Picker enables cycle times of 0.6 to 1.0 sec.
Robots

Picker enables cycle times of 0.6 to 1.0 sec.

High Speed Picker (HSP) employs one actuator for 2 motions and enables cycle speeds up to 120 cycles/sec. Suited for handling small work pieces with work piece loads below 100 g, unit offers independently adjustable end positions for horizontal and vertical stroke. It is available in 3 sizes with Y and Z stroke ranges of 52-68 and 15-25, 90-110 and 30-45, and 130-170 and 50-75. Compact design...

Read More »
Control Module brings smart features to small vehicles.
Controls and Controllers

Control Module brings smart features to small vehicles.

Model CL-410 has 8 total inputs, including one frequency or digital input for load control functions, and 7 analog or digital inputs. As single board controller, it offers load shedding and safety interlock features to prevent damage from activity. It delivers proportional control to machine's hydraulics, controls starter and fuel solenoids, and manages interface to ignition key. Model CL-410...

Read More »
Lubricator Pen delivers single-drop precision.
Hand Held Lubricators

Lubricator Pen delivers single-drop precision.

Tri-Flow® Pin Point Lubricator Pen contains concentrated formula with petroleum oils, micron-sized Teflon® particles, and pressure additives that secure Teflon® for lasting lubrication. Suited for preventative and corrective maintenance, pen deposits film to reduce friction and wear, inhibit rust formation and corrosive buildup, and displace moisture, dirt, and contaminants....

Read More »
Temperature Control Unit is application-ready.
Controls and Controllers

Temperature Control Unit is application-ready.

ADAM-6000 series consists of optimized solutions with Ethernet communication interfaces. ADAM-6022 dual PID loop control module; ADAM-6015, 7-channel RTD input module; and ADAM-6018, 8-channel thermocouple input module provide temperature measurement and control solutions and include built-in web pages and web I/O to allow access to module status through web browser. Temperature modules support...

Read More »
Portable TCU provides independent temperature control.
Controls and Controllers

Portable TCU provides independent temperature control.

Suited for applications attached to central cooling systems, compact Model 426 Temperature Control Unit (TCU) permits separate cooling processes to run simultaneously from one cooling source. It combines microprocessor control, internal pressure regulation, and fluid mixing to deliver cooling water to equipment. Liquid-to-liquid heat exchanger cools down to 5°C above source water...

Read More »
Gas Ignition Control runs on 120 Vac, 50/60 Hz.
Controls and Controllers

Gas Ignition Control runs on 120 Vac, 50/60 Hz.

Model 35-73 Intermittent Pilot Gas Ignition Control is microprocessor-based and polarity insensitive. Featuring repeatable timing sequences, it provides TFI times up to 120 sec, single spark and sense and remote flame sense options, thermostat/power off and automatic reset options, and on-board diagnostics with LED output. CSA certified unit is suitable for controlling pilot and main gas valves,...

Read More »
Parking Shelters protect patrons from elements.
Buildings

Parking Shelters protect patrons from elements.

Pay and Display Shelters attract attention and encourage visitors to facilities such as municipalities, universities, and hospitals. They protect patrons, equipment, and currency and eliminate need for full-time parking attendants. Shelters are fabricated from structural steel tubing and arrive fully assembled. Each one comes with glazing, lighting, signage, and optional heating.

Read More »
Laser Driver handles medium reach optical communications.
Controls and Controllers

Laser Driver handles medium reach optical communications.

Suited for Vertical Cavity Surface Emitting Laser Diodes, 3.2 Gbps Model LTC5100 maintains very low noise transmission eye diagrams. Digital controller with on-chip A/D and D/A converters provides continuous closed-loop monitoring and control of critical laser parameters. Driver can be operated in standalone mode or controlled by external microprocessor via built-in I2C(TM) Serial Interface port....

Read More »
Pickers

Picking Solution works with manual and automated systems.

SK Pick and Pass System uses conveyor system where order totes are released from pick cell when order lines in that cell are completed. As tote moves toward next picking area, order is automatically read and AS/RS or carousel in next cell is activated to bring needed inventory to picker, which then places items in tote. Order is then conveyed to next picking zone. Pick and Pass method integrates...

Read More »

All Topics

COVID-19 Response Suppliers COVID-19 Response:
Can Your Company Help Provide Critical Supplies?

We are using the power of our platform to aid in the mass shortage of critical supplies. If your company can help provide supplies, capabilities, or materials for products such as N-95 Masks and Tyvek SuitsPlease let us know.

COVID-19 Response Suppliers