New Boards Products

Instrument Controller features touchscreen-operated GUI.

QScreen Controller(TM) is a C-programmable embedded computer powered by HC11 Motorola microprocessor. It features real-time multitasking operating system, hundreds of pre-coded device drivers, up to 1 M Flash, and 512 K RAM. Controller commands eight 8-bit A/D lines, 8 digital I/O lines, and 2 RS232/485 ports. It can host up to 7 stackable Wildcard(TM) I/O modules. Applications include scientific...

Digital I/O Boards offer 32-64 channels.

Series 1700 PCI Cards feature isolated digital input and output channels with protection up to 2,500 Vdc. All outputs keep last values after hot system reset and provide channel-freeze function that keeps current output status unchanged for each channel during operation. Most boards support Board ID function, which helps engineers identify and access each card during hardware and software...

Telecom Blade is based on PowerPC 750FX processor.

Katana(TM) 750v cPSB blade features 2 PTMC sites, 5 Ethernet channels, and CTBus/H.110 TDM interconnect. Unit combines 800 MHz processor with Marvell MV64360 system controller, which provides high-speed access to as much as 1 GB SDRAM and 128 MB of flash memory. PTMC sites, which support 32-bit PCI data transfers at 33 MHz or 66 MHz, are equipped with dedicated CTBus and RMII interfaces. Blade's...

PC Board offers gigabit speed communication.

Compatible with PCI bus configured PCs, Gigabit Fibre Channel (ANSI X3.230) Board enables communication at gigabit speeds for fiber optic and copper cable applications. It incorporates TLK1501 bi-directional, serial, point-to-point transceiver chip. Balanced, twisted pair Fibre Channel copper cables can be used for runs up to 200 m, and runs to 2 km are possible with fiber optic cables. Compact...

Heated Deck Panels

Heated Deck Panels: The playbook to how these snow-free walkways work for bridges, sidewalks, and platforms

PCI Cards feature 4096 Mbit on-board signal memory.

Supporting all logic families, Ultrafast UF7221 full-length PCI card provides maximum output rate of 40 MHz on 32 digital channels. Each 4 bit (nibble) can be programmed with different high and low output levels from -2 to +10 V in 10 mV increments to generate ECL, PECL, TTL, LVDS, LVTTL, CMOS and LVCMOS signals. Output rate of signals can be programmed from DC to the 40 MHz max output rate. A 6U...

Serial Port Board enables embedded system communications.

Emerald-MM-Opto PC/104 module offers 4 optically isolated serial ports with RS-232, RS-422, and RS-485 protocols, each of which is independently configurable for protocol and IRQ settings. Available in 2- or 4-port configurations, unit includes 24 digital I/O lines with programmable direction and user-configurable pull-up resistors. Product also features auto-flow control and 16C2850 UART chip...

PCI Card suits development and simulation applications.

PCI-compatible PCI-Altera-485 includes PLX9054 and Xilinx for initial loading of Altera, and DMA transfer of data into and out of FIFOs. Altera controls 40 programmable RS-485/LVDS transceivers and 12 TTL IO. Each RS-485 channel is programmable for direction, termination, and function. Eight Cypress 22393 PLLs support Altera providing ability to synthesize multiple reference rates. PLX 9054...

Analog Output Board suits PCI-based computers.

Model OMB-DAQBOARD-2004 offers four 16-bit 100 kHz analog outputs ranging from -10 to +10 V. Through use of Bus Mastering DMA, each D/A output can continuously output waveform, which can be read from PC RAM or file on hard disk. Program can asynchronously output value to either D/A for nonwaveform applications if D/A is not already being used in waveform output mode. Additional D/A channels can...

PCI Cards are compatible with old and new PCs.

Universal voltage, ARCNET PCI20U network interface modules are compatible with 3.3 V and 5 V computers. Six models link PCI and PCI-X bus compatible computers with ARCNET LAN. Units allow for jumperless configuration and plug-and-play functionality. Each 32-bit, 33 MHz bus card operates with NDIS driver or null stack driver in Windows environment. Two LEDs monitor network operation and bus access...

LED Alpha-Numeric Marquee has Ethernet interface.

Model EL-2800-902 consists of 24-30 characters wide unit with double-sided viewing. It displays alphabetic and numeric characters in 1 line of 4 in. text, static or scrolling. Firmware PP-2111-189 implements DF1CRC protocol, which makes it possible to use Allen-Bradley communication modules to connect marquee to ABEthernetIP or Controlnet networks.

Optimize Your Workforce with Weavix™ by PK Industrial

The Weavix™ platform takes productivity, quality, and visibility to a new level by providing better communication and real-time KPIs. Check out the video to learn more!