Cases accept 3U subracks and chassis.

Press Release Summary:

INSTRUMET cases are available in 3U x 10.5 x 13.8, 3U x 19 x 13.8, and 3U x 19 x 17.7 in. sizes. Enclosures are manufactured in aluminum, with fixing screws hidden on underside, and feature base and removable rear panels with ventilation slots, 2 die-cast front bezels with caged nut mounting points, and top panel. All models feature 2 internal support rails which simplify installation of heavy subracks or chassis. Cases include 4 molded nonslip feet with tilt legs.


Original Press Release:

Instrumet 19

METCASE has launched the all new 'INSTRUMET' 19" case range. These stylish, versatile and light weight enclosures conform to the DIN and IEC standards for full and half width 19" equipment, and will accept standard 3U subracks and chassis. Typical applications will include test and measurement devices, communications equipment, medical equipment, laboratory systems and much more. The 'INSTRUMET' 19" cases are available in three standard sizes: 3U x 10.5" x 13.8", 3U x 19" x 13.8" and 3U x 19" x 17.7". The enclosures have a clean and modern appearance with no visible fixing screws on the case panels. The fixings are hidden on the underside of the case. 'INSTRUMET' enclosures are manufactured in aluminum which gives them a significant weight advantage over other steel 19" cases on the market. Each case consists of two die-cast front bezels, a top panel, a base panel and a removable rear panel. The base and rear panels include ventilation slots for cooling. All models feature two internal support rails which ensure easy installation of heavy subracks or chassis. The case parts are painted in a modern color combination of widow gray (bezel), and light gray (top, base & rear panel). The front bezel features standard caged nut mounting points for fitting the 19" subracks, chassis or accessory front panel. The mounting points are inset in the bezels to allow the equipment to be recessed, and thus protect the controls from accidental operation. The enclosures are supplied fully assembled, and include four molded non-slip feet with tilt legs. The case body, base panel and rear panel are provided with M4 x 10mm earth studs for electrical continuity. METCASE also offers a full customizing service on these enclosures with machining, silk-screen printing and much more, providing a fully finished housing ready for the electronic components. More information on these enclosures can be found on the METCASE website at http://www.metcaseusa.com/instrumet

Contact This Company

All Topics