Aprima Medical Software, Inc

Foot Switches are suitable for hostile environments.
Electrical Equipment & Systems

Foot Switches are suitable for hostile environments.

PX and PA series foot-switches are available in single or double switch models as well as in covered and uncovered models. Protective covers on PX models are available in yellow, red, or orange; come with full or half covers; and are constructed of high impact plastic. Available with slow- or snap-action contact elements, foot switches offer various contact block configurations. Both series carry...

Read More »
Voltage Regulator has round-tank functionality.
Controls & Controllers

Voltage Regulator has round-tank functionality.

Pad-mounted, Single-phase, 32-step, voltage regulator allows system planners to regulate voltage on new and existing underground systems. Unit is available for system voltages from 2400 V, 3-wire to 24940 V, 4-wire. With current ratings from 50 to 548 A, regulator incorporates either 200 or 600 A deadfront termination system. Features include CL-5 control, automatic pressure-relief device, and 3...

Read More »
Threadlocker/Sealant replaces lockwashers.
Adhesives & Sealants

Threadlocker/Sealant replaces lockwashers.

PERMABOND-® HH120 seals fasteners against water and chemicals. It obtains fixture strength in 15-20 min on active metals such as iron, steel, nickel, and aluminum. Viscosity is 7000 cp, allowing for gap filling up to 10 mil. HH120 features locking strength of 250-350 lb-in. and retaining strength of over 2000 psi. It is suitable for locking bolts, nuts, and screws for permanent assembly, and is...

Read More »
Gaskets are highly conductive and provide EMI shielding.
Mechanical Components and Assemblies

Gaskets are highly conductive and provide EMI shielding.

Soft GORE-SHIELD-® GS8000 EMI gaskets consist of nickel-plated base polymer, backed with thin foil layer and electrically conductive, pressure-sensitive adhesive. Less than 3.4 N/cm of pressure compresses gaskets from nominal starting thickness of 1 mm to thickness of 0.4 mm. At this point, DC resistance is less than 10 mOhm for a 19 mm-² donut, and shielding effectiveness is greater than 90...

Read More »
Chain Conveyors have modular design.
Material Handling & Storage

Chain Conveyors have modular design.

Flat-top and table-top chain conveyors are based on aluminum-profile frames with full length t-slots for assembly components, such as side-frames, drive units, supports, and guide rails. Flat-top chain choices including steel and thermoplastic are available in standard widths of 3-¼, 4, 4-½, 6, 7-½, 10 and 12 in. Conveyor chain choices include all plastic, all steel, and roller chain, with...

Read More »
Gear Motors offer maximum continuous torque to 100 lb-in.

Gear Motors offer maximum continuous torque to 100 lb-in.

Model M1600 GIL100 PM DC parallel-shaft gear motors are available in 12 to 115 V models. All are UL-approved and feature high-energy ceramic magnets, reversible designs, double-shielded ball bearings on motor, and needle bearings on gearbox. They also include Class F insulation, dynamically balanced armature, TENV design, and auto-hook tang-type commutator. Brushes are externally replaceable.

Read More »
MIL-STD-1553 Terminal is offered in various configurations.
Controls & Controllers

MIL-STD-1553 Terminal is offered in various configurations.

Mini-ACE Mark3, 3.3 V, fully integrated, MIL-STD-1553 BC/RT/MT terminal uses 0.77 in.-² board space and measures 0.13 in. high. It is offered with RT-only or BC/RT/MT functionality, 4K x 16 or 64K x 17-memory compliment, and either PCI or generic processor backend interface. Mini-ACE Mark3 works with 8, 16, or 32-bit processors with little or no glue logic while PCI Mini-ACE Mark3 series...

Read More »
Software provides energy reporting and analysis.
Software

Software provides energy reporting and analysis.

EnergyDirector(TM) web-based software monitors and measures energy usage of any electronic point or metered service, including gas, electric, water, and steam. It shows real-time current energy usage and allows user to generate reports and analyze current and historical data. Software provides cost comparison against on-site generation; energy cost allocation; remote control of lights, heat,...

Read More »
Cleaner removes contaminants from electronic equipment.
Cleaning Products & Equipment

Cleaner removes contaminants from electronic equipment.

NT(TM) Precision Cleaner is a moderately aggressive COzol(TM) technology alternative to HCFC 141b-based cleaners. It evaporates quickly, leaves no residue, is non-flammable, and is NSF registered for use in meat and poultry plants. Formula also complies with EPA regulations on use of CFCs and HCFCs. It contains no Class I or Class II Ozone Depleting Chemicals. All 16 oz aerosol products feature...

Read More »

All Topics