Brooklyn, NY 11232
Thermally Conductive Adhesive Duralco 132 Dissipates Heat up to 500
Duralco 132 thermally conductive adhesives combine Cotronics' unique, high temperature resins with highly conductive fillers to form thermally conductive, adhesive bonds with continuous service up to 500-Read More »
Thread-Locker Gel provides seals at up to 2,100
Resbond 907TSG Thread-Locker Gel provides thermally stable, electrically insulating, and chemical- and corrosion-resistant seals and is designed for pipe, screws, nuts, bolts, fasteners, etc. Curing at room temperature, Mil-I-45208 gel is packaged in 4 oz applicator bottles, each providing up to 2,000 applications. It is available in Blue Standard for general purpose, Red High Strength for...Read More »
Hand-held Applicator Dispenses Electrically Conductive 400ºF Flexible Epoxy with Pinpoint Accuracy
Duralco 125 Stress Free epoxy forms a flexible, electrically conductive bond for continuous use to 400-ºF. Ideal for manufacturing and repairing of flexible circuits, solder replacement, bonding semi-conductors, EMI shielding, thermistors, wire tacking, heating elements, assembling, electronics, etc. Duralco 125 offers 400-ºF service and provides outstanding electrical conductivity, high bond...Read More »
Ceramic-Based Sealer forms gas-tight seals.
Suited for applications up to 1,800-Read More »
Low-Expansion, Low-Odor Epoxy cures at room temperature.
Resistant to electricity, chemicals, and moisture, Duralco(TM) 4463 is 100% solid system that exhibits dimensional stability and adheres to glass, ceramics, metals, and plastics. This 500-Read More »
Low Expansion Epoxy withstands temperatures to 500
Offering dimensional stability, Duralco(TM) 4463 consists of 100% solid system that is mixed, applied, and cured at room temperature. Product resists electricity, chemicals, and moisture. With low odor and no VOCs, epoxy adheres to most glass, ceramics, metals, and plastics, and is suitable for bonding and encapsulated applications.Read More »
Epoxy forms high-temperature bonds for plastics.
Able to adhere to plastic surfaces as well as metals, ceramics, and glass, Bond-It 7050 bonds to Nylon, PVC, and dissimilar/difficult-to-bond materials. No special surface preparation is required. Users mix and apply, and product cures at room temperature to form 400-Read More »
Alumina Adhesive can be used in applications up to 3,000
Resbond(TM) 989F combines 600 nm, Ultra Fine Alumina with high temperature colloidal ceramic binders. When cured at room temperature or in 5 min at 200-ºF, material exhibits electrical, moisture, chemical, and solvent resistance. Single-component material adheres to metals, ceramics, graphite, or glass and can be used in fine dispensers without clogging or mess. It can bond super fine electric...Read More »
Bonding Adhesive holds up to 450 F.
Bond-It 007 adheres to smooth, rough or porous surfaces. Curing in minutes at room temperature without odor, adhesive features consistency thick enough to hold parts together while drying without molds, fixtures, or clamps. There is no sagging or dripping following application. Adhesive is packaged in self mixing dispensing cartridges and attaches ceramics to metals, brake pads to metals, and...Read More »
Repair Epoxy forms machinable aluminum layer.
Packaged in pre-measured job sized kits, 450-Read More »