Other

Services, Waste Handling Equipment, Green & Clean

Insight and Solutions to the Challenges of Site Remediation

October 8, 2015

Introduction Site remediation of locations contaminated with potentially toxic materials is a critical process that has to take into account a number of variables, often under a short time frame. When developing a site remediation plan for a brownfield location, companies have to keep all of these variables in mind so that clean-up can occur in the most effective and efficient way possible.... Read More

Fluid & Gas Flow Equipment, HVAC, Waste Handling Equipment

Pollution Control Unit meets UL-1978 standard.

September 18, 2015

Using 3-stage mechanical filter arrangement, Grease-Trapper PCU removes grease, smoke, and odors from kitchen exhaust air. Activated carbon panels remove odor molecules prior to discharging air, reducing impact of exhaust to surrounding areas. Built in accordance with NFPA 96, Grease Trapper offers capacities up to 12,000 cfm and uses MERV filters to ensure minimum overall particulate removal efficiency of 95%. Independent pressure switches signal when any filter stage needs replacing. Read More

Health, Medical and Dental Supplies & Equipment, Waste Handling Equipment

TSO3 to Enhance Canadian STERIZONE® Sterilizer - An Advanced Single Cycle to be Offered to Canadian Hospitals

September 9, 2015

Ticker:  TSX - TOS Shares Outstanding: 83,025,289 QUÉBEC CITY – TSO(3) Inc. (TSX: TOS) ("TSO(3)" or the "Company") an innovator in sterilization technology for medical devices in healthcare settings, today announced that the Company has submitted required documentation to Health Canada in support of commercializing the STERIZONE® VP4 Sterilizer in Canada. Currently, a three-cycle... Read More

Services, Waste Handling Equipment

Environmental Services Company Expands Capabilities with New Authorization to Transport Ebola Suspected or Confirmed Medical Waste

August 7, 2015

SWS Environmental Services recently acquired a new operating permit from the United States Department of Transportation. Panama City Beach, FL — SWS Environmental Services (SWSES) has been granted "Party Status" by the United States Department of Transportation (USDOT), Pipeline and Hazardous Materials Safety Administration (PHMSA) – Office of Hazardous Materials Safety for USDOT Special... Read More

Controls & Controllers, Waste Handling Equipment

See Water, Inc. Enhances Complete line of Sewage and Wastewater Control Panels

March 2, 2015

See Water, Inc., an industry leading manufacturer of pump control and liquid alarm systems for the water and wastewater industry, is now offering the new and improved WS Series® simplex and duplex control panels. The newly upgraded single phase and three phase control panels now provide enhanced pump protection in a more compact design. Ideal for grinder pump, sewage pump chamber, sump pump... Read More

Health, Medical and Dental Supplies & Equipment, Waste Handling Equipment

Instrument Trays Made of Solvay's Radel® PPSU Show Strong Compatibility with TSO3's Low-Temperature Sterilization System

February 16, 2015

ANAHEIM, CA and QUEBEC  — Solvay, a leading global supplier of high-performance thermoplastics, and TSO(3) Inc., a leading developer of low-temperature sterilization systems for the healthcare industry, jointly announced today that, as part of the U.S. FDA's 510(k) premarket clearance for TSO(3)'s new STERIZONE® VP4 Sterilization System received in December 2014, light weight... Read More

Waste Handling Equipment

MagneGas Deploys Manure Sterilization System to Major Hog Farm

December 17, 2014

System will be used to Demonstrate Manure Processing Capabilities and Launch Market TAMPA, Fla. – MagneGas Corporation ("MagneGas" or the "Company") (NASDAQ: MNGA), a technology company that counts among its inventions a patented process that converts liquid waste into a hydrogen-based fuel, announced today that it has completed construction of its latest Venturi™ sterilization system... Read More

Health, Medical and Dental Supplies & Equipment, Material Handling & Storage, Waste Handling Equipment

China's Medshine Uses Solvay's Radel® PPSU and AvaSpire® PAEK in Locally-Produced Medical Sterilization Case

October 16, 2014

High-Performance Thermoplastics Provides Strength, Transparency, Chemical Resistance, and Exceptional Sterilizability BOLLATE, Italy – Medshine Medical Devices Co., Ltd., a leading Chinese medical device manufacturer based in Qingdao, has introduced one of the first locally-produced surgical sterilization cases made of high-performance thermoplastics from Solvay Specialty Polymers. The... Read More

Services, Waste Handling Equipment

Goodhart Sons Inc. Awarded Multiple 2014 Fabrication Projects

July 31, 2014

Goodhart Sons, Inc., a 79-year-old ASME code shop, industrial fabricator and installation company serving both domestic and international clientele, has recently secured multi-million dollar fabrication contracts within the power, energy, pollution control and OEM sectors.  The main factor cited by the Project Managers and Engineers for selecting Goodhart Sons Inc. was the combination of cost,... Read More

Machinery & Machining Tools, Waste Handling Equipment

Sterilization System extends life of machine tool coolant.

July 11, 2014

Combining UV light with customizable filter, ASF 100 Industrial Aqueous Sterilization System controls spread of bacteria, mold, and fungi while removing unwanted particles from aqueous industrial fluids. Chemical-free system can be integrated into most machine tools that use aqueous liquids at temperatures up to 125°F with tank volumes up to 120 gal. Built-in electronics designed for industrial environments offer variety of operation modes and provide visual alerts when maintenance is required. Read More

Machinery & Machining Tools, Materials & Material Processing, Waste Handling Equipment

Evaporative Cooling Retorts suit raw product processing.

March 28, 2014

Providing automated monitoring and control, as well as extensive recipe flexibility, Evaporative Cooling Retorts offer solution for processing 3,200 lb batches or 50–800 gallon kettles of raw products. Since evaporative cooling consists of deaeration or removal of air from product, it not only cools, but also improves product quality and extends shelf life by slowing bacterial growth. Typical applications include potatoes, soups, sauces, fruits, chick peas, vegetables, and some meat products. Read More

Fluid & Gas Flow Equipment, HVAC, Transportation Industry Products, Waste Handling Equipment

Retrofit System cuts emissions in existing diesel engines.

March 24, 2014

Combining CRT® diesel particulate filter and SCR technology, SCRT® Selective Continuously Regenerating Technology cuts NOx, PM, CO, and HC emissions from stationary diesel engines for Tier 4 compliance. Engine exhaust first flows through CRT to reduce PM, CO, and HC. Controlled amount of urea is then injected into exhaust before it enters SCR catalyst modules. Urea is converted to ammonia and provides chemical agent to reduce NOx across SCR catalyst. Read More

Waste Handling Equipment

Sterilization Tunnels meet customer-specific requirements.

March 14, 2014

Featuring modular design to ensure customer-specific arrangement, HQL Series 6000, 7000, and 8000 are suitable for sterilizing and depyrogenizing pre-cleaned ampoules, injection and infusion bottles, as well as cartridges and syringes. Systems are available in standardized bandwidths of 600, 800, and 1,200 mm, respectively. Optimized airflow and measures for heat recovery help minimize energy required for electrical heating and ventilation, while flexible pressure zone ensures process safety. Read More

Fluid & Gas Flow Equipment, Materials & Material Processing, Waste Handling Equipment

Siemens and Texas A&M AgriLife Research to Develop Cost-Effective Technology to Remove Heavy Metals from Water and Wastewater

February 6, 2014

• Technology removes  selenium, mercury and other heavy metals and metalloids from power utility, mining, refinery and other industrial water and wastewater  to meet National Pollutant Discharge Elimination System (NPDES) limits • Continued research will develop and commercialize technology to reduce footprint and increase operations efficiency over a wide range of temperatures and... Read More

Material Handling & Storage, Mechanical Components & Assemblies, Waste Handling Equipment

Trash Handling Grapples feature heavy-duty cylinder shrouds.

January 22, 2014

Available for 13–25 ton excavators/material handlers, Builtrite™ Trash Handling/Sorting Grapples can handle bulky items as well as pick and place single items. Systems utilize 20 in. rotation bearing and high-torque hydraulic motor for precise placement. Arms are constructed of high-strength steel with abrasion-resistant, bolt-on wear bars on edges. Hanging style is suited for material handlers, while wristing style uses excavator bucket linkage to articulate grapple. Read More

Cleaning Products & Equipment, HVAC, Waste Handling Equipment

Housekeeping and Recovery of Combustible/Conductive Dusts: A Big Step in the Right Direction

January 20, 2014

Until today the certification of Hazloc Portable Vacuum Cleaners and Dust Collectors as per the Ex OSHA/NRTL system, the IECEx Scheme and the European ATEX system covers only the possibility to use the equipment in hazardous locations/areas in presence of combustible/conductive dusts, but does not cover the possibility to use the equipment to recover these dusts. Today we are proud to inform... Read More

Laboratory and Research Supplies & Equipment, Materials & Material Processing, Waste Handling Equipment

Gentle Motion Retorts Installed for the First Time in a Food Processing Plant in Europe - Improvements to Food Quality and Plant Capacity Anticipated

November 25, 2013

These Allpax Gentle Motion reciprocating retorts in Europe are being used to improve the quality of shelf-stable soup products packed in flexible containers. COVINGTON, La. – Allpax Products, powered by Pro Mach, said today that for the first time Gentle Motion reciprocating retorts have been installed in a food plant in Europe. The retorts are being used on shelf-stable soup products... Read More

Electrical Equipment & Systems, Health, Medical and Dental Supplies & Equipment, Waste Handling Equipment

Sanuvox Releases the Aseptix Dual UV Sterilization System to Help Reduce Nosocomial (HAI) Infections in Hospital Environments

November 20, 2013

Montreal, Canada – The Sanuvox Aseptix Dual UV Sterilization System uses a primary and secondary unit to sterilize high-touch surfaces with ultraviolet 'C' energy controlling (6 log reduction) drug-resistant microorganisms such as MRSA and C. diff. in as little as 7 minutes in a standard patient hospital room. The two unit operation dramatically lowers the sterilization time typically... Read More

Electrical Equipment & Systems, Machinery & Machining Tools, Waste Handling Equipment

Sterilizing System utilizes electron beam.

November 14, 2013

Suitable for sterilizing sensitive materials and complex products, SmartDose™ provides controls for simultaneous variable dose distribution, simultaneous dual beam redundancy, uninterrupted temperature controls, and intelligent tooling. Applications include allograft tissue, biomaterials, advanced polymers, drugs/biologics, and hydrogels as well as Teflon, implantables, bioabsorbables, bioresorbables, and combination devices. Read More

Waste Handling Equipment

Infrared Loop Sterilizer operates without warm-up.

November 4, 2013

Using specifically focused infrared light which generates IR hotspot, SteriMax Smart sterilizes inoculating loops at temperature of 650–1,100°C in 5–10 sec, without preheating or gas flame. Unit features adjustable sterilization and cool-down timers for 2 users, and annealing tube made of quartz glass or optional wear-resistant ceramics. Supplied in Cool-Touch housing made of stainless steel and safety glass, SteriMax Smart is suited for laboratories, anaerobic environments, and safety cabinets. Read More