Drill and Tap Machine incorporates milling capability.
Press Release Summary:
Along with 508 x 406 x 394 mm work cube and 660 x 381 mm T-slot table, DT-1 features BT-30 taper spindle that spins to 15,000 rpm and allows tapping at speeds to 5,000 rpm. Standard 11.2 kW vector drive system provides 62 Nm peak torque for milling and boring, while 20-pocket, servo-driven tool changer swaps tools in 0.8 sec. Max cutting feedrate of 30.5 m/min, 61 m/min rapids, and 1 G acceleration rates minimize cycle times and reduce non-cutting time.
Original Press Release:
Haas Drill and Tap Machine Features Milling Capability
The new DT-1 from Haas Automation, Inc., is a compact, high-speed drill and tap machine with full milling capabilities. The machine features a generous 508 x 406 x 394 mm work cube and 660 x 381 mm T-slot table, while maintaining a very small footprint. A powerful BT-30 taper spindle spins to 15,000 rpm, and allows tapping at speeds to 5000 rpm. The spindle is coupled directly to the motor for smooth, quiet operation and extreme thermal stability. A 11.2 kW vector drive system provides 62 Nm (peak) of torque for milling and boring operations.
The DT-1 is equipped with a high-speed, 20-pocket, servo-driven tool changer that swaps tools in 0.8 seconds. High-speed 61 m/min rapids combine with 1G acceleration rates to shorten cycle times and reduce non-cutting time. The maximum cutting feedrate is 30.5 m/min.
For efficient chip removal, the DT-1 features steeply sloped internal sheet metal and twin chip augers that exit at the rear of the machine. A 170 L flood coolant system is standard, with a programmable coolant nozzle and high-pressure through-spindle coolant systems available as options.
Built in the USA by Haas, the DT-1 drill and tap machine is backed by the worldwide network of Haas Factory Outlets - the most extensive system of support and service in the industry. For more information about Haas Automation and Haas products, visit www.HaasCNC.com.
