Linear Double Rail System delivers precision motion.

Press Release Summary:




Designed for load positioning applications, 400 Series features enclosed aluminum housing and max speed of 5 m/sec. Rails consist of double precision ground, 12 mm diameter, Cf53 steel shafts hardened to RC 62 ±2 that accommodate roller and bearing carriages. Shafts, pulled together by support blocks, are parallel to less than 0.02/m. Products are available in 16 sizes from 400-3,000 mm.



Original Press Release:



New Low Cost Series 400 Linear Double Rail System from Techno-Isel Offers an Enclosed Aluminum Housing



The New Series 400 Linear double rail system from Techno-Isel offers affordable precision motion for a variety of moderate load positioning applications. This extremely low cost system has a maximum speed of up to 5 m/sec.

These rails, identified as the 400 Series, consist of double precision ground 12 mm diameter Cf53 steel shafts hardened to RC 62 +/- 2 that can accommodate newly patented roller and bearing carriages. The shafts are pulled together by the unique shaped support blocks, ensuring that they are parallel to <0.02 /1 m. They are stocked in 16 sizes from 400 mm to 3000 mm.

This Series 400 system can run with both the newly patented Techno roller carriage 2, bearing carriage 2, or bearing carriage 4 designs. The more economical roller carriage 2 consists of a ground and hardened steel plate 110 x 65 x 6 mm with four M6 threaded holes on a 50 mm grid. Four precision rollers, 21 mm in diameter, are on each plate. Each roller has two sealed bearings which are lubricated for life. Two of the rollers have eccentric mounting to allow for easy preload and clearance adjustment. They have a travel speed of up to 10 m/sec. with very quiet operation. The Bearing Carriage 2 consists of a ground and hardened steel plate 80 x 60 x 36 mm with four M6 holes for threaded fastening and two 5h7 diameter holes for dowel pins. Each carriage has 4 re-circulating raceways with 3.5 mm diameter ball bearings. The unit is equipped with wipers and lubrication ports. The maximum rate of speed is 5 m/sec. The bearing carriage 4 is a single piece body constructed of ground & hardened steel. There are three M6 tapped mounting holes on the top of the carriage. The bearing also has a 28 mm diameter H7 precision hole through the body for mounting a ball screw, ball nut, pneumatic cylinder, belt or other drive mechanism.

All Topics