Mini-Circuits
Brooklyn, NY 11235
Low-Noise MMIC Amplifiers meet MIL requirements.
Utilizing E-PHEMT technology, CMA Series is tested to meet MIL requirements for gross leak, fine leak, thermal shock, vibration, acceleration, mechanical shock, and HTOL. Units are housed in 3 x 3 x 1.4 mm ceramic cases that are hermetically sealed and nitrogen filled. Offering thermal performance of -55 to +105Ã-
Read More »Coaxial Amplifier offers flat gain and high dynamic range.
SupportingÃ- use inÃ- various applications, ZX60-100VH+ is supplied in miniature shielded rugged case and delivers signals from 300 kHz to 100 MHz at up to 30 dBm output power. This 36 dB coaxial amplifier, operating onÃ- single +12 V supply, exhibits gain flatness of Ã-
Read More »SMA Cable Assemblies speed DUT connect/disconnect cycles.
Featuring male N-type connector, Quick Lock QBLxSMQ-NM+ Test Cable Assemblies fill wide range of N-to-SMA connection needs from DC to 18 GHz, with max power rating of 270 W at 1 GHz and 47 W at 18 GHz. Assemblies offer optimal electrical performance through 20,000 tough Flex Test™ cycles and 20,000 Quick Lock push on/pull off connection cycles. Available inÃ- lengths of 2, 3, or 6 ft as...
Read More »High Pass Filter ranges from 9,700-15,000 MHz.
Housed in 3.2 x 1.6 mm EIA 1206 package, 50 Ω Model HFCN-103+ integrates 7 high pass sections in SMT chip form factor. Device features ceramic construction, power handling capability of 8 W, and typical stop bandÃ- rejection of 30 dB. Systems that previously relied on large distributed filter elements to support these lower frequencies can save space and system complexity by integrating...
Read More »Wideband SMT Bias Tee covers wide frequency range.
Measuring 3.8 x 3.8 mm, TCBT-14+ wideband Bias-Tee enables engineers to design with DC current up to 200 mA, insertion loss of less than 1 dB, and VSWR of 1.1:1. It covers frequencies from 10 MHz to 10 GHz without resonances typically observed over such a range. Suitable for automated pick and place operation, surface-mount product is designed to handle 1 W of RF power.
Read More »USB-Powered Frequency Counter has wide RF frequency range.
Operating over frequency range of 1-6,000 MHz, UFC-6000 includes USB interface that allows remote display of measured frequencies. At 6.16 X 3.68 X 1.38 in., device has rugged shielded case with 16 x 2 character LCD screen as well as reference input BNC(F) port and signal input SMA(F) port. Also included are 2.7 ft USB cable and power adaptor suitable for US and EU power systems with USB A female...
Read More »Frequency Synthesizer supports GSM applications.
Measuring 0.910 x 0.910 x 0.252 in., Model RSN-1618AF-119+ is packaged in metal case to shield against unwanted signals and noise. Unit operates from 1,543-1,618 MHz and features max settling time of 35 Ã-µsec. With components secured to substrate using chip adhesive in addition to solder, surface mount synthesizer can be used as local oscillator in up-conversion and down-conversion sections...
Read More »USB Power Sensor features 75 ohm impedance.
Measuring 4.89 x 1.74 x 0.95 in., Model PWR-2.5GHS-75 turns WindowsÃ-® or LinuxÃ-® PC into power meter. Pocket-sized HID requires no driver installation and is shipped with quick-locking USB cable for connectivity. Measurement Application GUI software, displaying numerical data and graphs, enables user to perform measurements on RF components such as couplers, filters, amplifiers.
Read More »Free Webinar: Mixers and Frequency Conversion
When: Tuesday, May 20th at 11:00 AM ET Where: Presented online by Microwave Journal. Register now at: http://www.microwavejournal.com/events/1225 Speaker: Allen Podell, IEEE Life Fellow Presentation Abstract: Frequency conversion is a critical function in all wireless systems. A key component used to accomplish this is the mixer. Designers need to understand different mixer topologies and...
Read More »Mini-Circuits is Pleased to Participate in IMS2014 as a Gold Sponsor
The 2014 IEEE International Microwave Symposium. June 1 – 6, 2014. Tampa Bay Convention Center, Tampa Bay, FL. Visit Mini-Circuits at booth 823!. Mini-Circuits is proud to sponsor the 2014 International Microwave Symposium in Tampa, Florida.Ã- Our representatives will be at booth 823 exhibiting a showcase of our latest products including custom rack-mount test equipment, portable signal...
Read More »Check Out Our Reference Designs Index: Mini-Circuits Models Supporting Over 80 Integrated Circuits!
Mini-Circuits has created an online index of more than 80 integrated silicon reference designs and corresponding recommended Mini-Circuits models.Ã- This resource makes it quick and easy to find the Mini-Circuits components suggested for use with the ICs in your system. Use the simple table on our reference designs page (shown below) to locate the integrated circuit used in your system,...
Read More »New Mini-Circuits SATCOM Product Guide Published in Print and Online!
Mini-Circuits has released our new SATCOM Product Guide in print and for download from our website. This 32-page guide features a full survey of components and assemblies for satellite and earth station systems. With selected products from over 20 different product types to 40 GHz, the guide provides key performance parameters for each product and serves as a handy reference for engineers...
Read More »Low-Noise MMIC Amplifiers meet MIL requirements.
Utilizing E-PHEMT technology, CMA Series is tested to meet MIL requirements for gross leak, fine leak, thermal shock, vibration, acceleration, mechanical shock, and HTOL. Units are housed in 3 x 3 x 1.4 mm ceramic cases that are hermetically sealed and nitrogen filled. Offering thermal performance of -55 to +105Ã-
Read More »Free Webinar: Passive Components: Dividers, Couplers, Combiners
Where: Presented online by Microwave Journal.Ã- Register now at: http://www.microwavejournal.com/events/1126 Speaker: Dr. Robert Froelich, Besser Associates, Inc. Presentation Topic: Power Dividers 2-way, 3-way, and N-way Isolation and loss Phase relationships Uneven power division Combining RF power Directional Couplers Properties Coupling, Isolation, and Directivity Power Splitters and...
Read More »Free Webinars From Minicircuits.com
As part of our commitment to supporting customers and industry practitioners with information that adds value to your work, we’re adding a new page to our website where you can access free webinars on topics from VCOs to MMIC amplifier design to test equipment applications, and more. How to use our new webinar library: From our home page, navigate to “Applications” on the menu bar and...
Read More »VCO Fundamentals, A Free Webinar
When: Tuesday, October 15th, 2013 at 11:00 AM EDT Where: Presented online by Microwave Journal.Ã- Register now at: http://www.microwavejournal.com/events/1114 Speaker: John McNeill, Director of the New England Center for Analog and Mixed Signal Integrated Circuit Design (NECAMSID), Worcester Polytechnic Institute Presentation Abstract: This webinar will cover the fundamentals of voltage...
Read More »Mini-Circuits to Sponsor IEEE COMCAS 2013
The International IEEE Conference on Microwaves, Communications, Antennas and Electronic Systems David Intercontinental Hotel, Tel Aviv, Israel October 21 – 23, 2013 Event Website: http://www.comcas.org/Ã- Mini-Circuits is pleased to contribute to the 2013 IEEE Conference on Microwaves, Communications, Antennas, and Electronic Systems as a platinum sponsor.Ã- Our representatives from...
Read More »Free Technical Education Webinar - MMIC Amplifier Design Approaches
Date and Time:Ã- Tuesday, September 17th, 2013 at 11:00 AM EDT Where: Presented online by www.microwavejournal.com/events. Register now atÃ- http://www.microwavejournal.com/events/1110. Speaker: Ted Heil, Vice President and Chief Operating Officer, Mini-Circuits Presentation Abstract: This webinar offers an insight into MMIC amplifier design approaches, from semiconductor technology...
Read More »