SSAC, Inc.
Wichita Falls, TX 76302
Voltage Monitor has 22 mm DIN rail mounting enclosure.
CM-MPS Series voltage monitor provides 3-phase motor protection in euro-style enclosure with built-in finger safe, double chamber, and terminal blocks that allow positive connections when 2 different wire sizes are used. Series monitors phase-to-phase voltages and protects against failure caused by phase loss, phase reversal, undervoltage, overvoltage, and unbalanced voltages. Features include...
Read More »
Time Delay Relays offer 21 timing functions.
Series TRDU plug-in, switch adjustable, multifunction relays offer time delays from 0.1 sec to over 1,705 hr in 8 ranges. Timing accuracy is Ã-
Read More »
Motor Starter accommodates two wiring configurations.
PSS Softstarter can be connected both inline and inside the delta configuration. When connected inside the delta, PSS can replace wye delta starters and be sized to 58% of the motor horsepower rating. Reduced rating results in smaller starter, saving space and money. Compact Line offers 3-25 A at 230-600 Vac motor softstarting and control voltages of 24-110 Vac/dc, 100-480 Vac. Flexible Line is...
Read More »
Liquid Level Control suits low level cutoff protection.
Single probe LLC8 series uses AC current sensing to prevent thermal runaway and excessively high internal pressure in hot water tanks by detecting presence of conductive liquids. With open board design and UL353 recognition, it offers factory fixed time delay of 1-60 sec and is available for input voltages of 24, 120, or 230 Vac, 50/60 Hz. Sense resistance is factory fixed from 5K-250K ohms. SPDT...
Read More »
Timer/Counter Module comes with choice of 12 functions.
NHPU Series ProgramaCube(TM) is pre-manufactured without function assigned. Functions, time ranges, and count ranges can be created without designing new module. Unit switches motors, lamps, and heaters directly, without addition of contactor. Switch-adjustable time delays of 0.1 sec to 1023 hrs in 6 ranges or 3 counting functions/ranges is available. NHPU can be ordered with 6, 10, or 20 A...
Read More »
Voltage Monitor protects three phase equipment.
PLM Series voltage monitor meets or exceeds NEMA Standards for phase loss, unbalance, and undervoltage protection. It provides motor protection even when regenerative voltages are present. Monitor is available for operating voltages of 240, 380, and 480 Vac, 50-100 Hz, and with 35 mm DIN rail or surface mountable sockets rated 600 V. PLM Series is tested to IEEE C62.41-1991 Level B surge...
Read More »
Timing Modules are programmed at factory.
Functions, features, and options for Models KSPD, KSPS, and KSPU Series of ProgramaCube(TM) solid state output timing modules are programmed in software. When order is received, software function is added, so modules are readily available. KSPD is available in 11 fixed, knob, or external adjustable dual timer functions; KSPS is available in 10 fixed, knob, or external adjustable single functions;...
Read More »
Liquid Level Control provides low liquid cutoff protection.
LLC6 Series plug-in, single probe control uses small ac current to sense presence of conductive liquid in tanks. It offers factory fixed time delay of 1 to 60 sec and is available for input voltages of 24, 120, or 230 Vac, 50/60 Hz. Rated 10 A resistive at 240 Vac, SPDT relay contacts are isolated from operating and probe voltages. Unit is available with manual/automatic reset or manual reset...
Read More »
AC Current Sensor requires no external power.
Loop powered DCSA Series linear output current transformer provides output that is directly proportional to rms ac current passing through external LCSC10T12 toroidal sensor. Output can be 4-20 mA, 1-5 Vdc, or 2-10 Vdc. It is available in ranges of 0-5, 0-10, and 0-50 A, making it suitable for measuring current draw on motors, fans, lamps, heaters, solenoids, and valves. The 0-5 A range allows...
Read More »
Level Control provides cutoff protection.
LLC8 Series plug-in single probe liquid level control protects equipment and commercial appliances that use conductive liquids to produce hot water or steam, such as boilers and steamers. It uses small ac current to sense presence of water in tank. As long as water is in contact with probe, heating element can operate. It has time delay of 1 to 60 sec, is available for input voltages of 24, 120,...
Read More »
Voltage Monitor has 22 mm DIN rail mounting enclosure.
CM-MPS Series voltage monitor provides 3-phase motor protection in euro-style enclosure with built-in finger safe, double chamber, and terminal blocks that allow positive connections when 2 different wire sizes are used. Series monitors phase-to-phase voltages and protects against failure caused by phase loss, phase reversal, undervoltage, overvoltage, and unbalanced voltages. Features include...
Read More »
Time Delay Relays offer 21 timing functions.
Series TRDU plug-in, switch adjustable, multifunction relays offer time delays from 0.1 sec to over 1,705 hr in 8 ranges. Timing accuracy is Ã-
Read More »
Motor Starter accommodates two wiring configurations.
PSS Softstarter can be connected both inline and inside the delta configuration. When connected inside the delta, PSS can replace wye delta starters and be sized to 58% of the motor horsepower rating. Reduced rating results in smaller starter, saving space and money. Compact Line offers 3-25 A at 230-600 Vac motor softstarting and control voltages of 24-110 Vac/dc, 100-480 Vac. Flexible Line is...
Read More »
Liquid Level Control suits low level cutoff protection.
Single probe LLC8 series uses AC current sensing to prevent thermal runaway and excessively high internal pressure in hot water tanks by detecting presence of conductive liquids. With open board design and UL353 recognition, it offers factory fixed time delay of 1-60 sec and is available for input voltages of 24, 120, or 230 Vac, 50/60 Hz. Sense resistance is factory fixed from 5K-250K ohms. SPDT...
Read More »
Timer/Counter Module comes with choice of 12 functions.
NHPU Series ProgramaCube(TM) is pre-manufactured without function assigned. Functions, time ranges, and count ranges can be created without designing new module. Unit switches motors, lamps, and heaters directly, without addition of contactor. Switch-adjustable time delays of 0.1 sec to 1023 hrs in 6 ranges or 3 counting functions/ranges is available. NHPU can be ordered with 6, 10, or 20 A...
Read More »
Voltage Monitor protects three phase equipment.
PLM Series voltage monitor meets or exceeds NEMA Standards for phase loss, unbalance, and undervoltage protection. It provides motor protection even when regenerative voltages are present. Monitor is available for operating voltages of 240, 380, and 480 Vac, 50-100 Hz, and with 35 mm DIN rail or surface mountable sockets rated 600 V. PLM Series is tested to IEEE C62.41-1991 Level B surge...
Read More »
Timing Modules are programmed at factory.
Functions, features, and options for Models KSPD, KSPS, and KSPU Series of ProgramaCube(TM) solid state output timing modules are programmed in software. When order is received, software function is added, so modules are readily available. KSPD is available in 11 fixed, knob, or external adjustable dual timer functions; KSPS is available in 10 fixed, knob, or external adjustable single functions;...
Read More »
Liquid Level Control provides low liquid cutoff protection.
LLC6 Series plug-in, single probe control uses small ac current to sense presence of conductive liquid in tanks. It offers factory fixed time delay of 1 to 60 sec and is available for input voltages of 24, 120, or 230 Vac, 50/60 Hz. Rated 10 A resistive at 240 Vac, SPDT relay contacts are isolated from operating and probe voltages. Unit is available with manual/automatic reset or manual reset...
Read More »
AC Current Sensor requires no external power.
Loop powered DCSA Series linear output current transformer provides output that is directly proportional to rms ac current passing through external LCSC10T12 toroidal sensor. Output can be 4-20 mA, 1-5 Vdc, or 2-10 Vdc. It is available in ranges of 0-5, 0-10, and 0-50 A, making it suitable for measuring current draw on motors, fans, lamps, heaters, solenoids, and valves. The 0-5 A range allows...
Read More »
Level Control provides cutoff protection.
LLC8 Series plug-in single probe liquid level control protects equipment and commercial appliances that use conductive liquids to produce hot water or steam, such as boilers and steamers. It uses small ac current to sense presence of water in tank. As long as water is in contact with probe, heating element can operate. It has time delay of 1 to 60 sec, is available for input voltages of 24, 120,...
Read More »