QC Software limits specimen self-heating under dynamic load.
Press Release Summary:
Specimen Self-Heating Control (SSHC) is add-on to Instron® WaveMatrix™ Software package for dynamic and fatigue testing of polymers and composites. Using difference between specimen's continuously recorded temperature and pre-specified temperature target, solution maximizes testing frequency in closed loop. Resulting tests run at maximum frequency while keeping specimen temperature within tight band (as little as ±0.5°C). Temperature signal can be provided by any standard sensor system.
Original Press Release:
Software Add-on Limits Specimen Self-Heating Under Dynamic Loads
Instron, a leading provider of testing equipment designed to evaluate mechanical properties of materials and components, announces the release of the Specimen Self-Heating Control (SSHC) add-on to the versatile Instron® WaveMatrix™ Software package for dynamic and fatigue testing of polymers and composites. It maintains specimen temperature within a tight band and can save time, cost, and energy in the QC test lab, as well as in the development and optimization of composite formulations.
Polymers and composites show a pronounced self-heating effect during cyclic loading and a strong temperature performance correlation, so fatigue testing is traditionally conducted at rather low frequencies. The SSHC add-on uses the difference between the specimen’s continuously recorded temperature and a pre-specified temperature target to maximize the testing frequency in a closed loop. For lower loading, where very large numbers of cycles-to-failure are expected, the system can run at a significantly higher frequency, which greatly reduces the test duration. At high loading, consistent specimen temperature is maintained even in the latter stages of the test, during which self-heating effects increase dramatically resulting in run-away specimen temperature with fixed frequency tests.
Dr Peter Bailey, Dynamic Testing Systems Specialist at Instron UK, comments: “For structural composites, a 5°C shift in temperature will often have a greater effect than a two-fold change in test frequency, so the benefit of a tightly controlled test temperature greatly outweighs moderate variation in test frequency. Specimen Self-Heating Control allows a test to always run at the maximum frequency possible while keeping the specimen temperature constant. In this way, we can offer improved cost-effectiveness by increased throughput and minimized energy consumption. Additionally, this can give better consistency for polymers and composites due to previously unachievable confidence in test temperature.”
The temperature signal can be provided by any standard sensor system, e. g. via USB thermocouple integration or via any 0 – 10 Volt analog input, including infrared sensors. The user specified temperature window can achieve a tolerance of as little as ± 0.5 °C. The SSHC technology is applicable to any test geometry provided a specimen temperature transducer can be fitted, and is also compatible with temperature chamber testing.
Lastly, the SSHC add-on is available for all Instron dynamic testing systems provided they are equipped with the 8800 digital controller and supported by the latest version of WaveMatrix Software.
About Instron
Instron is a leading provider of test equipment for the material and structural testing markets. A global company providing single-source convenience, Instron manufactures and services products used to test the mechanical properties and performances of various materials, components and structures in a wide array of environments.
Instron systems evaluate materials ranging from the most fragile filament to advanced high-strength alloys, providing customers with comprehensive solutions for all their research, quality and service-life testing requirements. Additionally, Instron offers a broad range of service capabilities, including assistance with laboratory management, calibration expertise and customer training.
For more information, contact Instron, 825 University Ave, Norwood, MA 02062, USA.
Toll-free: 1-800-564-8378; Fax: 1-781-575-5725; or visit our website at www.instron.com.
