AutomationDirect.com    Cumming, GA 30040-9905
Apr 19, 2012 Available in standard 1/16 DIN size, CTT series accepts voltage and non-voltage inputs from NPN, PNP, or dry contact sensors and can operate as digital counter, timer, combination timer/counter, or tachometer. Counting speeds are selectable to 10,000 cycles/sec, and double-line, 6-digit, 2-color LCDs present values and facilitate setup. While Output 1 is SPST relay and NPN transistor that operate concurrently, Output 2 is available as SPDT relay or NPN transistor.

Lion Precision Inc.    St. Paul, MN 55126 7014
Apr 17, 2012 Model ECL150 Eddy-Current Displacement Sensor features up to 8 channels of noncontact displacement sensing in package measuring only 4.2 x 7.6 x 2.3 in. Measurement ranges from 0.5-15 mm with resolutions as low as 2.6 nm at 15 kHz bandwidth. Operating from 12-24 Vdc, 0.75 W/channel, device allows for easy customization for OEM applications. Linearity is ±0.2% of range.

Agilent Technologies, Inc.    Santa Clara, CA 95051
Apr 16, 2012 Equipped with 10.4 in. display, Model E4982A is suitable for manufacture of passive components such as SMD inductors and EMI filters, where impedance testing at frequencies of 1 MHz to 3 GHz is required. Unit offers 0.8% basic impedance measurement accuracy and delivers measurement speeds of 0.9, 2.1, and 3.7 msec. Featuring compact design with 277 mm depth, meter provides PC connectivity via GPIB, LAN, and USB.

Electronic Development Laboratories, Inc.    Danville, VA 24540
Apr 16, 2012 Providing instantaneous readings in 5° increments, KIT-EZK-CR E-Z Probe Pyrometer Kit includes LCD with backlight, input jacks on top and bottom, belt clip and sensor holder for access and storage, and ability to switch between °F and °C. Also included is Reinforced Fine Hypodermic Sharp Needle sensor specifically for tire and rubber industry, and both low battery and open sensor indicators.

McPherson, Inc.    Chelmsford, MA 01824
Apr 12, 2012 With extended lamp life at short UV wavelengths, VUVAS scientific-grade spectrophotometer is suited to analysis of doped and crystalline materials as well as deep UV optics and coatings. Unit offers direct optical characterization of transmission, variable angle reflectance, and gas cell absorbance (optional). Wavelength control is precise and reproducible throughout 120-350 nm range, and sensitive signal recovery is available with lock-in detectors controlled from software.

Sierra Instruments, Inc.    Monterey, CA 93940
Apr 12, 2012 Equipped with Frictionless-Hovering Valve Technology(TM) featuring shut-off capability, SmartTrak® 100 provides stable gas mass flow control. High pressure meter utilizes inherently linear Laminar Flow Element and advanced platinum sensor technology. User can independently adjust calibration in field for any of 10 pre-programmed Dial-A-Gas® gases. With Pilot Module control/readout interface, user can view and adjust critical control functions at any time.

Fluid Components International    San Marcos, CA 92069
Apr 11, 2012 Thermal Mass Air/Gas Flow Meter, ST100 Series, suits equipment-crowded plants or hazardous factory areas where combustible or toxic gases may be present. Using interconnecting cable, transmitter with optional digital display can be mounted up to 1,000 ft away from flow sensor. Product continuously measures, displays, and transmits array of parameters and is available with 4-20 mA analog, frequency/pulse, alarm relays, or digital bus communications: HART, Fieldbus, Profibus or Modbus.

Paul N. Gardner Co., Inc.    Pompano Beach, FL 33060 6608
Apr 04, 2012 Suited for surface preparation as required by ISO 8502-4, PosiTector DPM III measures and records relative humidity, air temperature, surface temperature, and dew point temperature. Unit comes in Standard or Advanced models with either built-in or separate probe. All include internal memory, auto logging, and USB port. Intended for indoor/outdoor use, weatherproof meter has audio and visual alarm that indicates when climate conditions are unsuitable for painting.

Dwyer Instruments, Inc.    Michigan City, IN 46361
Apr 04, 2012 Supplied pre-calibrated for horizontal, inline mounting, Series DTFW is available with brass or 316 stainless steel body to withstand system pressures up to 3,000 psig. Ranges are offered up to 30 gpm, and products measure water flow rates with ±2% FS accuracy. Available with ¼, ½, and 1 in. connections, series features 2.5 in. dia dial face. Other elements of construction include 302 SS spring and range spring, PTFE-coated magnet, acetal or PTFE metering cone, and Buna seals.

CAS Data Loggers    Chesterland, OH 44026
Apr 04, 2012 With Electrocorder EC-7VAR Kit, users can view onsite power consumption in kilowatt hours, as well as identify voltage supply faults and power spikes. Three-phase meter is available in 4 models recording at amp ranges from 4 A to 3 kA. Using constant data sampling technique, logger samples each cycle multiple times for up to 300 days of continuous recording. All models include logger, 4 voltage leads, 3 Rogowski Coils, USB lead, software, and carrying case.

Keithley Instruments, Inc.    Cleveland, OH 44139 1891
Apr 03, 2012 Optimized for testing diodes, FETs, and IGBTs, Model 2657A High Power System SourceMeter® Instrument can source and sink up to 180 W of DC power at up to 3,000 V. Unit's 6½-digt measurement engine enables 1 fA current measurement resolution to support low-leakage requirements of power semiconductor devices. Model 2657A provides choice of digitizing or integrating measurement modes for characterizing both transient and steady-state behavior, including rapidly changing thermal effects.

Raytek Corporation    Santa Cruz, CA 95061 1820
Apr 03, 2012 Housed in stainless steel enclosure with integral water cooling, IP65-rated Modline® 7 Series delivers continuous temperature monitoring and control. Sensing head can operate at stand-alone sensor, providing simultaneous analog and digital outputs of process temperatures. Motorized focus control and both through-the-lens and laser sighting are standard. Supplied with ModView Pro software, thermometers use high-speed DSPs with RS-485 serial data communication that supports up to 32 sensors.

HW group s.r.o    Prague 2   Czech Republic
Mar 28, 2012 Equipped with internal rechargeable back-up battery that keeps device operating for 4-12 hours during power outage, HWg-Ares12 monitors temperature, humidity, door contacts, and other sensors over GSM/GPRS cellular network. In addition to SMS and e-mail communications, thermometer features HWg-Push protocol to deliver data to standard SCADA or SNMP monitoring system. With HWg-PDMS software, users can display charts of measured values and export data to MS Excel.

Fluke Networks    Camarillo, CA 93010
Mar 23, 2012 Providing smartphone-like user interface, OptiFiber(TM) Pro OTDR includes Datacenter Mode, which automates parameter setting, such as wavelength or end-detection algorithms, to troubleshoot datacenter problems. Project management tools facilitate assignment and tracking of fiber testing projects for multiple users, while LinkWare(TM) software aids workflow management and integrates test results. With test connectors and patch cords as short as 0.5 m, OTDR provides short event and attenuation dead zones.

TTP LabTech Ltd    Melbourn SG8 6EE  United Kingdom
Mar 22, 2012 Enabling characterization of enzyme activity to be achieved within 2-10 min/sample, chipCAL is suitable for monitoring biopharma, food, and fermentation processes. Technology employs flow principle, whereby enzyme and substrate are passed through thermodynamic cell simultaneously, allowing chipCAL to detect thermodynamic changes using volumes as low as 15 µL. Providing non-contact, label-free sample monitoring, calorimeter has working temperature of 15-60°C and can analyze up to 60 samples/8 hr.

Block Engineering, Inc.    Marlborough, MA 01752
Mar 20, 2012 Based on tunable Quantum Cascade Laser spectral engine, LaserBench(TM) Spectrometer features purgeable sample compartment designed to accommodate center-focus FTIR accessories. Internal optics are sealed and desiccated, with windows mounted within sampling area. Controlled from Windows user interface on standard PC via USB communications interface, spectrometer includes status lights for laser and instrument as well as remote start/scan button.

Universal Flow Monitors, Inc.    Hazel Park, MI 48030
Mar 15, 2012 Used to measure and monitor water flow, Coolpoint(TM) meters have no moving parts. Intrinsic safety feature is available on ¼, 3/8, ½, 1, 1½, and 2 in. meters, featuring 2-wire, 4-20 mA transmitter that has approved barriers and no display, alarm, or pulse output. It conforms to requirements for NEC Class I, Division 1, Group D environments. Available in pipe sizes from ¼-4 in., standard flow rate transmitter is 4-20 mA, 3-wire unit with brass body, viton seals, and PVDF sensors.

Columbia Weather Systems, Inc.    Hillsboro, OR 97124
Mar 14, 2012 With 2 ISO second-class compliant solar radiation sensors as options, Weather MicroServer can provide efficiency monitoring for solar panel arrays. Kipp and Zonen and Hukseflux thermopile-based sensors can be mounted horizontally for global radiation measurement or at plane of array for PV solar applications. Used in conjunction with weather stations, Weather MicroServer offers Internet and Industrial protocols for applications including XML, FTP, Modbus/OPC, and SNMP.

MadgeTech    Warner, NH 03278
Mar 14, 2012 Providing volumetric water content measurements, Model SMR101A is suited for irrigation management, greenhouse monitoring, and soil moisture trend studies. Logger features 4 Hz reading rate, multiple start/stop function, and 1,000,000 reading storage capacity. Using MadgeTech Software, data can be displayed in graphical, tabular, and summary views and may also be exported to MS Excel® for additional analysis. System comes equipped with EC-5 soil moisture probe providing response time of 10 ms.

Spectro Analytical Instruments Inc.    Marlborough, MA 01752
Mar 13, 2012 Incorporating transport trolley and 15 in. display, SPECTROTEST Metal Analyzers utilize pluggable UV probe for both spark and arc excitation. Units can identify low-alloy steels using carbon content in rapid arc excitation mode. In spark excitation mode, devices can analyze carbon, phosphorous, and sulfur. Incorporated plasma generator makes it possible to do hundreds of measurements with single battery charge, and ICAL logic system monitors correct state of measuring system.