Mini-Circuits

High-Power Bi-Directional Coupler features rugged construction.
Electronic Components & Devices

High-Power Bi-Directional Coupler features rugged construction.

Featuring low loss suspended substrate construction, ZGBDC10-362HP+ coaxial coupler can pass up to 3 A of DC current from input to output and handle up to 250 W CW. IP67-rated, weatherproof case and sealed construction accommodates requirements of field applications or remote monitoring sites. With 0.18 dB insertion loss and 300–3,000 MHz coverage, coupler is also suited for lab testing as well...

Read More »
Coaxial Bandpass Filter covers 1500-1620 MHz range.
Electronic Components & Devices

Coaxial Bandpass Filter covers 1500-1620 MHz range.

SuitableÂ- for transmitters/receivers, harmonic rejection, and lab use, 50 Ω Model NBP-1560+ features fast roll-off, which will attenuate frequencies closer to passband with rejection value of greater than 20 dB. Sharp shape factor helps in adjacent rejection, while rugged connectorized package easily interfaces with other devices and is well suited for test set-ups....

Read More »
Electronic Components & Devices

Miniature Surface Mount Attenuators operate up to 18 GHz.

Housed in 2 x 2 mm package, YAT Series is available in 1 dB increments from 0–10 dB, and with as much as 30 dB attenuation. Fixed surface mount units can handle up to 2 W while still effectively dissipating any heat generated from RF/microwave power. Operating from -40 to +85°C with 50 Ω impedance, RoHS-compliant devices serveÂ- commercial, industrial, and military applications,...

Read More »
Frequency Mixers offer L-R isolation up to 55 dB.
Electronic Components & Devices

Frequency Mixers offer L-R isolation up to 55 dB.

Operating at frequency range of 235 MHz to 4.5 GHz, surface mount Models HJK and LAVI meet specific industry needs at LO power levels of +13 to +23 dBm. Model LAVI-452VH+, featuring dual double-balanced FET quad design for broadband wireless 4G systems, covers signals from 3.22–4.5 GHz with IP3 of 33 dBm typical. With double-balanced FET design, Model HJK-172H+ coversÂ- frequencies from...

Read More »
Coaxial Amplifier offers flat gain and high dynamic range.
Communication Systems & Equipment

Coaxial Amplifier offers flat gain and high dynamic range.

SupportingÂ- use in various applications, ZX60-100VH+ is supplied in miniature shielded rugged case and delivers signals from 300 kHz to 100 MHz at up to 30 dBm output power. This 36 dB coaxial amplifier, operating on single +12 V supply, exhibits gain flatness of ±0.3 dB across full frequency range. RoHS-compliant, unconditionally stable amplifier, suited for use in...

Read More »
SMA Cable Assemblies speed DUT connect/disconnect cycles.
Construction Equipment and Supplies

SMA Cable Assemblies speed DUT connect/disconnect cycles.

Featuring male N-type connector, Quick Lock QBLxSMQ-NM+ Test Cable Assemblies fill wide range of N-to-SMA connection needs from DC to 18 GHz, with max power rating of 270 W at 1 GHz and 47 W at 18 GHz. Assemblies offer optimal electrical performance through 20,000 tough Flex Test™ cycles and 20,000 Quick Lock push on/pull off connection cycles. Available inÂ- lengths of 2, 3, or 6 ft as...

Read More »
High Pass Filter ranges from 9,700-15,000 MHz.
Electronic Components & Devices

High Pass Filter ranges from 9,700-15,000 MHz.

Housed in 3.2 x 1.6 mm EIA 1206 package, 50 Ω Model HFCN-103+ integrates 7 high pass sections in SMT chip form factor. Device features ceramic construction, power handling capability of 8 W, and typical stop bandÂ- rejection of 30 dB. Systems that previously relied on large distributed filter elements to support these lower frequencies can save space and system complexity by integrating...

Read More »
Communication Systems & Equipment

MMIC Amplifier features low noise figure of 0.8 dB typical.

Packaged in 2 x 2 mm case, PMA2-252LN+ is adaptable microwave amplifier designed for 1.5-2.5 GHz receiver applications, from LTE and satellite base stations to GPS and air navigation. It is powered by single 3-4 Vdc supply and features low noise figure of 0.8 dB typical and high IP3 of up to 32 dBm. Packaged in 2 x 2 mm case, amplifier can handle RF input power up to +25 dBm without requiring...

Read More »

All Topics

COVID-19 Response Suppliers COVID-19 Response:
Can Your Company Help Provide Critical Supplies?

We are using the power of our platform to aid in the mass shortage of critical supplies. If your company can help provide supplies, capabilities, or materials for products such as N-95 Masks and Tyvek SuitsPlease let us know.

COVID-19 Response Suppliers