Texas Instruments

Digital Signal Controllers feature 32-bit wide data path.

Suited for industrial control applications, DSP-based TMS320F280xx controllers feature mixed 16/32-bit instruction set and processor-intensive, sensorless vector control. Models TMS320F28015/16 offer 12 KB RAM and 32 KB Flash, while TMS320F2801-60/02-60 offer 12 KB RAM and 32 or 64 KB Flash, respectively. Each provides complete control system capabilities and 60 MHz performance. Depending on...

Read More »
Electrical Equipment & Systems

Texas Instruments Single-Chip Cell Phone Technology Will Make Multimedia Phones Affordable for Mass Market

New OMAP-Vox(TM) Single-Chip Platform Supports EDGE, Enables Software Reuse for Faster and More Cost-Effective Multimedia-Rich Feature Phone Development DALLAS and BEIJING, Nov. 8 /-- During a summit of wireless industry leaders held today in Beijing, China, Texas Instruments Incorporated (NYSE:TXN) (TI) announced a new OMAP-Vox(TM) single-chip solution to foster development of lower-cost...

Read More »
Temperature Sensor suits precision measurement applications.
Sensors, Monitors & Transducers

Temperature Sensor suits precision measurement applications.

Supplied in MSOP-8 package, TMP275 delivers ±0.5°C accuracy (max) from +10 to +85°C and ±0.75°C (max) from 0 to +100°C. Digital-output temperature sensor incorporates I2C/SMBus-compatible, 2-wire serial interface and allows up to 8 different addresses for flexibility in interface bus designs. Along with 9-12 bit programmable resolution and 0.1 Â-µA...

Read More »
Agricultural & Farming Products

IEC-Compliant Microcontroller promotes automotive safety.

Symmetrical dual-core microcontroller (MCU), TMS570, is suited for use in braking, steering, and chassis control applications. It features dual ARM® Limited Cortex(TM) R4 cores and 2 MB on-chip Flash memory, which is protected by Error-Correcting Code (ECC) bit checking. While design enables failure detection and response times required by IEC 61508 SIL3 standard, directly implemented...

Read More »
Operational Amplifier exhibits low noise and distortion.
Communication Systems & Equipment

Operational Amplifier exhibits low noise and distortion.

Supplied in 16-pin QFN package, 16-bit THS4520 fully-differential ADC driver offers rail-to-rail output and supports wideband, dc coupled, channel requirements in high-accuracy, 3.3-5 V DAQ systems through its independent output common-mode control. This feature provides control for output common mode over full range, independent from signal path design. With 600 MHz bandwidth, product offers low...

Read More »
Communication Systems & Equipment

ZyXEL Communications Selects Texas Instruments Voice over IP Solutions for Next-Generation Access Devices and IP Phones

DALLAS (August 30, 2006) -- Texas Instruments Incorporated (TI) (NYSE:TXN) announced today that ZyXEL Communications Corp. (TSE:2391), the world's largest residential gateway provider, has chosen TI's Voice over Internet Protocol (VoIP) products for its voice-enabled DSL access devices, VoIP gateways and IP phones. TI's complete, integrated customer premises equipment (CPE) silicon and software...

Read More »
Communication Systems & Equipment

Fixed Gain Audio Power Amps occupy 2.5 x 1.7 mm PCB area.

Supplied in 1.5 x 1.5 mm package, models TPA2032D1, TPA2033D1, and TPA2034D1 feature respective fixed gain amplification of 6, 9.5, and 12 dB. They offer typ common-mode rejection ratio of -69 dB and power supply rejection ratio of -73 dB at 217 Hz. Suited for wireless portable applications, these 88% efficient Class-D audio power amplifiers are capable of driving 2.75 W from 5 V power supply...

Read More »
Communication Systems & Equipment

Operational Amplifier is used in single-supply applications.

With single-supply operation from 2.2-5.5 V, OPA365 operational amplifier utilizes zero-crossover, single-input stage architecture to achieve rail-to-rail performance. Features include distortion of 0.0006% THD+N, noise of 4.5 nV/rtHz, bandwidth of 50 MHz, and settling time of 300 ns to 0.01%. Delivering CMRR of 100 dB minimum and 120 dB typical over entire input range, product design makes it...

Read More »
Miniature, 1 W DC/DC Converters feature 3 kV isolation.
Electrical Equipment & Systems

Miniature, 1 W DC/DC Converters feature 3 kV isolation.

Supplied in RoHS-compliant package measuring 20 x 8 x 10 mm, DCH01 series provides up to 85% efficiency and meets UL60950 specifications with EN55022 Class B EMC performance. Unregulated dc/dc converters offer point-of-load power conversion and ground loop elimination for noise-sensitive applications. With open-frame design, plug-in power modules operate from 5 V input and provide single voltages...

Read More »
Analog-to-Digital Converter achieves 4 MS/sec.
Electrical Equipment & Systems

Analog-to-Digital Converter achieves 4 MS/sec.

Featuring fully differential input with pseudo bipolar input range of -4 to +4 V, SAR Model ADS8422 includes either full 16-bit interface or two 8-bit option modes so data can be read in cycles if necessary. Device provides 92 db signal-to-noise ratio and -102 dB total harmonic distortion. Operating over industrial temperature range of -40 to +85°C, converter is suited for medical imaging,...

Read More »

All Topics