New Zinc Thunderstud Wedge Anchors are Suitable for Light to Heavy-Duty Fastening Purposes

Press Release Summary:

The Zinc Thunderstud Wedge Anchors are available in diameters ranging from 1/4 to 1-1/4 in. and lengths in 1-3/4 to 12 in. range. The units come with patented universal clip and partial threads and are offered with correct size and quantities of nuts and washers. The anchors are used for application in solid concrete for indoor, dry environments.


Original Press Release:

Zinc Thunderstud Wedge Anchors Now Available from Confast

Zinc Thunderstud Wedge Anchors, in every diameter, overall length and thread length, are now available for direct purchase from the manufacturer. 

“Thunderstud zinc anchors are designed for application in solid concrete for indoor, dry environments, and are best suited for light to heavy-duty fastening purposes,” described Bob Carlisle, founder and President of Concrete Fastening Systems, Inc. “They are manufactured in a diameters ranging from ¼” to 1-1/4” with lengths from 1-3/4” to 12”, depending on the diameter.”

Product Features

  • MADE IN AMERICA: Uses steel melted in America to assure top quality and to meet most Made in America requirements
  • PATENTED UNIVERSAL CLIP: Anchor does not spin in the hole which makes each fastening faster and more secure
  • PARTIAL THREADS: Assures proper anchor length is used to meet minimum embedment depths
  • LENGTH I. D. STAMPED ON EACH ANCHOR: Provides for a fast easy inspection of embedment depth
  • PACKAGED: Correct size and quantities of nuts and washers included
  • INSTALLATION: Hole size to be drilled in the concrete is equal to the diameter of Thunderstud zinc anchor used. To determine the minimum anchor length for your application, simply add the material thickness to the minimum embedment and add the thickness of the nut & washer.

Installation steps:

  1. Drill a hole in the concrete at least 1/2" deeper than the wedge anchor embedment using a hammer drill and the correct size carbide tipped bit.
  2. Clean out the hole of all debris.
  3. Place the nut on the end of the wedge anchor (to protect the threads of the wedge anchor during installation).
  4. Hammer the wedge anchor into the hole deep enough so that the threads are below the surface of the base material.
  5. Tighten the nut - turning approximately three or four full turns.
  6. Drill a hole in the concrete at least 1/2" deeper than the wedge anchor embedment using a hammer drill and a correctly sized carbide tipped bit. (Hole size is wedge anchor size).
  7. Clean out the hole of all debris.
  8. Place the nut on the end of the wedge anchor (to protect the threads of the wedge anchor during installation).
  9. Hammer the wedge anchor into the hole deep enough so that the threads are below the surface of the base material.
  10. Tighten the nut - turning approximately three or four full turns.

Concrete Fastening Systems, Inc. has been selling concrete fasteners for 30 years from a fully stocked warehouse in Cleveland, Ohio. Free, same-day shipping of anchors in every length and diameter is available by ordering at: www.confast.com.

All Topics