Deburring Tool deburrs cross-drilled holes.
Share:
Press Release Summary:
ORBITOOL(TM) removes burrs specifically from intersection of holes. Operation can be tailored to leave minimally broken edge or blended radius. Tool is used like any cutting tool found on lathe turret or tool magazine of machining center. It can deburr non-circular features and is suitable for process control environment.
Original Press Release:
J.W. Done Co. Introduces Orbitool, The Next Tool After Drill; The Only In-Process Deburring Tool for Cross-Drilled Holes
DELIVERS INCREASED THROUGHPUT AND SHORTER CYCLE TIMES
I know that you are always looking for new products/technologies that will enable your specifier readers to achieve even greater cost, time, and quality efficiencies.
Our company -- J.W. Done of Foster Citg, CA -- is exhibiting at IMTS, with Weiler Corp. Booth B-6421 - ORBITOOL(TM), The Next Tool After Drill -- a new deburring tool that will accomplish all of the above -- at a fraction of the investment of alternative deburring techniques!
The NEXT TOOL AFTER DRILL is the only tool capable of in-process deburring of cross-drilled holes. The tool is used just like any cutting tool found on a lathe turret or tool magazine of a machining center. It removes burrs specifically from the intersection of the holes. The operation can be tailored to leave a minimally broken edge or a blended radius. The new tool is already in use at several major metal working companies. Customers are quite enthusiastic about the tool and are reporting dramatic improvements in productivity.
I hope that you can take a few minutes at IMTS to see a demo of our new tool and learn why it is not like any other cutting tool found on the market today.
ORBITOOL BENEFITS
-- removes burrs within seconds
-- consistent results and consistent quality
-- increased throughput/shorter cycle time
-- dramatically reduced deburring cost
-- no capital investment
-- can be used in automatic tool changers
-- process can be tailored to leave a minimally broken edge or a blended radius
-- requires no special tooling
-- no additional setup for secondary deburring operations
-- no batch and queue
-- setup and programming are simple
-- can deburr non-circular features
-- ideal for process control environment
Thank you in advance for your consideration. You can find more information at www.jwdone.com A copy of a data sheet can be downloaded from our website at www.jwdone.com/specifications.pdf
Sincerely,
Michael Kapgan, President
J.W. Done Compang
888-535-3663, email: mkapgan@jwdone.com
