Two-Component Pump aids tub and shower manufacturers.
Share:
Press Release Summary:
Used for high-volume dispensing of filled polyester resin and catalyst material, Boss(TM) pump offers 5 gpm @ 20 cycles/min standard output and 15 gpm max output. It delivers uninterrupted operation and features reversible sharp-edge carbide seats, hard chrome-plated cylinder and rod, as well as spring-loaded u-cup seals with no packings. Additional features include integrated muffler in air motor and removable foot valve and cylinder.
Original Press Release:
Binks New Two-Component Pump Provides Unparalleled Durability
Binks BossTM Pump Lasts Longer than Other Pump Manufacturers Standard Products in High-Volume Tub and Shower Fiberglass Products Manufacturing
July, 2005, Glendale Heights - Binks has announced the BossTM pump, built to last longer than any existing pumps on the market now, when used for high-volume dispensing of filled polyester resin and catalyst material. Tub and shower manufacturers will see a marked improvement in production output and consistency, as the Binks BossTM pump provides faster dispensing and longer continuous operation than any current pump products.
The Binks Boss pump provides unparalleled high-volume dispensing capability. It's standard output is rated at 5gpm at 20 cycles/minute, with a maximum dispensing capability of 15 gallons per minute. Standard two-component pumps typically output two to four gallons per minute.
The Binks Boss also provides uninterrupted operation that exceeds any existing pump on the market today. When tested at one facility over an eight-month period, the Binks Boss ran continuously and exceeded their expectations by pumping a tremendous amount of resin with no downtime on the resin pump. Typical repairs on existing pumps are expected every three-four weeks in a similar application. By using a Binks Boss Pump, this could extend pump durability up to ten times greater than standard pumps.
In addition to high-volume and durability, the Binks Boss also provides these advantages:
oReversible sharp-edge carbide seats for long life and lower maintenance costs
oHeavy hard chrome plated cylinder and rod for extended life
oSpring loaded u-cup seals with no packings to adjust
oRemovable foot valve and cylinder for easy service
oIntegrated muffler in air motor for quiet operation
Binks pioneered the development of liquid spray finishing technology over 100 years ago and continues to set the standards for industrial spray finishing. For further information about Binks spray finishing or fluid delivery products, please call Customer Service at 1.800.992.4657 or visit the Binks website at www.binks.com (Gel-Coat and Resin Laminating Equipment Section).
