Interface Module works with addressable fire systems.
Share:
Press Release Summary:
Used in intelligent fire systems, M210E-CZ conventional zone interface module enables zone of up to 32 conventional 2-wire detectors to be managed by control panel via single module address on one loop. It is compatible with existing intelligent control panels and can be mounted in stand-alone enclosure or on 35 mm DIN rail. Along with optional short-circuit isolation, product features tri-color LED status indicator and can be installed without loss of protection.
Original Press Release:
Conventional Interface Module for Addressable Fire Systems
Redditch (UK)
New from System Sensor Europe is the M210E-CZ conventional zone interface module, used in intelligent fire systems to enable a zone of up to 32 conventional two-wire detectors to be managed by the control panel via a single module address on a loop. Fully compatible with existing intelligent control panels the module can be mounted in a stand-alone enclosure or on a standard 35mm DIN rail. Optional short-circuit isolation can be enabled if required to preserve loop continuity in the event of the device failing and a tri-colour LED gives local status indication.
When existing conventional systems are being replaced and upgraded with a new addressable system, undertaking the work in stages is often convenient.
By linking an existing conventional zone via the M210E-CZ, the new system can be installed without loss of protection. The module can also allow the use of lower cost conventional detectors in physically well defined locations such as separate machinery rooms and boiler houses, where knowing the individual detector address is not necessarily important.
The power for the conventional detectors can be supplied from the loop, from a dedicated feed from the control panel or from an external power supply. A fault input enables an external power supply and other devices to be monitored for failure; a factory programmable option for VdS monitoring requirements is available. The M210E-CZ can also be used to interface System Sensor's beam detector to existing intelligent fire panels.
