 32-bit DSP executes real-time gesture processing, eliminating need for external cameras or controllers for host processing while permittingÂ- accelerated and more natural user interaction with devices....

Read More »
Dodge® Raptor Coupling Now Available in Three Larger Sizes
Sponsored

Dodge® Raptor Coupling Now Available in Three Larger Sizes

The Dodge Raptor coupling epitomizes the innovation and value that has made Baldor a world leader in industrial electric motors. For almost 100 years Baldor has been the go-to source for industries across the globe. The Raptor coupling is just one example of our dedication to engineered excellence and commitment to providing value and performance. See our video to learn more.

Read More »

All Topics