Company News

Vishay

63 Lancaster Ave., Malvern, PA, 19355, USA

  • 610-644-1300

Latest New Product News from
Vishay

Electronic Components & Devices, Green & Clean, Materials & Material Processing

Single-Line ESD Protection Diode offers 14 pF capacitance.

Jun 22, 2012

Bidirectional symmetrical single-line ESD protection diode, with working voltage of ±7 V and leakage current of less than 0.1 µA, is suitable for use with portable electronics. Product features maximum clamping voltage of 15 V at 4 A. Measuring 1.0 x 0.6 mm, with profile of 0.38 mm in LLP1006-2L package, it is able to clamp ESD strikes with minimal over- or undershoots. Surge current... Read More

Electronic Components & Devices

Panel Potentiometer incorporates variable resistor and switch.

Jun 20, 2012

Featuring fully sealed, panel-sealed construction, Sfernice P16S consists of knob driving that incorporates cermet or conductive plastic potentiometer. Only mounting hardware and terminals are situated on back side of panel. Unit offers power rating to 1 W at +40°C and TCR of ±150 ppm/°C typical, with dielectric strength of 2.5 kVrms. Available in 7 mm bushing length with 16 mm knob... Read More

Electronic Components & Devices, Sensors Monitors & Transducers

Proximity, Ambient Light Optical Sensor has 16-bit resolution.

Jun 20, 2012

In one 4.8 x 2.3 x 0.8 mm package, VCNL4020 combines IR emitter, photo-pin-diode, ambient light detector, signal processing IC, and 16-bit ADC. Sensor supports I²C bus communication interface and can function at any depth or air gap below glass window. Exhibiting cross talk immunity, product integrates energy conservation capabilities as well as interrupt function, is capable of detection... Read More

Electronic Components & Devices, Sensors Monitors & Transducers

Optical Sensor IC provides 16-bit resolution.

Jun 19, 2012

Housed in 4.8 x 2.3 x 0.8 mm package, Model VCNL4020 integrates IR emitter, photo-pin-diode for proximity, ambient light detector, signal processing IC, and 16-bit ADC. Unit offers programmable LED drive current from 10-200 mA in 10 mA steps, allowing object detection up to 200 mm. IC includes interrupt function and supports I²C bus communication interface. Featuring standby current... Read More

Communication Systems & Equipment

Multilayer Ceramic Chip Antennas operate at 868 and 915 MHz.

Jun 19, 2012

Complying with MBRAI standard for portable communication, 868 MHz Models VJ5301M868MXBSR and VJ5601M868MXBSR measure 35 x 5 x 1.2 mm, while 915 MHz Models VJ5601M868MXBSR and VJ5601M915MXBSR have 15.5 x 10.5 x 1.2 mm outline. Surface mount antennas feature 50 W unbalanced tuning interfaces and operating temperature of -40 to +85°C. Halogen-free per IEC 61249-2-21,... Read More

Electronic Components & Devices, Optics & Photonics

Phototriac Optocouplers feature blocking voltage of 600 Vac.

Jun 13, 2012

Housed in miniflat SOP-4 package with 2.0 mm height, VOM160 and VOM305x Series offer input trigger LED current of 5, 7, and 10 mA. Non-zero crossing phototriac optocouplers turn motors and solenoid controls on/off in refrigerators, lamps, washers, and coffee makers. Models VOM3052T and VOM3053T, with static dV/dt of 1,500 V/µs, are well suited for noisy environments where lower dV/dt can cause... Read More

Green & Clean, Optics & Photonics

Non-Zero Crossing Phototriac Optocouplers come in Green package.

Jun 12, 2012

Supplied in miniflat SOP-4 package with 2.0 mm profile, VOM160 and VOM305x series offer 3 choices of input trigger LED current: 5 mA (VOM160NT/VOM3053T), 7 mA (VOM160PT), and 10 mA (VOM160RT/VOM3052T). Blocking voltage is 600 Vac, and static dV/dt is 500 or 1,500 V/µs. In addition to being used for turning on/off motors and solenoid control in refrigerators, washers, lamps, and coffee makers,... Read More

Sensors Monitors & Transducers

SMD 940 nm Reflective Optical Sensor has 0.2-5 mm range.

Jun 08, 2012

Supplied in 3.4 x 2.7 x 1.5 mm package, TCNT2000 utilizes 940 nm emitter chip and provides typical CTR of 4%. Construction features emitting light source and silicon phototransistor detector arranged in same plane, and analog output signal is triggered by detection of reflected IR light. Designed for optical encoding and switching, product can also serve as position sensor and incorporates... Read More

Electronic Components & Devices

Panel Potentiometer allows easy access to controls.

Jun 05, 2012

Featuring compact, fully sealed, and panel-sealed construction, Sfernice P16S potentiometer includes variable resistor and switch incorporated into built-in knob. Mounting hardware/terminals are situated on back side of panel which keeps required clearance to a minimum, making it ideal for small, low-profile, low-weight equipment. Device offers power rating to 1 W at +40°C and TCR of ±150... Read More

Electronic Components & Devices

N-Channel Power MOSFETs offer ultra-low on-resistance.

May 10, 2012

Featuring high-voltage stripe technology and currents from 3-36 A, D Series includes 400, 500, and 600 V MOSFETs with on-resistance down to 0.17, 0.13, and 0.34 W and gate charges down to 9, 6, and 45 nC, respectively. RoHS-compliant and halogen-free according to IEC 61249-2-21 definition, devices save energy in high-power switch mode applications, including server and telecom power systems,... Read More

Electronic Components & Devices

N-Channel Power MOSFETs feature low on-resistance.

May 09, 2012

Rated at 30 V, TrenchFET® Gen IV Series demonstrates extremely low RDS(on) values down to 1.0 mW at 10 V and 1.35 mW at 4.5 V. Models SiRA00DP, SiRA02DP, and SiRA04DP are housed in 6.15 x 5.15 mm PowerPAK SO-8 package, while Model SiSA04DN comes in 3.30 x 3.30 mm PowerPAK 1212-8 package. All devices offer low Qgd/Qgs ratio of 0.5 or less. Applications include high power density DC/DC... Read More

Electronic Components & Devices

High-Voltage Power MOSFETs offer on-resistance down to 0.130 ohm.

May 02, 2012

Promoting efficiency and power density, D Series uses stripe design that lowers total gate charge while increasing switching speed and reducing on-resistance and input capacitance. These 400 V, 500 V, and 600 V devices respectively feature on-resistance down to 0.17, 0.13, and 0.34 ohm; gate charges down to 9, 6, and 45 nC; and gate charge times on-resistance values down to 7.65, 15.6, and... Read More

Electronic Components & Devices

Thin Film Resistor Networks come in 14 or 16-pin SOIC packages.

May 01, 2012

NOMCA series of dual-in-line thin film resistor networks features low absolute TCR of ±25 ppm/°C, TCR tracking of 5 ppm/°C, ratio tolerances to ±0.05%, and long-term ratio stability of 0.05% after 1,000 hours at +125ºC. For improved ESD and moisture protection, resistor networks are constructed with self-passivating tantalum nitride resistor film on high-purity alumina or ceramic... Read More

Communication Systems & Equipment

IR Receivers are designed for 3D TV eyewear.

Apr 24, 2012

TSMP6000 and TSMP77000 are surface-mount IR receivers designed to receive any infrared signal used for 3D TV synchronization, simplifying design of universal 3D TV eyewear. They feature reception of raw IR 3D synchronization signals between 20-60 kHz and 800-1000 nm in wavelength. Receivers integrate photodiode, amplifier, and signal conditioning IC into a single tiny package that helps minimize... Read More

Electronic Components & Devices

Thin Film Resistor Networks are AEC-Q200-qualified.

Apr 23, 2012

Constructed with self-passivating tantalum nitride resistor film on high-purity alumina or ceramic substrate, NOMCA Series features low absolute TCR of ±25 ppm/°C, TCR tracking of 5 ppm/°C, tight ratio tolerances to ±0.05 %, and long-term ratio stability of 0.05% after 1,000 hours at +125°C. Dual in-line networks offer 7 or 8 isolated resistors of equal value in 14- or 16- pin SOIC... Read More

Communication Systems & Equipment, Optics & Photonics

Remote Control IR Receiver offers low, 0.8 mm profile.

Apr 20, 2012

TSOP57x series of remote control infrared receivers combine height of 0.8 mm, wide angle of sensitivity of 150°, and receiving distance of 40 m. At an off-axis angle of 45°, receiver retains 85% of on-axis sensitivity. Noise suppression technology has peak sensitivity of 940 nm and offers modulation frequencies of 36 kHz, 38 kHz, 40 kHz, and 56 kHz. Receivers do not use lens and are... Read More

Electronic Components & Devices

Thick Film Resistor offers 1,100 W from 57 x 60 mm footprint.

Apr 19, 2012

Non-inductive LPS1100 provides resistance range from 1 W to 1.3 kW and offers offers power rating of 1,100 W at heat sink temperature of 25°C. Thermal resistance at rated power of 25°C is 0.039 °C/W junction-to-case. Device features temperature coefficient of ±150 ppm/°C, tolerances from ±1 to ±10%, and operating... Read More

Electronic Components & Devices

Compact Thick Film Resistor has power rating of 1,100 W.

Apr 19, 2012

Supplied in 57 x 60 x 25 mm package, LPS1100 offers power rating of 1,100 W at heat sink temperature of +25°C. Non-inductive (less than 0.1 µH) solution, providing resistance range of 1 ohm to 1.3 kohm, features dielectric strength to 12 kVRMS and overload capability of up to 2,200 W for 10 sec. Operating from -55 to +200°C, RoHS Directive 2011/65/EU-compliant product exhibits thermal... Read More

Electronic Components & Devices

High-Voltage Avalanche Rectifier comes in low-profile package.

Apr 06, 2012

Supplied in SMT plastic DO-214AC package, BYG23T avalanche rectifier combines 1.98 mm profile with reverse voltage of 1,300 V and 75 nsec reverse recovery time. Other properties include low typ reverse current of 2.9 µA at +125°C, 5 mJ pulse energy in avalanche mode, forward current of 1.0 A, and forward voltage of 1.39 V at 1 A and +125°C. Rectifier is optimized for high-voltage,... Read More

Optics & Photonics

ATEX-Certified Optocoupler serves potentially explosive areas.

Apr 05, 2012

Supplied in 17.8 x 9.6 x 6.1 mm plastic package, CNY65Exi meets EU ATEX 94/9/EC directive for operation in potentially explosive atmospheres while offering isolation voltage of 11,600 V and comparative tracking index of 475. IR light transmits data and control signals from typically low-voltage control side to high-voltage equipment, and emitter and detector are separated by distance of greater... Read More