Gap Inspection Gages are constructed of carbon steel.

Press Release Summary:




Designed to assure that instrumentation tube fitting has been sufficiently pulled up, NGG series gages are useful when fittings are to be tightened in difficult or inaccessible locations. They are available in sizes from 5/8 through 2 in. Gages have both Go and No Go ends and should be used only in initial make-up situations.



Original Press Release:



Brennan Offers Gap Inspection Gages



Gages have both "GO" and "NO-GO" ends

Brennan's new Gap Inspection Gages are designed to assure that an instrumentation tube fitting has been sufficiently pulled up. These gages are particularly useful when fittings are to be tightened in difficult or inaccessible locations as well as in systems where insufficient make-up could cause potentially dangerous or expensive consequences.

Not intended for use in subsequent remake assemblies, Brennan's gages have both "Go" and "No Go" ends and should be used only in initial make-up situations.

This new NGG series' carbon steel gages are available from stock in 5/8" through 2'' sizes.

All Topics