Gas IR Tower Oven is designed for fiberglass PTFE coatings.
Share:
Press Release Summary:
Used to dry, bake, and sinter PTFE coatings on fiberglass fabrics, 21 ft vertical electric and gas fired IR tower oven is engineered for 65 in. woven fiberglass line. Design for gas burners eliminates need for high-temperature insulation, and heater's outer surfaces, edges, and back remain cool to touch. Dual 12 x 71 in. drying zones combine electric IR with air; bake zone is 24 in. in direction of product travel; and sinter zone is 32 in. in direction of product travel.
Original Press Release:
New Gas Infrared Tower Oven for PTFE Coatings on Fiberglass
Hawthorne, New Jersey --- This Radiant Energy Systems’ 21 ft. vertical electric and gas fired infrared tower oven is custom designed for drying, baking and sintering of PTFE coatings on fiberglass fabrics. A new, upgraded design for the gas burners is supplied. This new design eliminates the need for high temperature insulation. The heater’s outer surfaces— edges and back, are cool to the touch.
This more efficient oven system was engineered for a 65” woven fiberglass line. There are two 12” x 71” drying zones that combine electric infrared with air. The bake zone is 24” in direction of product travel. Two gas fired infrared burners are mounted in a staggered configuration with each heater opposite an insulated reflector panel. This design allows the product temperature to even out.
The sinter zone is 32” in direction of product travel and contains four staggered gas infrared heaters. These heaters are also mounted in a staggered configuration with each heater opposite an insulated reflector panel.
Radiant Energy Systems is headquartered in Hawthorne, New Jersey. To learn more visit www.RadiantEnergy.com or info@RadiantEnergy.com; 973-423-5220.
Clara O’Boyle, Marketing Coordinator
Radiant Energy Systems, Inc.
175 North Ethel Ave
Hawthorne, NJ 07506
973-423-5220 ext 11
