Aremco Products, Inc.

707 Executive Blvd.
Unit "B"
Valley Cottage, NY 10989

Ceramic Adhesive suits applications to 3,000-

Ceramabond(TM) 552 consists of single-part, alumina-filled adhesive that adheres to ceramics and metals used in applications to 3,000Ã-

Paints & Coatings

Epoxy Coating provides corrosion protection to 300-

Corr-Paint(TM) CP2070 high-temperature, epoxy-novolac paint is a 2-part, gray-pigmented, 100% solids system used to protect steel components and structures. It is resistant to wide range of chemicals, and provides thermal shock, salt spray, and UV resistance. Mixed viscosity is 800-1000 cp. Applied by spray equipment, brush, or roller, coating dries and cures fully at room temperature in 24 hr....

$Refractory Coating withstands temperatures to 2,300-$

Paints & Coatings

Refractory Coating withstands temperatures to 2,300-

Pyro-Paint(TM) 634-AS alumina-silica-filled, fiber-reinforced, ceramic coating bonds, coats, and seals graphite and refractory materials used in molten metal fluid handling components. It also coats and insulates graphite impellers, preventing oxidation and corrosion of graphite at melt line. With 400-700 cps viscosity range, it is resistant to wetting by non-ferrous molten metals,...

Adhesives & Sealants

Epoxy System repairs cast iron and steel to 450-

Pyro-Putty(TM) 657 repairs pin holes, cracks, and defects in cast iron and sheet metal prior to painting and powder coating. Stainless steel filled, 1-to-1 mix epoxy system provides continuous and intermittent temperature limits of 400 and 450-°F, respectively. Dispensable, thixotropic paste cures fully at room temperature in 4-6 hr; cured material exhibits tensile shear strength of 1,860 psi...

Adhesives & Sealants

Silver-Filled Adhesive is used in applications to 1,200-

Pyro-Duct(TM) 597-A electrically and thermally conductive adhesive is formulated using high-purity silver powders combined with conductive binder system. It exhibits volume resistivity of 0.0002 ohm-cm at room temperature and tensile shear strength of 450 psi. Single component, water-dispersible system contains no organic resins or solvents. It sets at room temperature in 1-2 hr and heat cures in...

Adhesives & Sealants

Adhesive and Coating withstands temperatures to 2,400-

Ceramacoat(TM) 512N high-temperature adhesive and ceramic coating system is used in assembly of ceramic, metal, and plastic electrical components and as coating of high temperature structures requiring corrosion protection. Single part, water-based, silica-filled system offers volume resistivity of 109 ohm-cm and dielectric strength of 250 V/mil at room temperature. Odorless product contains no...