Aprima Medical Software, Inc

Fluorescent Light shines from top to bottom.
Architectural & Civil Engineering Products

Fluorescent Light shines from top to bottom.

HBS100 series industrial fluorescent fixture illuminates horizontally and vertically, eliminating shadows on high warehouse shelves. Luminance does not significantly degrade, delivering consistent light over entire 20,000-hour life span. Unit can replace HID luminaries in warehouses and factories. It is available in 3, 4, or 5 lamp configurations and open strip, with wire guard, or with...

Read More »
Water Unions feature widely spaced ball bearings.
Fluid & Gas Flow Equipment

Water Unions feature widely spaced ball bearings.

6000 Series Water Unions feature cartridge seal that allows on-machine replacement with no need to remove hose connections or use special tools. Repair can be conducted by removing 6 hex bolts and end cap, removing cartridge seal and rotor seal face, and replacing. Unions have balanced mechanical seal with carbon against tungsten carbide seal faces for reduced friction and wear. Widely spaced...

Read More »
Infrared Thermometers have laser guide for accurate sighting.
Test & Measurement

Infrared Thermometers have laser guide for accurate sighting.

Models CA870, CA872 and CA876 non-contact infrared instruments measure temperature in °F and °C. They have 3-1/2-digit backlit LCD display, auto-hold function and auto power off. Model CA876 includes type K thermocouple for taking temperature measurements in areas not suitable for infrared. It also offers MIN and MAX recording, LO and HI alarm, and adjustable emissivity from 0.1 to...

Read More »
Case Sealer can convert to 2 in. or 3 in. tape requirements.
Adhesives & Sealants

Case Sealer can convert to 2 in. or 3 in. tape requirements.

Little David Random Legend Series Case Sealer uses pressure sensitive tape to seal top and bottom of boxes. It tapes boxes ranging from 3 to 24 in. high, 4 1/2 to 22 in. wide, and from 3 in. in length. Side and lock leg extensions accommodate conveyor heights from 22 1/4 to 32 1/4 in. Sealed drive system and CaseLocker ST cartridge require no lubrication. Sealer features single mast design with...

Read More »
Torque Sensors are designed for low torque applications.
Sensors, Monitors & Transducers

Torque Sensors are designed for low torque applications.

STS2220 rotary shaft torque sensors are available in capacities from 1.0 to 10.0 Nm. They feature one-piece outer housings and pre-lubricated bearings, and accept either AC or DC excitation voltage for compatibility to most readout instruments. Units have 1.5 mV/V nominal output at rated capacity, bridge resistance of 350 ohms, maximum speed of 10,000 rpm, and non-linearity of +/- 0.1% of full...

Read More »
Three-Chip Camera provides digital output.
Optics & Photonics

Three-Chip Camera provides digital output.

IK-TU51 3 CCD camera provides 10-bit digital signal, eliminating need for frame grabber. It is suitable for machine vision, microscopy and broadcast applications. Camera has digital signal processors, RGB analog output, interchangeable 1/2 or 1/3 in. remote heads, broadcast-level resolution of 800 TVL, 6-vector color-enhancement circuitry, and pulse triggers. HAD CCDs improve camera sensitivity...

Read More »
Multiple Stage Valve is suitable for vacuum systems.
Fluid & Gas Flow Equipment

Multiple Stage Valve is suitable for vacuum systems.

Compact ILP two-stage valve includes pneumatically-actuated poppet valve and bypass valve in single unit that fits into tight space constraints found in vacuum applications, such as loadlock and transfer chambers in semiconductor or optical processing. Soft start process reduces turbulent flow during initial vacuum system evacuation, for less product contamination and damage. Heater jacket is...

Read More »
Fluid Bed Drying System recycles exhaust air.
Fluid & Gas Flow Equipment

Fluid Bed Drying System recycles exhaust air.

Drying system recycles 75% of heated exhaust air through continuous pulse jet dust collector and reheats it in natural gas burner, during drying of rice, salt, limestone, sawdust, polymers, inorganic chemicals and other products that require temperatures of 150+ Â-ºF. System permits process to operate at high outlet moisture while staying comfortably above dew point of final exhaust air.

Read More »

All Topics