Texas Instruments
Dallas, TX 75243
Share:
Split-Chassis PC Platform offers table-top interface.
Split-Chassis PC platform incorporates x1 TI PCI Express interface running over cable to support 2.5 Gbps bi-directional throughput. PCI-Express-to-PCI Bridge XIO2000 is connected to USB host controller, parallel ATA controller, and TI PCI7621 UltraMedia controller. Split unit enables users to upgrade system performance independently of I/O capability. Unit provides table-top interface for USB,...
Read More »Digital Signal Processors target packet-switched telecom.
Models TMS320C6410 and TMS320C6413 include 2 standard McBSPs for multi-channel clocked serial communication, 2 Audio Serial Ports compatible with IIS and common stereo codecs, 16-/32-bit microprocessor Host Port Interface, and 2 IIC control serial ports. Model TMS320C6410 runs at 400 MHz with 160 Kbytes total memory, while 500 MHz Model TMS320C6413 offers 288 Kbytes total memory. Both come in 23...
Read More »DSP Chip comes in ball grid array package.
At 500 MHz, TMS320C6413 digital signal processor (DSP) employs parallel architecture with 8 parallel functional units in DSP core and 256+ KBytes on-chip memory. Tailored telecom peripherals include 2 multi-channel buffered serial ports, 2 audio serial ports, 2 IIC control serial ports, and 3 general 32-bit timers. Chip's 1 mm ball pitch on BGA package facilitates 4 layer board routing. Device...
Read More »Development Platform helps develop hands-free kit systems.
Hands-Free Kit, matched with Bluetooth-® radio subsystem, provides complete DSP-based platform with real-time voice and audio-enhancing algorithms. It includes C5407 DSP motherboard with Clear Voice Capture echo and noise suppression software. Features include Bluetooth Daughter Card with Bluetopia stack; separate FM transmitter; dual-channel A/D converter, cPLD, and 3 programmable LEDs and push...
Read More »Current Mode ICs act as interleaved PWM controllers.
Peak current-mode controllers UCC28220 and UCC28221 use interleaving techniques to control 2 isolated power stages. Available in interleaved forward or interleaved fly-back isolated topologies, devices integrate 2 PWM channels operating at 180-
Read More »
Analog-to-Digital Converters offer noise-free resolution.
Models ADS1255 and ADS1256 are 24-bit ADCs offering resolution up to 23 bits, data rates up to 30 kSPS, and -
Read More »Hot Swap Controller eliminates need for OR-ing diodes.
Able to provide protection for redundant -48 V telecom power supplies, TPS2350 hot swap power manager allows precise control of current and voltage during turn-on and operation. Unit operates with supply voltages from -12 to -80 V, withstands spikes to -100 V, and uses 3 power field effect transistors. Programmable features include undervoltage and overvoltage limits, circuit breaking, fault...
Read More »
Integrated Circuit suits single-cell Lithium-Ion systems.
Offered in 48-lead, 7 x 7 mm QFN package, TPS65010 battery charging and power conversion integrated circuit (IC) delivers performance and power conversion efficiency up to 97%. Product integrates 2 synchronous step-down DC/DC converters with integrated FETs, one 1-A converter, and one 400 mA converter. It deploys pulse frequency modulation and PWM switching technology and conserves battery by...
Read More »ADSL Router integrates 12 V line driver on single chip.
Model AR7 is built with 130 nm copper CMOS process that supports system-on-chip integration of analog circuits with digital logic. Chip combines MIPS 32-bit RISC processor, DSP-based digital transceiver, ADSL analog front end including line driver and receiver, power management, and hundreds of passive components onto single piece of silicon. Programmable digital filters in receive section make...
Read More »
DSP Starter Kit contains USB plug-and-play functionality.
Model TMS320C5510 provides full featured board for DSP development. It enables user to identify areas to be tuned for less power consumption, demonstrate dynamic power management in hardware and software, and manage power consumption efficiently to meet system power budgets early in development cycle.
Read More »