In-Line Charge Converters offer TEDS capability.
Press Release Summary:
Series T422 converts charge mode piezoelectric sensor signals into low-impedance voltage signals for operation with ICP® sensor signal conditioners or readout devices which have ICP® sensor input. TEDS interface chip enables identification, location, sensitivity, and other information relative to attached sensor to be stored. Devices allow use of extreme environment charge mode sensors in large channel count modal analysis and structural testing.Original Press Release:
In-Line Charge Converters Enable Charge Mode Piezoelectric Sensors with TEDS Capabilities
March 3, 2003, Depew, NY - The T422 Series of In-Line Charge Converters from the Electronics Division of PCB Piezotronics, Inc., convert charge mode piezoelectric sensor signals into low-impedance voltage signals for operation with ICP® sensor signal conditioners or readout devices which have an ICP® sensor input. These in-line charge converters are now available with TEDS (Transducer Electronic Data Sheet) capabilities, which enable the devices to store and recall TEDS (IEEE 1451.4 standard) data for the sensor which is attached.
T422 Series In-Line Charge Converters feature a TEDS interface chip which enables the identification, location, sensitivity, and other information relative to the attached sensor to be stored. The devices allow for the use of extreme environment charge mode sensors in typical TEDS applications such as large channel count modal analysis and structural testing.
For additional information, contact the Electronics Division of PCB Piezotronics, Inc., toll-free at 800-828-8840; E-mail: electronics@pcb.com; or fax 716-684-0987. For other PCB products, contact PCB directly at 716-684-0001, or visit our web site at www.pcb.com.
PCB and ICP are registered trademarks of PCB Group Inc.
