Press Release Summary:
Suitable for welding metals such as stainless steels, duplex steels, titanium and zirconium, that require oxide free welding, PurgEyeÂ® 1000 Weld Purge MonitorÂ® measure oxygen levels from 1 ppm to 1,000 ppm. Unit is designed for preventing oxidation under distance monitoring conditions. PurgEyeÂ® 1000 with PurgeNetâ¢ measure directly at weld location and transfers the information to monitor up to 1 Km away.
Original Press Release:
Remote Monitoring of Weld Purge up to 1 km away
When welding lengths of tube and pipework fabrications, as well as sections of pipelines of 20 metres length and more, one problem operators face is not receiving a fast and true weld purge reading from the purge zone.
Now, for the first time, Huntingdon Fusion Techniques HFTÂ® makes it possible to have an immediate reading of the weld purge gas at the underside of the joint, from any distance up to 1,000 metres away with their PurgEyeÂ® 1000 Weld Purge MonitorÂ®.
Luke Keane, Distributor Support for HFTÂ® said: âBy using a remote sensing head, which can be fitted onto any Mechanical or Inflatable Tube and Pipe Weld Purging System from 1â (25 mm) diameter upwards, the oxygen level can be measured directly at the weld location and the information will be electronically transferred to the monitor up to 1 km away. With this capability, the operator can be certain that the weld purge reading is correct and that the joint will not be adversely affected by oxidation.â
âThe PurgEyeÂ® 1000 is one of our five Weld Purge MonitorsÂ® to now feature PurgeNetâ¢, a networking device designed for communicating the current oxygen reading from the Monitor, to another piece of equipment, such as the visual warning accessory PurgeAlarmâ¢ or a Dew Point Monitor with additional inter-pass temperature monitoring.â
If exhaust gas from a normal weld purge system is piped down a hose to a distant measuring instrument, it may take many minutes, or even hours in some cases, for a stable reading to reach the sensor. The exhaust gas may even be contaminated on the way by outgassing from the walls of the hose material or from air drawn in through a leaky connection.
In the event the oxygen level is too high, the weld would become oxidised at best and might even have nitrogen and hydrogen absorbed into the joint at worst, which could cause metallurgical defects leading to other problems.
The PurgEyeÂ® 1000 Weld Purge MonitorÂ® has been designed and developed specifically to prevent oxidation under distance monitoring conditions and has a sensor placed immediately next to the weld purge site.
The sensor is secured in a tiny module, which is mounted inside the purging system and is connected to the measuring instrument by a data cable. The purge reading is sent back to the instrument at the speed of light, so operators and quality control personnel know immediately when the purge is satisfactory.
This way, the operator can be certain that the weld purge reading is correct and that the joint will not be adversely affected by oxidation, allowing welders to achieve that sought after zero colour weld.
The PurgEyeÂ® 1000 measures oxygen levels from 1,000 parts per million (ppm), right down to 1 ppm (accurate to 10 ppm), ideal for welding metals such as stainless steels, duplex steels, titanium and zirconium where oxide free, zero colour welds are required time after time.
For the USA, please contact: