Torque Sensor converts shafts into rotary torque sensors.

Press Release Summary:

Model 1650B clamps onto drive train and converts shaft into rotary torque transducer within 15 minutes. It does not require installation of slip rings, and comes pre-calibrated. Suitable for proving trials or commissioning driver/driven transmission trains, model 1650B can be used for temporary or permanent installations. Immune to oil, dirt, and water, unit is available for shafts with 2.5 to 15 in. dia, and can be used at speeds up to 2500 rpm.

Original Press Release:

Clamp-On Torque Sensor Converts Your Shaft Into A Rotary Torque Sensor In 15 Minutes.

The new Model 1650B Rotary Torque Sensor literally clamps onto the drive train and, within 15 minutes, converts the shaft into a rotary torque transducer ready to take measurement data. This unique 1650B System avoids the need to break into the drive train to install an in-line torque cell, it eliminates the need for skilled personnel to cement strain gauges onto the shaft, and does not require the installation of maintenance-intensive slip rings. The 1650B clamp on sensor assembly comes pre-calibrated. Installation only requires the user to clamp on the two halves of the sensor shell, position the antenna and connect the wireless receiver. There is nothing to wear out, maintenance is virtually eliminated. This rotary torque transducer is ideal for proving trials or commissioning of driver/driven transmission trains to ensure design criteria are met or that drive trains are not overloaded. The 1650B Rotary Torque Sensor can be used for temporary or permanent installations. It is immune to oil, dirt and water, making it ideal for most industrial applications. The unit is available for shaft diameters from 2.5 inches to 15 inches and can be used at shaft speeds up to 2500 rpm. Wireless Data Corporation A SENSOTEC Company 2080 Arlingate Lane Columbus, OH 43228 Phone: (614) 850-5000 Fax: 614-850-1111 E-mail: wdcsales@sensotec.com wirelessdatacorp.com