Abbeon Cal Inc.
Unit 1
Ventura, CA 93003
Round Knife Cutters handle technical textiles and composites.
Equipped with 350 W motor, Monster Slitter TASW12M is suitable for cutting composite materials such as glass fiber, carbon fiber, Aramid, or any soft material up to 2 in. thick. Model TADD120DT, equipped with 3-phase induction motor, uses 8-sided 120 mm knife to cut thicknesses up to 2 in. Direct-drive, bi-directional- unit can reach speeds of 2,600 rpm. Both models have push button sharpening...
Read More »Automatic Bending Machine handles thin plastic sheets.
With 4 ft 5 in. working length, Model AFF135 handles plastic sheets from .007–.039 in. thick. Machine includes adjustable electronic heating element that can also be controlled in contact-time. Material is heated by Teflon-coated sword, which can be replaced with different sizes, so that radius can be changed accordingly. Using protractor, angle of bend can be set from 0–180-
Read More »Electrolysis-Based Heat Source offers safe, reliable operation.
By making hydrogen and oxygen- via electrolysis of distilled water, Aquaflame 800 produces controllable and efficient heat source. Sole byproduct is water, and unit- works without gas cylinder storage. Addition of deionized water, potassium hydroxide crystals, and- MEK is occasionally required, and optional battery-operated torch lighter is available. Uses include acrylic flame polishing,...
Read More »
Adjustable Bending Fixture holds products at set angle.
With Model ARK125FX, bent items can be cooled down at any set angle. Extended versions with double adjusting-angle are also available. Fixture is provided with 2 adjustable parallel stops to hold products into right angle. Both sides of jig are open to slide products out of fixture when complicated item is made.- Using protractor at either side of fixture, users can set jig at desired angle....
Read More »Electronic Thermocutter weighs 11-½ oz.
With transformer replaced by high-tech electronics, AZTC-20 electronic thermocutter cuts synthetic fabrics, plastic tubes, fiber optics, foam and similar materials that tend to crimp, serrate or unravel when cold cutters are used. Temperature in unit is controlled from zero to 1050-ºF, while electrical current control switch allows selection of large blades. Cutting foot accessory lifts...
Read More »