Analog Devices, Inc.

Electrical Equipment & Systems

SAR ADCs suit medical imaging and DAQ systems.

Along with 92 dB SNR, AD7626 PulSAR® ADC achieves 16-bit data capture performance with 15-bit ENOB (effective number of bits) and 10 MSPS throughput. It can also be multiplexed for applications that do not require full 10 MSPS data rates, consumes 130 mW of power, and uses self-clocked LVDS bus. Model AD7625 operates at 6 MSPS. Both 16-bit SAR (successive-approximation register) ADCs come...

Read More »
Sensors, Monitors & Transducers

Inertial Sensor reduces motion control design complexity.

Supplied in 23 mmÂ-³ package, ADIS16365 combines 3 gyroscopes and 3 accelerometers to provide 6 degrees-of-freedom motion sensing. It immediately detects small shifts in position of GPS antenna, promoting real-time signal correction and heading accuracy. Fully calibrated and compensated for various sensitivities, product reduces design time/complexity with automatic sensor point-of-reference...

Read More »
Communication Systems & Equipment

RF Power Detector, Log Amp promote wireless performance.

Integrated crest-factor RF power detection IC, ADL5502, combines rms RF detector and envelope detector. Featuring ±0.1 dB accuracy with crest factors up to 11 dBm, it enables cell phone designers to manage wireless handset power, extend battery life, and process complex 3G/4G signals. Logarithmic amplifier, ADL5513, offers 80 dB dynamic range with ±3 dB log conformance up to 4 GHz to...

Read More »
Communication Systems & Equipment

Differential Amplifiers can drive 14- and 16-bit ADCs.

Consuming less than 120 mW of power on single 3.3 V supply, single channel ADA4939-1 and dual channel ADA4939-2 differential amplifiers achieve 82 dB SFDR at 70 MHz. Operating over -40 to 105°C temperature range for both 3.3 and 5 V operation, units feature input voltage noise of 2.3 nV/rt Hz, -3 dB bandwidth of 1.4 GHz, and slew rate of 5,000 V/Â-µS. Model ADA4939-2 can drive dual...

Read More »
Controls & Controllers

Microcontrollers have ADC noise performance of 60 nV.

Including 3 models, Series ADuC706x analog MCUs consume 2.6 mA and handle 4-20 mA loop-powered applications in factory automation and precision instruments. Featuring 24-bit sigma-delta ADCs and ARM7 core with 8 interrupt priority levels, units also incorporate 32 Kb of flash memory and 4 Kb of SRAM, programmable gain amplifier, multiplexers, buffers, auxiliary 24-bit ADC for cold junction...

Read More »
Communication Systems & Equipment

IC Pair acts as direct conversion receiver solution.

Quadrature demodulator (ADL5380), operating from 400 MHz to 6 GHz, and companion 2-channel digital gain trim amplifier (AD8366) enable and integrate direct conversion radio receivers in cellular 3G/4G and broadband wireless 802.16 applications. With ADL5380, base station receivers can be designed for various cellular and broadband wireless data systems and standards. Features for AD8366 include...

Read More »
Electrical Equipment & Systems

Sigma-Delta Converter targets 900 MHz band RF applications.

Operating from 840-960 MHz, Model ADF9010 integrates Tx quadrature modulator with integer-N synthesizer and on-chip VCO, achieving LO phase noise of -140 dBc/Hz at 1 MHz offset. Rx low pass filter gain is programmable from 3-24 dB in 3 dB steps. Filter features 4 programmable modes, with auto-calibrated cutoff frequencies of 330 kHz, 880 kHz, and 2 MHz. Transmit path delivers OIP3 of 24 dBm,...

Read More »
Agricultural & Farming Products

Digital Isolators suit electric-hybrid automotive systems.

AEC-Q100-qualified for -40 to +125°C operation, ADuM120xW 2-channel, ADuM130xW 3-channel, and ADuM140xW 4-channel digital isolators are designed for motor drives and battery management systems. They provide multiple isolation channels in various configurations and data rates up to 25 Mbps. Based on iCoupler® chip-scale micro-transformer technology, units include digital interface and...

Read More »
Agricultural & Farming Products

Four-Channel Devices isolate both data and power.

Housed in 10 x 10 mm surface mount package, ADuM540x Series integrates iCoupler® digital isolation technology and isoPower(TM) DC-DC converter, which provides up to 500 mW of regulated, isolated power and can operate at 5.0 or 3.3 V. Based on chipscale transformers, iCoupler digital isolators condition and drive data across transformers, while isoPower converter employs switches,...

Read More »
Electrical Equipment & Systems

Analog Output Drivers optimize process control applications.

Designed to condition output of low-voltage, single-supply DAC, Models AD5750 and AD5751 can drive resistive loads up to 1.5 kW, capacitive loads up to 1 Â-µF, and inductive loads up to 0.1 h. Units achieve accuracy level of 0.1% TUE under all operating conditions. Model AD5750 operates from dual ±12 V to ±24 V supplies, while Model AD5751 operates from single 10.8-60 V supply....

Read More »

All Topics